General Requirements for the Utility Capacity Test Sample Clauses

General Requirements for the Utility Capacity Test. 3.2.1.1 Contractor will develop in coordination with Owner, detailed Performance Test Procedures thirty (30) days prior to the commencement of Acceptance Testing. 3.2.1.2 The Capacity Test will be two (2) hours in duration. Data will be collected during two (2) 60-minute intervals during the Capacity Test. 3.2.1.3 The Capacity Test will be conducted with all normally operated auxiliaries in service and with the Plant operated at a power factor between 0.95 leading to 0.95 lagging. 3.2.1.4 The Plant will be operated on natural gas. 3.2.1.5 Owner will provide notice to PECO at least ten (10) days before the Capacity Test. Utility personnel will be allowed to witness the Capacity Test. -------------------------------------------------------------------------------- EPC - Exhibit D TENASKA GEORGIA GENERATION PROJECT Page 19 of 20 -------------------------------------------------------------------------------- ACCEPTANCE TEST GUIDELINES, PROCEDURES AND SPECIFCATIONS Date 9/13/99 -------------------------------------------------------------------------------- 3.2.1.6 Contractor will provide qualified test engineers to direct the Utility Test, assist with data collection and perform calculations. 3.2.1.7 Reactive power data will be collected from the Utility (kWh) meter used for measuring net reactive power output to the transmission system. The change in meter readings over a set time period will be used to calculate a net capacity value. 3.2.1.8 The output of the gas turbine generators shall be corrected in accordance with the conditions specified herein. The corrections will then be applied to the Utility kWh meter readings. 3.2.1.9 Calculated contract capacity shall be rounded off to the nearest 100 kW. 3.2.1.10 No adjustments shall be made to the capacity calculations for tolerances due to measurement uncertainties. 3.2.1.11 Data shall be collected at ten minute intervals for each one (1) hour test run. 3.2.1.12 Computations for correcting capacity shall be performed immediately following each test run. 3.2.1.13 The preliminary corrected capacity results shall be available upon completion of the test run calculations. 3.2.1.14 The Plant Net Capacity shall be the average of the Net Plant Output corrected to Standard Conditions (Section 3.3) calculated for each test run. 3.2.1.15 A preliminary report summarizing the test results will be prepared and issued by the Contractor within 24 hours upon which the test is completed. Contractor shall issue Final Report w...
Sample 1Sample 2
AutoNDA by SimpleDocs

Related to General Requirements for the Utility Capacity Test

  • General Requirement Any notice, election, demand, request, consent, approval, or other communication required or permitted to be given under this Contract shall be in writing signed by an officer or duly authorized representative of the party making same and shall be delivered personally or shall be sent by certified or statutory mail, postage prepaid, return receipt requested, shall be effective as of the date on which it is received or would have been received but for the refusal of the addressee to accept delivery, and shall be addressed as shown in the Contract. The persons and addresses to which notices should be given may be changed by notice given in accordance with this Article.

  • Minimum Condition and Warranty Requirements for TIPS Sales All goods quoted or sold through a TIPS Sale shall be new unless clearly stated otherwise in writing. All new goods and services shall include the applicable manufacturers minimum standard warranty unless otherwise agreed to in the Supplemental Agreement.

  • Minimum Customer Support Requirements for TIPS Sales Vendor shall provide timely and commercially reasonable support for TIPS Sales or as agreed to in the applicable Supplemental Agreement.

  • CONTRACT COMPLIANCE REQUIREMENT The HUB requirement on this Contract is 0%. The student engagement requirement of this Contract is 0 hours. The Career Education requirement for this Contract is 0 hours. Failure to achieve these requirements may result in the application of some or all of the sanctions set forth in Administrative Policy 3.10, which is hereby incorporated by reference.

  • General Requirements The Contractor hereby agrees:

  • Compliance with Xxxxxxxx Act requirements The contractor shall comply with the requirements of 29 CFR part 3, which are incorporated by reference in this contract.

  • Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.

  • Additional Requirements for Sleeping Rooms The Contractor shall provide departing Attendees a secured area for storing belongings.

  • Listing and Maintenance Requirements Compliance The Company has not in the two years preceding the date hereof received written notice from any stock exchange, market or trading facility on which the Common Stock is or has been listed or quoted to the effect that the Company is not in compliance with the listing, maintenance or other requirements of such exchange, market, trading or quotation facility. The Company has no reason to believe that it does not now or will not in the future meet any such requirements.

  • Minimum Shipping Requirements for TIPS Sales Vendor shall ship, deliver, or provide ordered goods and services within a commercially reasonable time after acceptance of the order. If a delay in delivery is anticipated, Vendor shall notify the TIPS Member as to why delivery is delayed and provide an updated estimated time for completion. The TIPS Member may cancel the order if the delay is not commercially acceptable or not consistent with the Supplemental Agreement applicable to the order.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!