Substance Abuse Treatment Information Substance abuse treatment information shall be maintained in compliance with 42 C.F.R. Part 2 if the Party or subcontractor(s) are Part 2 covered programs, or if substance abuse treatment information is received from a Part 2 covered program by the Party or subcontractor(s).
Reactive Power and Primary Frequency Response 9.6.1 Power Factor Design Criteria
Primary Frequency Response Developer shall ensure the primary frequency response capability of its Large Generating Facility by installing, maintaining, and operating a functioning governor or equivalent controls. The term “functioning governor or equivalent controls” as used herein shall mean the required hardware and/or software that provides frequency responsive real power control with the ability to sense changes in system frequency and autonomously adjust the Large Generating Facility’s real power output in accordance with the droop and deadband parameters and in the direction needed to correct frequency deviations. Developer is required to install a governor or equivalent controls with the capability of operating: (1) with a maximum 5 percent droop ± 0.036 Hz deadband; or (2) in accordance with the relevant droop, deadband, and timely and sustained response settings from an approved Applicable Reliability Standard providing for equivalent or more stringent parameters. The droop characteristic shall be: (1) based on the nameplate capacity of the Large Generating Facility, and shall be linear in the range of frequencies between 59 and 61 Hz that are outside of the deadband parameter; or (2) based on an approved Applicable Reliability Standard providing for an equivalent or more stringent parameter. The deadband parameter shall be: the range of frequencies above and below nominal (60 Hz) in which the governor or equivalent controls is not expected to adjust the Large Generating Facility’s real power output in response to frequency deviations. The deadband shall be implemented: (1) without a step to the droop curve, that is, once the frequency deviation exceeds the deadband parameter, the expected change in the Large Generating Facility’s real power output in response to frequency deviations shall start from zero and then increase (for under-frequency deviations) or decrease (for over-frequency deviations) linearly in proportion to the magnitude of the frequency deviation; or (2) in accordance with an approved Applicable Reliability Standard providing for an equivalent or more stringent parameter. Developer shall notify NYISO that the primary frequency response capability of the Large Generating Facility has been tested and confirmed during commissioning. Once Developer has synchronized the Large Generating Facility with the New York State Transmission System, Developer shall operate the Large Generating Facility consistent with the provisions specified in Articles 9.5.5.1 and 9.5.5.2 of this Agreement. The primary frequency response requirements contained herein shall apply to both synchronous and non-synchronous Large Generating Facilities.
Labeling Upon request, Lessee will xxxx the Equipment indicating Lessor's interest with labels provided by Lessor. Lessee will keep all Equipment free from any other marking or labeling which might be interpreted as a claim of ownership.
Denial of Preferential Tariff Treatment The Customs Authority of the importing Party may deny a claim for preferential tariff treatment when: (a) the good does not qualify as an originating good; or (b) the importer, exporter or producer fails to comply with any of the relevant requirements of this Chapter.
Quantity If Seller delivers more than the quantity of Goods ordered, Buyer may reject all or any excess Goods. Any such rejected Goods shall be returned to Seller at Seller's risk and expense. If Buyer does not reject the Goods and instead accepts the delivery of Goods at the increased or reduced quantity, the Price for the Goods shall be adjusted on a pro-rata basis.
Emergency Medical Treatment I grant the Releasees permission to authorize emergency medical treatment as they deem appropriate, and agree that such action by the Releasees shall be subject to the terms of this Agreement. I understand and agree that the Releasees assume no responsibility for any injury or damage that might result from such emergency medical treatment.
Xxx Treatment We have not promised you any particular tax outcome from buying or holding the Note.
CLEARANCE PATTERNS 7.1 The State shall develop separate clearance patterns for each of the following: Vendor Account Payroll Account AHS-PATH Account Unemployment Insurance Benefits Account Federal Highway Planning & Construction Program (Vendor Account) 7.2 The following shall develop the State's clearance patterns: The State of Vermont-Department of Finance and Management 7.3 The sources of data the State shall use when developing its clearance patterns are as follows: Vendor account-State's central accounting system Unemployment Insurance Benefits Account-Department of Labor bank records All other accounts-Bank files from the State Treasurer's Office 7.4 The State shall use the following methodology when developing its clearance patterns: When developing each clearance pattern, the State shall track at least 99% of the funds disbursed, from issuance to clearance, for a period of at least three months. 7.5 The State shall identify for each check or warrant (hereafter, check) in the population: (1) the date the check was released for payment; (2) the date the check was debited from the State's account, and, (3) the amount of the check. 7.6 The State shall use the following method to calculate the dollar-weighted average day of clearance: To determine the number of days each check was outstanding (clearance time), the issue date shall be subtracted from the date the check cleared the State's account. To determine the percentage of the disbursement paid out each day following issuance, the amount of the checks that clear the State's account each day shall be summed and then divided by the amount of the total disbursement. For each day following issuance, the clearance time of the checks paid out that day shall be multiplied by the percentage of the total disbursement those checks represent. This product is the clearance factor. The dollar-weighted average day of clearance for the disbursement shall be determined by summing the clearance factor of each day following the disbursement. 7.7 The State shall adjust each clearance pattern to reflect the dollar-weighted proportion of funds paid out by EFT/Direct payroll, with the following exceptions: All Accounts - An adjustment is not necessary since the State includes all payments in its clearance pattern calculations, including those paid electronically. The State shall also adjust each clearance pattern to reflect: n/a 7.8 Each of the State's clearance patterns is calculated in calendar days. 7.9 An authorized State official shall certify that each clearance pattern developed by the State accurately corresponds to the clearance activity of the programs to which it is applied. This certification shall be provided to the Fiscal Service prior to the effective date of the Agreement. The State shall recertify its clearance patterns at least every five years. 7.10 The State shall follow the procedures of 31 CFR 205 if it has actual or constructive knowledge, at any time, that a clearance pattern does not correspond to a program's clearance activity.
Minimum Standard of Treatment 1. Each Party shall accord to a covered investment treatment in accordance with the customary international law minimum standard of treatment of aliens, including fair and equitable treatment and full protection and security. 2. The concepts of “fair and equitable treatment” and “full protection and security” in paragraph 1 do not require treatment in addition to or beyond that which is required by the customary international law minimum standard of treatment of aliens. 3. A breach of another provision of this Agreement, or of a separate international agreement, does not establish that there has been a breach of this Article.
