Grout. For each employee who is eligible for coverage under the Plan, for the first nine (9) months of eligibility, the Company agrees to pay fifty per cent (50%) of the respective employee’s premium rate for the group life insurance coverage; and after nine (9) months of eligibility, the Company agrees to pay one hundred per cent of the respective employee’s premium rate for the group life insurance coverage. The death benefit is equal to one hundred and fifty per cent (150%) of the employee’s annual earnings to a maximum of sixty thousand dollars ($60,000). For each employee who is eligible for coverage under the Plan, for the first nine (9) months of eligibility, the Company agrees to pay fifty per cent (50%) of the respective employee’s premium rate for the health insurance coverage; and after nine (9) months of eligibility, the Company agrees to pay eighty per cent (80%) of the respective employee’s premium rate for the health insurance e. Dispensing fees for prescriptions are capped at and any dispensing fees charged above this amount are payable by the employee. There is a family deductible per employee; and a single deductible per employee; per calendar year for health care costs.
Grout. .1 Supply and install load bearing grout between the top of foundation and tower base.
Grout. Provide materials that comply with the applicable requirements. Water DIVISION 2400 Portland Cement (Type I or II) DIVISION 2000 Fly Ash DIVISION 2000 Admixtures DIVISION 1400 Non-Expansive Cementitious Grout DIVISION 1700 Polyurethane DIVISION 1700 (this specification) Mix the water, portland cement (not less than 25% by volume of solids) and fly ash (75% by volume of solids) into a cement/fly ash grout complying with TABLE 1: TABLE 1: GROUT FOR MUDJACKING Property Test Method Value Fluidity (efflux time) ASTM C939 16 to 36 seconds 7-Day Compressive Strength ASTM C942 600 psi minimum Submit to the Engineer the results of tests conducted on the design mix by a certified testing laboratory. Provide test results for 1, 3, and 7 day strengths, fluidity, time of initial set (ASTM C 266), and shrinkage and expansion observed (ASTM C 940). Use admixtures only with written approval from the Engineer. The Engineer will accept the fly ash grout on the results of the compressive strength and visual inspection of the mixture placed on the project.
Grout. Connect an expanding rubber packer, or other approved device, to the end of the grout plant discharge hose. Place the expanding rubber packer in the injection hole, being careful not to extend the discharge end of the rubber packer below the lower surface of the PCCP. Produce grout slurry to a 12 second flow cone time. Pump the grout into the holes using an injection pump with a pressure capability of 250 to 300 psi when pumping grout slurry mixed to a 12 second flow cone time. Cease injection at a hole when grout flow does not occur after 7 seconds of sustained 150 psi gauge pressure, and there is no indication of slab movement. Prior to grout drying on the drilled holes, fill the holes with a fast setting sand/cement mixture or other patching material approved by the Engineer
Grout. A. Neat cement grout shall consist of Portland Cement and water. Mixture shall contain no more than 6 gallons of water per 94-lb bag of Portland Cement.
Grout. This page intentionally left blank. May 2017 C01025C17 Georgetown Wet Weather Treatment Station 03600 - 11 GROUT GROUT TESTING PROCEDURES
Grout. A. Unless otherwise specified, grout in Transportation Structures shall be a non-shrink grout on the Alberta Transportation Products List.
Grout. A. Grout and concrete patching materials shall be packaged in waterproof containers with the production date and shelf life of the material shown.
Grout. A. Nonmetallic, Shrinkage-Resistant Grout: Premixed, nonmetallic, noncorrosive, nonstaining grout containing selected silica sands, portland cement, shrinkage compensating agents, plasticizing and water-reducing agents, complying with ASTM C 1107, of consistency suitable for application, and a 30-minute working time.
Grout. 1 Thin set system grout: polymer modified epoxy grout by FLEXTILE .2 Colours: HARVEST 586
