Illuminated Road Traffic Signposts Sample Clauses

Illuminated Road Traffic Signposts. Traffic Signposts to be illuminated must be of a tubular steel large base type to BS 873 Part 7:1984 and be capable of passing the tests described in BS 873. The posts shall be hot dipped galvanised and shall comply with BSEN 1461:1999 and shall be manufactured from steel complying with the requirements of BS 4360 1986 Welded Steels, complete with double lock flush fitting vandal resistant doors, fitted with anti-vandal stainless steel M8-8mm centre pin recessed socket screw lock door bolts. Each post shall be factory primed and undercoated to G2A prior to erection with a black bituminous base as standard, after erection they are to be painted Grey RAL 693 (aircraft grey). The ground section shall remain as black bitumen with at least 150mm visible above ground level. Large base posts shall be of a steel gauge not less than 3.2mm thick and shall be cylindrical with a base diameter of not less than 139.7mm and a shaft diameter of not less than 76.1mm as a minimum. An internal backboard of dimensions not less than 450mm x 95mm x 12mm, manufactured from a substantial non-hygroscopic material, shall be fixed in the housing and an earth bolt shall be provided. The opening to the housing shall be not less than 450mm x 95mm and shall be positioned to afford easy access to the control equipment. An access slot of not less than 75mm x 150mm high for cabling purposes shall be provided approximately 300mm below ground level. Each signpost shall be suitably sized to accommodate all necessary attachments including numbering below the sign face to ensure the clearance to the finished ground level is an absolute minimum of 2.1 metres but 2.3 to 2.45 metres is preferred. However where certain signage is associated with “roundabouts, splitter islands etc” mounting heights used are to be as deemed appropriate. Signposts in the same location shall be of the same material and height unless otherwise approved by the Network Lighting Manager. A concrete "mowing strip" shall be provided around signposts, 300mm offset from sign assemblies, where installed in verge areas. Flange based signposts may be used subject to the prior approval of the Network Lighting Manager. Where ground conditions dictate, signposts may be erected in suitably sized pots subject to the prior approval of the Network Lighting Manager. Signpost Luminaires shall be Signature Exlite Delta or similar approved PTS or PTD type with an ingress protection rating of IP66, each luminaire shall be complete with LED’s...
Sample 1Sample 2
AutoNDA by SimpleDocs

Related to Illuminated Road Traffic Signposts

  • Workstation/Laptop encryption All workstations and laptops that process and/or store DHCS PHI or PI must be encrypted using a FIPS 140-2 certified algorithm which is 128bit or higher, such as Advanced Encryption Standard (AES). The encryption solution must be full disk unless approved by the DHCS Information Security Office.

  • Electrical appliance safety The Hirer shall ensure that any electrical appliances brought by them to the premises and used there shall be safe, in good working order, and used in a safe manner in accordance with the Electricity at Work Regulations 1989. Where a residual circuit breaker is provided the hirer must make use of it in the interests of public safety.

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CBB chooses to subtend a Verizon access Tandem, CBB’s NPA/NXX must be assigned by CBB to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG.

  • Orthotic Appliances Coverage for Orthotic Appliances is limited to custom-made leg, arm, back and neck braces, when related to a surgical procedure or when used in an attempt to avoid surgery, and is necessary to carry out normal activities of daily living excluding sports activities. Coverage includes the initial purchase, fitting or adjustment. Replacements are covered only when Medically Necessary due to a change in bodily configuration. All other Orthotic Appliances are not covered. The determination of whether a covered item will be paid under the DME, orthotics or prosthetics benefits will be based upon its classification as defined by the Centers for Medicare and Medicaid Services.

  • The Web Services E-Verify Employer Agent agrees to, consistent with applicable laws, regulations, and policies, commit sufficient personnel and resources to meet the requirements of this MOU.

  • Mailboxes Each department or unit shall make available a convenient receptacle at a designated location for Employees to receive University business correspondence.

  • Trunk Group Architecture and Traffic Routing The Parties shall jointly engineer and configure Local/IntraLATA Trunks over the physical Interconnection arrangements as follows:

  • Devices BNY Mellon will restrict the transfer of Customer Data from its network to mass storage devices. BNY Mellon will use a mobile device management system or equivalent tool when mobile computing is used to provide the services. Applications on such authenticated devices will be housed within an encrypted container and BNY Mellon will maintain the ability to remote wipe the contents of the container.

  • Automated Teller Machines We do not accept deposits at ATMs that we do not own or operate. Funds from deposits (cash or checks) made at automated teller machines (ATMs) we own or operate will follow the same availability schedule as making a deposit in person to one of our employees, except that same day availability may not apply to the items noted. These deposits may be available the first day after the day of deposit.

  • PROHIBITION ON CERTAIN TELECOMMUNICATIONS AND VIDEO SURVEILLANCE SERVICES OR EQUIPMENT To the extent applicable, Supplier certifies that during the term of this Contract it will comply with applicable requirements of 2 C.F.R. § 200.216.

Time is Money Join Law Insider Premium to draft better contracts faster.