Product References a. “Or Equal” In all Solicitations or Bid Specifications, the words “or equal” are understood to apply where a copyrighted, brand name, trade name, catalog reference, or patented Product is referenced. References to such specific Product are intended as descriptive, not restrictive, unless otherwise stated. Comparable Product will be considered if proof of compatibility is provided, including appropriate catalog excerpts, descriptive literature, specifications and test data, etc. The Commissioner’s decision as to acceptance of the Product as equal shall be final. b. Discrepancies in References In the event of a discrepancy between the model number referenced in the Solicitation or Bid Specifications and the written description of the Products that cannot be reconciled, then the written description shall prevail.
Material Safety Data Sheet Seller shall provide to Buyer with each delivery any Material Safety Data Sheet applicable to the work in conformance with and containing such information as required by the Occupational Safety and Health Act of 1970 and regulations promulgated thereunder or its State approved counterpart.
Mail Order Catalog Warnings In the event that, the Settling Entity prints new catalogs and sells units of the Products via mail order through such catalogs to California consumers or through its customers, the Settling Entity shall provide a warning for each unit of such Product both on the label in accordance with subsection 2.4 above, and in the catalog in a manner that clearly associates the warning with the specific Product being purchased. Any warning provided in a mail order catalog shall be in the same type size or larger than other consumer information conveyed for such Product within the catalog and shall be located on the same display page of the item. The catalog warning may use the Short-Form Warning content described in subsection 2.3(b) if the language provided on the Product label also uses the Short-Form Warning.
Originating Switched Access Detail Usage Data A category 1101XX record as defined in the EMI Telcordia Practice BR-010-200- 010.
Federal Medicaid System Security Requirements Compliance Party shall provide a security plan, risk assessment, and security controls review document within three months of the start date of this Agreement (and update it annually thereafter) in order to support audit compliance with 45 CFR 95.621 subpart F, ADP System Security Requirements and Review Process.
Cross-References Unless otherwise specified, references in this Agreement and in each other Loan Document to any Article or Section are references to such Article or Section of this Agreement or such other Loan Document, as the case may be, and, unless otherwise specified, references in any Article, Section or definition to any clause are references to such clause of such Article, Section or definition.
Regulatory References A reference in this Agreement to a section in the HIPAA Rules means the section as in effect or as amended.
MATERIAL SAFETY DATA SHEETS As applicable, Contractor shall provide Purchaser with all appropriate Material Safety Data Sheets (“MSDS”) at the time of delivery of each shipment of Goods which requires such compliance and/or and for materials used by Contractor while performing Services and any updates of the same.
Substance Abuse Treatment Information Substance abuse treatment information shall be maintained in compliance with 42 C.F.R. Part 2 if the Party or subcontractor(s) are Part 2 covered programs, or if substance abuse treatment information is received from a Part 2 covered program by the Party or subcontractor(s).
National Treatment and Most-favoured-nation Treatment (1) Each Contracting Party shall accord to investments of investors of the other Contracting Party, treatment which shall not be less favourable than that accorded either to investments of its own or investments of investors of any third State. (2) In addition, each Contracting Party shall accord to investors of the other Contracting Party, including in respect of returns on their investments, treatment which shall not be less favourable than that accorded to investors of any third State. (3) The provisions of paragraphs (1) and (2) above shall not be construed so as to oblige one Contracting Party to extend to the investors of the other the benefit of any treatment, preference or privilege resulting from: (a) Any existing or future free trade area, customs unions, monetary union or similar international agreement or other forms of regional cooperation to which one of the Contracting Parties is or may become a party, or (b) Any matter pertaining wholly or mainly to taxation.