General Construction Activities. Including, but not limited to, the enrollment sectors identified in 6.1 through 6.5 above, general construction activities that include, but are not limited to, construction of facility sites, infrastructure, roads, and implementation of best management practices, which involves the use of heavy equipment and trucking activities in clearing vegetation, contouring, compacting, stabilizing soils, constructing and maintaining roads and linear infrastructure, and installing erosion control (including silt fencing, earthen berms, etc.). The list of construction activities are described above is not intended to be exhaustive.
General Construction Activities. The contractor shall not be permitted to transport construction materials or equipment longitudinally over the pipeline. • Where it is necessary for construction equipment (i.e., tractors, backhoes, dump trucks, etc.) or equipment transporting construction materials to cross the pipeline, the crossing of the pipeline right-of-way shall be at, or as near to, a 90˚ angle as is feasible. • To gain access to the job site, the contractor shall submit a plan indicating where construction equipment will cross the pipeline, along with the depth of the pipe at the crossings, any proposed ramping over the pipeline, together with the following specifications for the equipment: type and weight of equipment; for track equipment – track width and length; for wheeled equipment – number of axles (single or tandem axles). BP will perform a stress factor calculation to determine if the equipment can safely cross the pipeline. If crossing of the pipeline is allowed, special measures may need to be taken to ensure the integrity of the pipeline. • No track type construction equipment shall be permitted to pivot or turn directly over the top of the pipeline. • A scraper or pan type tractor shall not be used for removal of soil within ten feet (10’) of the centerline of the pipeline. Rubber tire or small track type equipment is an acceptable alternative. • A sheepsfoot roller shall not be used for compaction purposes within five feet (5’) or directly above the centerline of the pipeline. • No vibratory rollers shall be used within three feet (3’) of the centerline of the pipeline until the compacted cover over the pipeline has reached a depth of three and one-half feet (3 ½’). EXHIBIT D EXHIBIT D
General Construction Activities. Construction solid waste, debris and refuse generated on-site should be collected, handled and disposed of properly to avoid entering any nearby stormwater drain. Stockpiles of cement and other construction materials should be kept covered when not being used. Oils and fuels should only be stored in designated areas which have pollution prevention facilities. To prevent spillage of fuels and solvents to any nearby stormwater drain, all fuel tanks and storage areas should be provided with locks and be sited on sealed areas, within bunds of a capacity equal to 110% of the storage capacity of the largest tank. The bund should be To minimize water quality impacts MTRC / Contractor All works areas During Construction EIA Recommendation drained of rainwater after a rain event. Objectives of the EIA Ref. EM&A Ref. Recommended Mitigation Measures Recommended Measure & Main Concerns to address Who to implement the measure? Location of the measure What When to requirements or implement the standards for measure? the measure to achieve? Water Quality Impact (Operation)
