Corrosion Protection. A-E may be required to perform corrosion protection evaluations, studies, and investigations; Cathodic Protection (CP) system and protective coatings design; field inspection of CP system construction and/or repair; and shop and field inspection of corrosion resistant coating applications including inspection of structural and spot welds. A-E may also be expected to perform review of contractor submittals, shop drawings, substitutions, and proposed field changes.
Corrosion Protection. PSL 3.9.2
Corrosion Protection. Corrosion protection shall be provided for buried pipelines as specified in Division 500 of the Water System Standards as applicable to the project. Steel reservoirs and submerged metallic structures in concrete reservoirs shall have corrosion protection, such as adequate coatings, etc. The corrosion protection design shall be approved by the Manager.
Corrosion Protection. In locations below an elevation of 4 feet, or where water or especially corrosive soils, including those contaminated with petroleum products, are encountered or where other unfavorable conditions may subject the pipe to serious corrosion, the Manager may specify the type of pipe to be used. Under such circumstances, corrosion protection for the pipe, fittings, and appurtenances may be required by the Manager. The materials and methods to be used for corrosion protection shall be specified on the plans or by special provisions or as directed by the Manager. To ascertain whether unfavorable soil conditions exist, the Manager may request that soil boring samples at approximately the invert of the pipe be taken, analyzed, and submitted as part of the project.
Corrosion Protection. All exposed carbon steel or iron surfaces shall be primed and painted per the manufacturer’s standard practice for outside service to preclude rust and corrosion. Paint having an asphaltum base or lead shall not be used.
Corrosion Protection. Hawkeye Gold Denatured Fuel Ethanol will contain a corrosion inhibitor designed for use in ethanol fuels.
Corrosion Protection. See Division 500 for additional corrosion control requirements as applicable to the project. 203.02 PRETENSIONED CONCRETE CYLINDER PIPE. (Bar Wrapped Concrete Pressure Pipe)
Corrosion Protection. See Division 500 for corrosion control requirements as applicable to the project.
A. General. PVC C-900 and C-905 pipe shall be cast-iron-pipe-equivalent O.D. type as called for in the Bid, Plans and Specifications.
B. AWWA C900 PVC PIPE. PVC C900 pipe shall be in compliance with Table 200-5 and AWWA C900, "AWWA Standard For Polyvinyl Chloride (PVC) Pressure Pipe, 4-inch Through 12-inch For Water Distribution". C. AWWA C905 PVC Pipe. PVC C905 pipe shall be in compliance with Table 200-6 and AWWA C905, "AWWA Standard for Polyvinyl Chloride (PVC) Transmission Pipe, Nominal Diameters 14-inches Through 36-inches". D. Fittings.
Corrosion Protection. See Division 500 for required coating types and other corrosion control requirements as applicable to the project.
Corrosion Protection. Refer to Particular Specification G02: Corrosion Protection.
