Nonconformances Noted During Government Inspection Sample Clauses

Nonconformances Noted During Government Inspection. All rework requests submitted for defects noted during Government inspection must be approved by the applicable contracting officer. 5. For reworks requiring the Government's approval, the contractor may submit a standard rework procedure (SRP), for certain defects, under the contractor's documented QAP Corrective and Preventive Action Program. The SRPs must be specific and these must be evaluated by DLA Troop Support-FTRC and approved by the applicable contracting officer. 6. If the contractor elects to rework nonconforming product, it must be reworked and reoffered within 30 days from date of initial rejection. 7. All requests for rework shall be accompanied with a comprehensive rework plan. The rework plan will include rational information and data that supports the rework plan and ensures the elimination of nonconforming material from the lot. See “Request for Rework, Request for Waiver, Request for Deviation, or Reinspection of Nonconforming Supplies”. After any lot’s failure or rework, if the lot is reinspected, it will be both Contractor and Government inspected at the next higher sample size.” (C.) Contractor's Quality History: 1. Effectiveness of corrective actions (rework/screen inspections) taken by the contractor prior to Government end item verification inspection (receipt, in-process and contractor's end-item inspections) will be determined by the results of the end item verification inspection performed by the contractor. Corrective actions taken to ensure compliance with the contractual requirements prior to the Government inspection will not be counted against the contractor's quality history. If product is found conforming during Government inspection, the corrective action will be determined to have been effective. 2. If product is found nonconforming during the Government inspection following contractor corrective action for the same defect (or defect category in case of critical pouch defects) for which the contractor took a corrective action, the corrective action will be determined to have been ineffective. E-7. Request for Rework, Request for Waiver, Request for Deviation, or Reinspection of Nonconforming Supplies (A.) When the requirements cited in the section of this solicitation/contract entitled “Rework of Product Pre or Post Acceptance” require that a written request for deviation, waiver, rework, or reinspection must be furnished, as appropriate, to the Contracting Officer, that request shall at a minimum contain the following...
Sample 1
AutoNDA by SimpleDocs

Related to Nonconformances Noted During Government Inspection

  • Refund During Cooling-Off Period The PEI will provide the Student with a cooling-off period of seven (7) working days after the date that the Contract has been signed by both parties. The Student will be refunded the highest percentage (stated in Schedule D) of the fees already paid if the Student submits a written notice of withdrawal to the PEI within the cooling-off period, regardless of whether the Student has started the course or not.

  • Drawings Submitted During the Contract Term Where required to develop, maintain and deliver diagrams or other technical schematics regarding the scope of work, Contractor shall do so on an ongoing basis at no additional charge, and must, as a condition of payment, update drawings and plans during the Contract term to reflect additions, alterations, and deletions. Such drawings and diagrams shall be delivered to the Authorized User’s representative.

  • Addressing Objections Raised During Public Comment Period The Parties agree that the procedure contemplated for public review of this Stipulated Order and the Regional Water Board’s or its delegate’s adoption of this Stipulated Order is lawful and adequate. The Parties understand that the Regional Water Board or its delegate has the authority to require a public hearing on this Stipulated Order. If procedural objections are raised or the Regional Water Board requires a public hearing prior to the Stipulated Order becoming effective, the Parties agree to meet and confer concerning any such objections, and may agree to revise or adjust the procedure and/or this Stipulated Order as necessary or advisable under the circumstances.

  • Delays during construction Without prejudice to the provisions of Clause 10.3 (ii), in the event the Contractor does not achieve any of the Project Milestones or the Authority’s Engineer shall have reasonably determined that the rate of progress of Works is such that Completion of the Project Highway is not likely to be achieved by the end of the Scheduled Completion Date, it shall notify the same to the Contractor, and the Contractor shall, within 15 (fifteen) days of such notice, by a communication inform the Authority’s Engineer in reasonable detail about the steps it proposes to take to expedite progress and the period within which it shall achieve the Project Completion Date.

  • Crossing of Picket Lines During Strike An Employee covered by this Agreement shall have the right to refuse to cross a picket line or to handle struck work arising out of Labour disputes. Failure to cross such a picket line or handle struck goods by a member of this Union shall not be considered a violation of this Agreement, nor shall it be grounds for disciplinary action. An Employee who is absent by reason of refusal to cross a picket line shall be paid at the discretion of the Employer.

  • Maintenance during Construction Period (i) During the Construction Period, the Contractor shall maintain, at its cost, the existing lane(s) of the Project Highway so that the traffic worthiness and safety thereof are at no time materially inferior as compared to their condition on Appointed Date, and shall undertake the necessary repair and maintenance works for this purpose; provided that the Contractor may, at its cost, interrupt and divert the flow of traffic if such interruption and diversion is necessary for the efficient progress of Works and conforms to Good Industry Practice; provided further that such interruption and diversion shall be undertaken by the Contractor only with the prior written approval of the Authority’s Engineer which approval shall not be unreasonably withheld. For the avoidance of doubt, it is agreed that the Contractor shall at all times be responsible for ensuring safe operation of the Project Highway. It is further agreed that in the event the Project includes construction of a bypass or tunnel and realignment of the existing carriageway, the Contractor shall maintain the existing highway in such sections until the new Works are open to traffic.

  • C4 Contract Price During Extension of the Initial Contract Period C4.1 Subject to the Pricing Schedule and the provision in clause F6 (Variation), the Contract Price shall apply for the Initial Contract Period and following an extension pursuant to clause F8 (Extension of Initial Contract Period), to the date of expiry of the extended period, or such earlier date of termination or partial termination of the agreement in accordance with the Law or the provisions of the Contract. C5 Euro

  • Drawings Submitted During the Contract Term Where required to develop maintain and deliver diagrams or other technical schematics regarding the scope of work, Contractor shall do so on an ongoing basis at no additional charge, and must, as a condition of payment, update drawings and plans during the Contract term to reflect additions, alterations, and deletions. Such drawings and diagrams shall be delivered to the Authorized User’s representative.

  • Frequency and Duration There shall be an open enrollment period for health coverage in each year of this Agreement, and for dental coverage in the first year of this Agreement. Each year of the Agreement, all employees shall have the option to complete a Health Assessment. Open enrollment periods shall last a minimum of fourteen (14) calendar days in each year of the Agreement. Open enrollment changes become effective on January 1 of each year of this Agreement. Subject to a timely contract settlement, the Employer shall make open enrollment materials available to employees at least fourteen (14) days prior to the start of the open enrollment period.

  • Additional Requirements from Authorized Users An Authorized User may have distinct requirements that must be met by all individuals employed by or working for the Authorized User. The Contractor’s Staff Members will be expected to comply with these requirements as a condition of the placement.

Time is Money Join Law Insider Premium to draft better contracts faster.