Heating and Cooling Units Sample Clauses

Heating and Cooling Units. COVERED—Up to 2 heating and 2 cooling units OR 2 heat pump units; including blower fan motors; burners; controls; fan blades; heat/cool thermostats; boiler zone control valves; heat exchangers; heating elements; igniter and pilot assemblies; internal system controls; wiring and relays; motors and switches; air handler; capacitors; compressors; condenser fan motors; condenser coils; evaporator coils; evaporative cooler; fan blades; pumps; refrigerant piping; reversing valves; and refrigerant (up to $20 per pound) on all authorized sealed system repairs. If none of the systems listed above exists in the property, coverage may (at Our discretion and with approval granted prior to coverage start) be extended to baseboard, wall, in-floor, or other alternative systems provided they are not explicitly excluded in this section. NOT COVERED—Portable or window units; forced air damper systems; solar heating systems; pellet, corn cob or wood units; radiant cable heat; or fireplaces and associated components; chimneys; outside or underground piping; circulation components or redrilling of xxxxx for water source heat pumps; fuel storage tanks; expansion tanks; filters; timers; heat lamps; humidifiers or dehumidifiers; condensate drain pump; flues and vents; improperly sized or mismatched systems; cleaning and maintenance; free- standing or gas log systems, including gas supply lines; flue dampers; pressure regulators; computerized energy management systems; gas air conditioning systems; electronic air cleaners; water towers; roof jacks and stands; chillers; any system with asbestos; heat recovery units; interconnecting refrigerant lines; water pumps; water cooling towers; pre-coolers; insulation; concrete pads; costs related to leak test, or recapturing refrigerant; baseboard, casings, registers and radiators tied to boiler systems; use of cranes; costs associated with replacing non-failed parts to bring a system into compatibility (including conversion to R410a); and units located in detached garages. Smart thermostats will be replaced with regular thermostats or given cash equivalent.
Sample 1
AutoNDA by SimpleDocs
Heating and Cooling Units cooling units OR 2 heat pump units and associated parts and components; including blower fan motors; burners; controls; fan blades; heatlcool thermostats; zone control systems; heat exchangers; heating elements; igniter and pilot assemblies; internal system controls; wiring and relays; motors and switches; air handler; capacitors; compressors; condenser fan motors; condenser coils; evaporator coils; fan blades; pumps; refrigerant piping; reversing valves; and refrigerant on all authorized sealed system repairs. If none of the systems listed above exists in the property, coverage may (at Our discretion and with approval granted prior to coverage start) be window units; solar heating systems; pellet, corn cob or wood stoves; radiant underground piping; circulation components or redrilling of xxxxx for water improperly sized or mismatched systems; cleaning and maintenance; free-
Sample 1
Heating and Cooling Units. COVERED: Up to 2 heating and 2 cooling units OR 2 heat pump units and associated parts and components, including blower fan motors, burners, controls, fan blades, heat/cool thermostats, zone control systems, heat exchangers, heating elements, ignitor and pilot assemblies, internal system controls, wiring and relays, motors and switches, air handler, capacitors, compressors, condenser fan motors, condenser coils, evaporator coils, fan blades, pumps, refrigerant filter dryer, refrigerant piping, reversing valves. If none of the systems listed above exists in the property, coverage may (at the discretion of Home Warranty and with approval granted prior to coverage start) be extended to baseboard, wall, in-floor, or other alternative systems provided they are not explicitly excluded in this section. NOT COVERED: Portable or window units, solar heating systems, pellet or wood stoves, radiant cable heat, or fireplaces and associated components. Chimneys. Outside or underground piping. Circulation com- ponents or re-drilling of xxxxx for water source heat pumps. Fuel storage tanks. Expansion tanks. Filters. Timers. Heat lamps. Humidifiers or dehumidifiers. Condensate drain pump. Flues and vents. Improperly sized or mismatched systems. Cleaning and maintenance. Free-standing or gas log systems, including gas supply lines. Flue dampers. Pressure regulators. Computerized energy management systems. Gas air conditioning systems. Electronic air cleaners. Water towers. Roof jacks and stands. Chillers. Any system with asbestos. Heat recovery units. Interconnecting refrigerant lines. Water pumps. Water cooling towers. Pre-coolers. Insulation. Concrete pads. Costs related to adding or recapturing refrigerant. Baseboard, casings, registers and radiators tied to boiler systems.
Sample 1

Related to Heating and Cooling Units

  • Heating, Ventilating and Air Conditioning General Office Area: The building shall be equipped with a combination heating, ventilation and air conditioning system. The system shall have ducted supply and return air. The space above the ceiling shall not be used as a supply or return plenum. The systems shall be sized in accordance with the

  • Heating and Air Conditioning Xxxxxx agrees to furnish to Lessee heating and air conditioning equipment and maintain same in satisfactory operating condition at all times for the Premises during the term of the Lease at the expense of Lessor. Xxxxxx agrees that thermostats in the Premises will be set to maintain an average zone temperature of 75 degrees Fahrenheit during the heating and cooling seasons.

  • Heating, Ventilation and Air Conditioning Landlord shall furnish to the Premises heating, ventilation and air-conditioning (“HVAC”) in accordance with the Design Standards set forth in Exhibit D during Ordinary Business Hours. Landlord shall have access to all air-cooling, fan, ventilating and machine rooms and electrical closets and all other mechanical installations of Landlord (collectively, “Mechanical Installations”), and Tenant shall not construct partitions or other obstructions which may interfere with Landlord’s access thereto or the moving of Landlord’s equipment to and from the Mechanical Installations. No Tenant Party shall at any time enter the Mechanical Installations or tamper with, adjust, or otherwise affect such Mechanical Installations. Landlord shall not be responsible if the HVAC System fails to provide cooled or heated air, as the case may be, to the Premises in accordance with the Design Standards by reason of (i) any equipment installed by, for or on behalf of Tenant, which has an electrical load in excess of the average electrical load and human occupancy factors for the HVAC System as designed, or (ii) any rearrangement of partitioning or other Alterations made or performed by, for or on behalf of Tenant. Tenant shall install, if missing, blinds or shades on all windows, which blinds and shades shall be subject to Landlord’s approval, and shall keep operable windows in the Premises closed, and lower the blinds when necessary because of the sun’s position, whenever the HVAC System is in operation or as and when required by any Requirement. Tenant shall cooperate with Landlord and shall abide by the rules and regulations which Landlord may reasonably prescribe for the proper functioning and protection of the HVAC System. Tenant acknowledges that the server room in the Premises currently has three heat pumps installed, being two 4-ton units, and one 2.5-ton unit (the “Existing Heat Pumps”). The 2.5-ton unit is currently connected and operational. Tenant shall determine whether it is satisfied with the condition of the Existing Heat Pumps and Landlord shall not have any responsibility or liability for the condition, operation, maintenance, repair or replacement of the Existing Heat Pumps. Tenant may operate the Existing Heat Pumps. Tenant shall be responsible for, and pay directly for, all necessary maintenance and repairs to the Existing Heat Pumps. Tenant shall reimburse Landlord monthly for the cost of all utility services used to operate the Existing Heat Pumps within 10 Business Days after receipt of Landlord’s invoice for such amount. Landlord may measure Tenant’s usage of such utility services by either a sub-meter or by other reasonable methods such as by temporary check meters or by survey. Tenant, at its cost, may replace the Existing Heat Pumps with one or more new heat pumps, provided, however, that the capacity of such replacement heat pump(s) shall not exceed the 10.5-ton capacity cooling capacity of the Existing Heat Pumps.

  • Premises Parking and Common Areas 2.1 Letting Lessor hereby leases to Lessee, and Lessee hereby leases from Lessor, the Premises, for the term, at the rental, and upon all of the terms covenants and conditions set forth in this Lease. Unless otherwise provided herein, any statement of square footage set forth in this Lease, or that may have been used in calculating rental and/or Common Area Operating Expenses, is an approximation which Lessor and Lessee agree is reasonable and the rental and Lessee's Share (as defined in Paragraph 1.6(b)) based thereon is not subject to revision whether or not the actual square footage is more or less.

  • Moonlighting Employment as a physician in a professional capacity outside of what is outlined in this Agreement, whether temporary special medical activity (“TSMA”) or external moonlighting, must be approved in writing, in advance, by the Departmental Chair, Program Director and Director of Graduate Medical Education (or designee). Even if approved, professional and general liability insurance as outlined in Section 5.4 is not provided to Trainee engaged in external moonlighting. Trainee acknowledges he or she has the responsibility to obtain insurance for such engagement. TSMA and external moonlighting must be included and reported as part of Trainee's hours spent on clinical experience and education. Trainee shall not be required to engage in any outside work.

  • SHIPPING AND AIR TRANSPORT 1. Profits of an enterprise of a Contracting State from the operation of ships or aircraft in international traffic shall be taxable only in that State. 2. The provisions of paragraph 1 shall also apply to profits from the participation in a pool, a joint business or an international operating agency.

  • Generators Temporary installation of generators, and permanent installation of generators that are placed inside existing non-residential buildings or that occupy an area under 50 square feet behind the building they serve.

  • Installation, Maintenance, Testing and Repair Unless otherwise agreed in writing by the Parties, to the extent required by Applicable Law, Interconnection provided by a Party shall be equal in quality to that provided by such Party to itself, any subsidiary, affiliates or third party. If either Party is unable to fulfill its obligations under this Section 14.2, it shall notify the other Party of its inability to do so and will negotiate alternative intervals in good faith. The Parties agree that to the extent required by Applicable Law, the standards to be used by a Party for isolating and clearing any disconnections and/or other outages or troubles shall be at parity with standards used by such Party with respect to itself, any subsidiary, affiliate or third party.

  • Heating The Hirer shall ensure that no unauthorised heating appliances shall be used on the premises when open to the public without the consent of the management committee. Portable Liquefied Propane Gas (LPG) heating appliances shall not be used.

  • Generator Subject to the provisions of this Section 29.36, Tenant shall be entitled to install, operate and maintain a generator and any other equipment related thereto, including, without limitation, a fuel system, wiring and shaft space (“Generator”) next to the Building at Tenant’s sole cost and expense (without paying any additional fee or rental to Landlord for the use thereof). Prior to the installation of the Generator, Tenant shall inspect the proposed location to determine a suitable location for the Generator, and Tenant shall submit written plans and specifications relative to the type, size and proposed location (including any proposed screening) of the Generator to Landlord for its review and written approval. Tenant shall be solely responsible for the cost of acquisition, installation, operation, and maintenance of the Generator; and Tenant shall install, maintain and operate the Generator in accordance with all federal, state, and local laws, statutes, ordinances, rules and regulations, including without limitation, obtaining and maintaining any and all permits, approvals and licenses required to install and operate the Generator by any governmental authority having jurisdiction. Landlord and Tenant agree that, upon the expiration of earlier termination of the Lease Term, Tenant shall not be required to remove the Generator, any associated cabling, wiring and screening or other improvements. Tenant shall not be entitled to grant or assign to any third party (other than a permitted assignee of Tenant’s rights under the Lease or a permitted subtenant relative to the Premises (or a portion thereof)) the right to use the Generator without Landlord’s prior written consent (which consent may be granted or withheld in Landlord’s discretion). Upon reasonable advance notice to Tenant (and provided Landlord reasonably coordinates with Tenant and provides an alternate source of backup generator capacity during said transition), Landlord shall be entitled to cause the Generator to be moved to another location near the Building, at Landlord’s cost and expense. Tenant shall pay all personal property taxes on the Generator. Tenant shall also pay any increases in the real property taxes of the Building due to the installation of the Generator within thirty (30) days of receipt of notice from Landlord which includes proof of such increase in taxes. Tenant’s indemnity obligations under Section 5.4.1.5 of the Lease, relating to the use of Hazardous Materials, shall apply to the use and operation of the Generator. Finally, Tenant’s insurance obligations under Section 10.3 of the Lease shall apply to the Generator.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!