Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.
Bumping The employee scheduled for layoff under Section D. may elect to either accept layoff or bump in accordance with the process outlined in this Section. An employee scheduled for layoff who fails or is unable, in accordance with Section D.3., to exercise the option to bump to the least senior position shall be laid off. Within seven calendar days of receipt of notification of layoff, the employee scheduled for layoff shall notify the Employer of his/her decision to either accept layoff or bump within his/her current class series, as listed below. Alternatively, an employee may bump into the least senior position in the layoff unit in a former class series at or below any level at which the employee had satisfactorily completed the required probationary period. This alternative shall not apply to employees who were demoted from the higher paying class for disciplinary reasons or who transferred from the higher paying classification in less than satisfactory employment status. An employee seeking to bump into another position must meet all requirements in accordance with Section D.3. As a result of bumping, an employee shall not earn more than the maximum rate of the lower classification bumped into or more than the rate previously earned in a higher classification from which the employee bumped. When an employee bumps downward, he/she shall be paid at that step in the lower level pay range which credits the service in the higher level range(s) to the step at which the employee was paid when promoted from a lower level. Corrections Medical Aide Corrections Medical Officer 8 Corrections Medical Officer E9 Corrections Medical Unit Officer E10 Corrections Officer Corrections Officer 8 Corrections Officer E9 Resident Unit Officer 10 Forensic Security Aide Forensic Security Assistant 8 Forensic Security Assistant 9 Forensic Security Assistant E10 Special Alternative Incarceration Officer Special Alternative Incarceration Officer 9 Special Alternative Incarceration Officer E10 Bump process--after the parties have identified the layoff unit:
1. The Employer shall identify the vacancies and least senior employees within the layoff unit equal to the number of positions being abolished within the layoff unit. These least senior employees shall be issued layoff notices.
2. If the layoff unit contains more than one work location, employees remaining in the layoff unit who are displaced from their original work location (due to the closure, reduction consolidation, etc.), will be placed in existing vacancies or the vacated positions identified in step 1 above. Placement into these positions shall be in seniority order based on preferences provided by the employees.
3. Employees remaining in the layoff unit may request an exchange transfer (one for one transfer) with any bargaining unit member in the same classification in accordance with Article 15 Part D §A.6., either within or outside the layoff unit. Exchange transfers shall not be unreasonably denied and will be processed with the rest of the layoff unit moves, if possible. In addition, during the bump process, exchange transfers occurring within this Article shall supersede all other closer to home and seniority based transfers or recalls, as no vacancy exists. Requests for exchange transfers shall be in writing by both employees requesting to exchange.
4. The parties may reach mutual agreement to modify the process to minimize impact on affected employees as necessary.
Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.
CUTTING AND PATCHING The Contractor shall be responsible for cutting, fitting or patching required to complete the Work or to make its parts fit together properly.
Training and Orientation (a) No employee shall be required to work on any job or operate any piece of equipment until he/she has received proper training and instruction.
(b) The Employer shall provide sufficient and adequate training and/or orientation to any employee working in a new or unfamiliar work area or position.
Packing and Marking All material and equipment to be furnished by the Contractor shall be packed, crated or otherwise suitably protected to withstand shipment undamaged to the destination. Each package, crate or part shall be marked plainly with the name of the consignee, shipping destination, the Owner's order number, and such other markings as are required. Complete packing lists, one copy with each package and two (2) copies by mail to the Owner at time of shipment, shall be supplied showing contents and identity of each package.
Sealing and Marking of Bids The bidder shall seal the original and each copy of the bid in separate envelopes duly marking the envelopes “ORIGINAL” and “COPY”. The envelopes shall then be sealed in an outer separate envelope.
Advertising and Marketing Except in so far as herein expressly provided, the Service Provider shall not make or issue any formal or informal announcement (with the exception of Stock Exchange announcements), advertisement or statement to the media in connection with this Agreement or otherwise disclose the existence of this Agreement or the subject matter thereof to any other person without the prior written consent of SARS.
Bullying and Harassment Neither DFMC nor you will engage in behaviour that is, or may be reasonably considered to be, intimidating, bullying or harassing or commit any act or behaviour which is offensive or abusive in connection with this Contract. If you are in breach of this clause, DFMC may suspend the collection of your milk for a period of 5 days or until such time as DFMC determines (acting reasonably) that the behaviour has been rectified.
Advertising and Publicity No Credit Party shall issue or disseminate to the public (by advertisement, including without limitation any “tombstone” advertisement, press release or otherwise), submit for publication or otherwise cause or seek to publish any information describing the credit or other financial accommodations made available by the Lenders pursuant to this Agreement and the other Loan Documents without the prior written consent of the Administrative Agent. Nothing in the foregoing shall be construed to prohibit any Credit Party from making any submission or filing which it is required to make by applicable law or pursuant to judicial process; provided, that, (i) such filing or submission shall contain only such information as is necessary to comply with applicable law or judicial process and (ii) unless specifically prohibited by applicable law or court order, the Borrower shall promptly notify the Administrative Agent of the requirement to make such submission or filing and provide the Administrative Agent with a copy thereof.
