Optical Connectors Sample Clauses

Optical Connectors. The CFP2 module shall support LC, MTP12 and MTP24 optical connector types, as listed in Table 5-3. The optical connectors are positioned in the CFP2 module as illustrated in Figure 5-10. The optical connector is centered in position along the X-axis (module width) with an offset tolerance of ±0.5mm. The position of the optical connector in the Y and Z axes shall be specified by the CFP2 module manufacturer. Table 5-3: Optical Connectors8 Pin # Category Reference Number LC Connector TBA TBA MPO12 Connector TBA TBA MPO24 Connector TBA TBA 8 Other optical connectors may be supported Figure 5-10: CFP2 Optical Connector Position Offset 2mm Transmitter Receiver Module center Connector center
Sample 1Sample 2Sample 3See All (10)
AutoNDA by SimpleDocs
Optical Connectors. ‌ The CFP4 module shall support LC, MTP12 and MTP24 optical connector types, as listed in Table 5-3. Table 5-3: Optical Connectors 3 Pin # Category Reference Number LC Connector TBA TBA MPO12 Connector TBA TBA MPO24 Connector TBA TBA
Sample 1Sample 2Sample 3See All (8)
Optical Connectors. The optical connector for the MSA shall be located per Figure 5-16 below. The optical connector is centered in position along the X-axis (module width) with an offset tolerance of ±0.5mm. The position of the optical connector in the Y and Z axes shall be specified by the CFP module manufacturer.
Sample 1Sample 2Sample 3See All (4)
Optical Connectors. ‌ 4 The CFP8 module shall support LC, MTP12 and MTP16 optical connector types, as listed in Table 5-3. 5 The optical connectors are positioned in the CFP8 module as illustrated in Figure 5-10. 6 Table 5- 3: Optic al Connec tors 5 Pin # Category Reference Number LC Connector TBA TBA MPO12 Connector TBA TBA MPO16 Connector TBA TBA MPO32 Connector TBA TBA 5 Other optical connectors may be supported 3 Figure 5- 10: CFP8 Optic al Connec tor Pos ition
Sample 1
Optical Connectors 
Sample 1

Related to Optical Connectors

  • Network Interconnection Architecture Each Party will plan, design, construct and maintain the facilities within their respective systems as are necessary and proper for the provision of traffic covered by this Agreement. These facilities include but are not limited to, a sufficient number of trunks to the point of interconnection with the tandem company, and sufficient interoffice and interexchange facilities and trunks between its own central offices to adequately handle traffic between all central offices within the service areas at a P.01 grade of service or better. The provisioning and engineering of such services and facilities will comply with generally accepted industry methods and practices, and will observe the rules and regulations of the lawfully established tariffs applicable to the services provided.

  • Interconnection 2.2.10 Startup Testing and Commissioning

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!