Manufacturer's Recommendations. All work or materials shall be installed in accordance with the manufacturer's recommendations and requirements. The Contractor shall obtain the manufacturer’s recommendations and requirements, for its use at the Site in executing the Work, copies of bulletins, circulars, catalogues, or other publications bearing the manufacturer’s titles, numbers, editions, dates, etc. If the manufacturer’s recommendations and requirements are not available, the Contractor shall request installation instructions from the Design Professional.
Manufacturer's Recommendations. All work or materials shall be installed in accordance with the manufacturer's recommendations and requirements. The CM/GC shall obtain the manufacturer’s recommendations and requirements, for its use at the Site in executing the Work, copies of bulletins, circulars, catalogues, or other publications bearing the manufacturer’s titles, numbers, editions, dates, etc. If the manufacturer’s recommendations and requirements are not available, the CM/GC shall request installation instructions from the Design Professional.
Manufacturer's Recommendations. (h) the requirements of the Project Documents; and
Manufacturer's Recommendations. 1.9.18 Office for Resident Engineer Inspector.
Manufacturer's Recommendations. A. Except as otherwise approved by Nassau BOCES or the participating District(s), determine and comply with manufacturers’ recommendations on product handling, storage and protection.
Manufacturer's Recommendations. All installations shall be in accordance with manufacturer's published recommendations and specific written directions of manufacturer's representative. Should Contract Documents differ from recommendations of manufacturer or directions of manufacturer’s representative, Contractor shall analyze differences, make recommendations to the District and the Architect in writing, and shall not proceed until interpretation or clarification has been issued by the District and/or the Architect.
Manufacturer's Recommendations. All work or materials shall be installed in accSoErCdTaIOnNc2e–wPiRthE-CtOhMeMmENaCnEuMfEaNcTtuPrHeArS'sE recommendations and requirements. The Contractor shall obtain the manufacturer’s recoPmARmT 2en–dCaOtNioTnRAsCaTnDdOCreUqMuENirTeSmAeNDntSsI,TEfoPrLiAtsN use at the Site in executing the Work, copies of bulletins, circulars, catalogues, or other publications bearing the manufacturer’s titles, numbers, editions, dates, etc. If the manufacturer’s recommendations and requirements are not available, the Contractor shall request installation instructions from the Design Professional.
Manufacturer's Recommendations. All work or materials shall be installed in accordance with the Contract Documents and the manufacturer's recommendations and requirements. The CMR shall obtain the manufacturer’s recommendations, requirements, and referenced standards, for its use at the Site in executing the Work. Manufacturer’s recommendations shall include copies of bulletins, circulars, catalogues, or other publications bearing the manufacturer’s titles, numbers, editions, dates, etc. Reference standards include standards promulgated by the Board of the standard as referenced in the plans, specifications and applicable building codes. If the manufacturer’s recommendations or reference standards are not available, the CMR shall request installation instructions from the Design Professional.
Manufacturer's Recommendations. All work or materials shall be installed in accordance with the Contract Documents and the manufacturer's recommendations, requirements and reference standards. The CM/GC shall obtain the manufacturer’s recommendations, requirements and reference standards for its use at the Site in executing the Work. Manufacturer’s recommendations shall include copies of bulletins, circulars, catalogues, or other publications bearing the manufacturer’s titles, numbers, editions, dates, etc. Reference standards include standards promulgated by the agency of the standard as referenced in the plans, specifications and applicable building codes. If the manufacturer’s recommendations or reference standards are not available, the CM/GC shall request instructions from the Design Professional.
Manufacturer's Recommendations. Except as otherwise shown or specified, comply with the recommendations and instructions of the manufacturer of the sheet metal being fabricated.
