Installation and Maintenance Except for the bi‐directional and production metering equipment owned by the City, all equipment on Customer’s side of the delivery point, including the required disconnect device, shall be provided and maintained in satisfactory operating condition by Customer and shall remain the property and responsibility of the Customer. The City will bear no responsibility for the installation or maintenance of Customer’s equipment or for any damage to property as a result of any failure or malfunction thereof. The City shall not be liable, directly or indirectly for permitting or continuing to allow the interconnection of the Facility or for the acts or omissions of Customer or the failure or malfunction of any equipment of Customer that causes loss or injury, including death, to any party.
Repairs and Maintenance The Tenant shall (a) take good care of the Apartment and all equipment and fixtures in it; (b) promptly make all necessary repairs and replacements whenever the need results from the Tenant's act of neglect or the neglect of Tenant’s family members, guests, visitors or contractors (if consented to by Landlord); (c) keep the Apartment and any other part of the building used by the Tenant as clean and safe as possible; and (d) promptly notify the Landlord when there are conditions which need repair. Landlord shall have a reasonable amount of time to make repairs. Tenant shall be responsible for reimbursing the Landlord for the cost of any repairs that are not "normal wear and tear" repairs, any such costs shall be considered additional rent; (e) shall not attach to, hang from or place anything on the railings of the patio or deck; and ( f ) Tenant agrees not to install any partition walls. No outside contractor is authorized to perform any services at the Apartment or apartment complex unless approved in writing by a representative of the Landlord. If Tenant contracts for any such services without written consent of the Landlord, Tenant shall be wholly responsible for the payment for any such service and shall hold the Landlord harmless against any claim made by a contractor who performs any such service at the request of the Tenant. Tenant shall also be responsible for returning the apartment back to its original condition, or else shall be liable to the Landlord for the costs incurred for the Landlord to do so after Tenant vacates.
Equipment Rental Copies of rental agreements for the equipment used, including the rental rate; and the number of hours the equipment was used on the project.
Repair and Maintenance Except in the case of damage to or destruction of the Leased Premises, the Building, the Outside Areas or the Property caused by an act of God or other peril, in which case the provisions of Article 10 shall control, the parties shall have the following obligations and responsibilities with respect to the repair and maintenance of the Leased Premises, the Building, the Outside Areas, and the Property.
Construction and Maintenance There are on-going maintenance, renovation and construction projects taking place in and around the residences. The work typically takes place during regular business hours, but may begin earlier or extend into evenings or weekends. On-going construction or renovation projects will continue through midterm and final exam periods. The University will take measures to ensure that prudent construction practices are followed, but there may be noise, dust and temporary interruption of some services. Residents may be required to temporarily or permanently relocate to facilitate construction or renovation to their residence area. There will be no compensation or reduction to your residence fees due to disruption and/or relocation.
Installation, Inspection, and Maintenance The Contractor is responsible for installation and maintenance of the BMPs as a part of its Bid. The Design Professional shall obtain the services of a qualified testing laboratory to inspect the BMPs in accordance with the permits, the costs of such inspections to be borne by the Owner. In the event of Abnormal Weather Conditions or force majeure, the Contractor shall be compensated for re-installation of BMPs at established Unit Prices.
Planned Maintenance (a) Sellers may designate up to twenty (20) Days of Planned Maintenance on Sellers’ Facilities during each Contract Year. Sellers shall be entitled to reduce (including down to zero (0)) its Gas scheduling under Clause 8 and Exhibit 3 for each Day of Planned Maintenance.
Supply and Maintenance of Equipment It is the responsibility of the Employer to furnish and maintain all equipment, machinery and supplies required by employees in the performance of their duties. Employees shall not suffer any loss in salary in the event that they cannot carry out their normal duties by reason of the Employer failing to properly maintain equipment, machinery or supplies or by reason of power failures or other circumstances not attributable to the employees.
Operation and Maintenance 17.1 O&M obligations of the Concessionaire