Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.
Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.
Training and Orientation (a) No employee shall be required to work on any job or operate any piece of equipment until he/she has received proper training and instruction. (b) The Employer shall provide sufficient and adequate training and/or orientation to any employee working in a new or unfamiliar work area or position.
Tests, Labs, and Imaging and X rays (diagnostic)
Working and Labor Synergies The Contractor shall be responsible for maintaining a tranquil working relationship between the Contractor work force, the Contractor Parties and their work force, State employees, and any other contractors present at the work site. The Contractor shall quickly resolve all labor disputes which result from the Contractor's or Contractor Parties’ presence at the work site, or other action under their control. Labor disputes shall not be deemed to be sufficient cause to allow the Contractor to make any claim for additional compensation for cost, expenses or any other loss or damage, nor shall those disputes be deemed to be sufficient reason to relieve the Contractor from any of its obligations under the Contract.
Training and Promotion a. The contractor will assist in locating, qualifying, and increasing the skills of minorities and women who are applicants for employment or current employees. Such efforts should be aimed at developing full journey level status employees in the type of trade or job classification involved. b. Consistent with the contractor's work force requirements and as permissible under Federal and State regulations, the contractor shall make full use of training programs, i.e., apprenticeship, and on-the-job training programs for the geographical area of contract performance. In the event a special provision for training is provided under this contract, this subparagraph will be superseded as indicated in the special provision. The contracting agency may reserve training positions for persons who receive welfare assistance in accordance with 23 U.S.C. 140(a). c. The contractor will advise employees and applicants for employment of available training programs and entrance requirements for each. d. The contractor will periodically review the training and promotion potential of employees who are minorities and women and will encourage eligible employees to apply for such training and promotion.
Protective Clothing and Equipment The Employer shall provide and pay for all protective devices, clothing and other equipment necessary to properly protect employees from injury and unhealthy conditions. The Employer shall make provisions for the proper cleaning and maintenance of all safety equipment, devices and clothing at no cost to the employees.
CLOTHING AND EQUIPMENT (a) Employees required by the Employer to wear uniforms will be supplied with an adequate number of uniforms appropriate to the occupation free of cost to Employees. Such items are to remain the property of the Employer and be laundered and maintained by such Employer free of cost to the Employee. (b) Instead of the provision of such uniforms, the Employer may, by agreement with the Employee, pay such Employee a uniform allowance at the rate set out in Item 1 of Table 5. This rate is expressed as per shift or part thereof, or as a weekly rate – an Employee is to be paid whichever is the lesser amount. (c) Where an Employee’s uniforms are not laundered by or at the expense of the Employer, the Employee will be paid a laundry allowance. For Aged Care, Health Professionals and Home Care Employees this will be paid at the rate set out in Item 2 of Table 5. This allowance is also expressed as a payment per shift of part thereof of as a weekly payment – an Employee is to be paid whichever is the lesser amount. For Nursing Employees this will be paid at the rate set out in Item 3 of Table 5. (d) The uniform allowance, but not the laundry allowance, will be paid during all absences on paid leave, except absences on long service leave and absence on personal/carer’s leave beyond 21 days. Where, prior to the taking of leave, an Employee was paid a uniform allowance other than at the weekly rate, the rate to be paid during absence on leave will be the average of the allowance paid during the four weeks immediately preceding the taking of leave. (e) Where an Employer requires an Employee to wear rubber gloves, special clothing or where safety equipment is required for the work performed by an Employee, the Employer must reimburse the Employee for the cost of purchasing such special clothing or safety equipment, except where such clothing or equipment is provided by the Employer.
Marketing and Promotion The School will be responsible for marketing and promoting the Sports Facilities in accordance with the agreed aims and targets. A marketing strategy will be prepared and implemented and reviewed on an annual basis.
Training and Support Licensor shall offer installation support to the Licensee and each of the Members, including assisting with the implementation of any Licensor software. Licensor will provide appropriate training to Licensee and Member staff relating to the use of the Licensed Materials and any Licensor software. Licensor will offer reasonable levels of continuing support to assist Licensee and Members in use of the Licensed Materials, including providing help files and other appropriate user documentation in connection with the use of and access to Licensed Materials. Licensor will, at a minimum, make its personnel available by email, telephone or via the Web, or in person during Licensor’s regular business hours, Monday through Friday, for training and user access support.
