Combined sections in Engineering Sample Clauses

Combined sections in Engineering. Technologies and The Trades The following shall be the method to determine the compensation for combined sections in CNC Machinist Technology, Machinist Technology, Carpentry and Masonry, Welding, and Airframe and Powerplant courses. Such shall also be the method used for any future courses in the Engineering Technologies and The Trades Department by mutual agreement. Those sections taught simultaneously during the same session by a single bargaining unit member and which require 120 academic hours of instruction and which have a combined enrollment of 24 or fewer students on the census date shall be credited a total of 8 contact hours toward load or overload for the combined sections. If the combined enrollment of such sections exceeds 24 students, the bargaining unit member will receive additional compensation according to the following table. The number of preparations may not exceed three at any time except for overload unless the parties mutually agree to allow more than three following procedures used to implement Section 5.11 of the collective bargaining agreement.
Sample 1
AutoNDA by SimpleDocs

Related to Combined sections in Engineering

  • and Section 7 4. If, by reason of any exercise of Warrants on a “cashless basis”, the holder of any Warrant would be entitled, upon the exercise of such Warrant, to receive a fractional interest in a share of Common Stock, the Company shall round down to the nearest whole number, the number of shares of Common Stock to be issued to such holder.

  • and Section 3 11. Subject to the foregoing, the Manager may cause the Company to issue additional Common Units authorized under this Agreement at such times and upon such terms as the Manager shall determine and the Manager shall amend this Agreement as necessary in connection with the issuance of additional Common Units and admission of additional Members under this Section 3.04 without the requirement of any consent or acknowledgement of any other Member.

  • Headings and Sections The headings in this Agreement are inserted for convenience only and are in no way intended to describe, interpret, define, or limit the scope, extent or intent of this Agreement or any provision hereof. Unless the context requires otherwise, all references in this Agreement to Sections or Articles shall be deemed to mean and refer to Sections or Articles of this Agreement.

  • Captions and Section Numbers The captions, section numbers, and article numbers appearing in this Lease are inserted only as a matter of convenience and in no way define, limit, construe, or describe the scope or intent of such sections or articles of this Lease nor in any way affect this Lease.

  • and Section 2 8. The determination by the applicable Lender of the amount of any such loss, cost or expense shall be conclusive absent manifest error.

  • Headings and Section References The section and subsection headings contained in this Agreement are for reference purposes only and shall not affect in any way the meaning or interpretation of this Agreement. Section references are to this Agreement unless otherwise specified.

  • RELATED SECTIONS Not Used

  • Captions; Articles and Sections The captions contained in this Agreement are for reference purposes only and are not part of this Agreement. Unless otherwise indicated, all references to particular Articles or Sections shall mean and refer to the referenced Articles and Sections of this Agreement.

  • Captions and Section Headings Captions and section headings used herein are for convenience only, and are not part of this Agreement and shall not be used in construing it.

  • Table of Contents and Section Headings The table of contents and the Section and subsection headings herein are intended for convenience only and shall be ignored in construing this Agreement.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!