Maintaining Phase Sample Clauses

Maintaining Phase. When the battery is fully charged the charger will leave the absorption phase and enter the Maintenance Phase where a 13,4V supply is supplied to the battery until the battery is disconnected from the charger. The charging process for the 12V 20Ah batteries used in the FROG robot is the following. If the battery is dried (9.5V - 0%) the battery will start to charge in Bulk phase for about 7 hours at 2A. In the end of the 7 hours the level of the battery is about 70%, that means that the charge level will raise about 10% each hour. After +/- 7 hours the charger will enter into the Absorption phase where there will be an increase of about 5% of level of battery each hour. After 5 to 6 hours the battery Level will reach 100%-120% (depending of the type of battery, number of cycles and correct maintenance) . After this period the system will enter in Maintaining phase, and the battery will maintain the charge level. Figure 13 shows the battery charge behaviour using the developed charger. Only the Bulk and Absorption phases are displayed. The Maintaining phase start can be set to any point of the Absorption phase by the change of the value of one resistor component.
Sample 1
AutoNDA by SimpleDocs

Related to Maintaining Phase

  • Production Phase contract period in which the Development and the Production are to be performed.

  • Development Phase contractual phase initiated with the approval of ANP for the Development Plan and which is extended during the Production Phase while investments in xxxxx, equipment, and facilities for the Production of Oil and Gas according to the Best Practices of the Oil Industry are required.

  • Design Development Phase INDICATE IN STATEMENT OF WORK “NOT APPLICABLE” IF SECTION IS NOT APPLICABLE

  • Preconstruction Phase Services Preconstruction Phase Services shall mean all services described in Article 3.1, and any similar services described in the Request for Proposals, including such similar services as are described in the Construction Manager at Risk’s Response to the Request for Proposals to the extent they are accepted by Owner, but excluding any Early Work. Early Work shall be considered part of Construction Phase Services.

  • Development Area 10.4. The Development Area shall encompass all Deposits to be produced.

  • Construction Phase Services 3.1.1 – Basic Construction Services

  • Bidding Phase 2.8.1 The Professional, following the Owner's approval of the Construction Document Phase, shall assist the Owner in obtaining bids and in award and preparation of Construction Contracts.

  • Design Development Phase Services 3.3.1 Based on the Owner’s approval of the Schematic Design Documents, and on the Owner’s authorization of any adjustments in the Project requirements and the budget for the Cost of the Work, the Architect shall prepare Design Development Documents for the Owner’s approval. The Design Development Documents shall illustrate and describe the development of the approved Schematic Design Documents and shall consist of drawings and other documents including plans, sections, elevations, typical construction details, and diagrammatic layouts of building systems to fix and describe the size and character of the Project as to architectural, structural, mechanical and electrical systems, and other appropriate elements. The Design Development Documents shall also include outline specifications that identify major materials and systems and establish, in general, their quality levels.

  • Preconstruction Phase The Preconstruction Phase shall mean the period commencing on the date of this CM/GC Contract and ending upon commencement of the Construction Phase; provided that if the Owner and CM/GC agree, the Construction Phase may commence before the Preconstruction Phase is completed, in which case both phases shall proceed concurrently, subject to the terms and conditions of the Contract Documents.

  • Construction Phase Part 1 –

Time is Money Join Law Insider Premium to draft better contracts faster.