Recess - Caucus a. The Chairperson of either team may call for a caucus of reasonable duration at any time.
Recess - Caucus Sample Clauses
Related to Recess - Caucus
Summer Session A. All ASEs employed in the Summer Session shall receive the same general range adjustment as ASEs received in the preceding Fall term. B. The following articles apply to ASEs who are employed in the summer session: Recognition, Wages (range adjustment only), DCP, Travel, Health and Safety, Leaves, Holidays, Duration, Workspace and Instructional Support, Parking, Grievance and Arbitration, Waiver, Management and Academic Rights, No Strikes, Non-Discrimination, Union Access and Rights, Union Security, Discipline and Dismissal, Emergency Layoff, Employment Files and Evaluations, Definitions, Severability, Labor-Management Meetings, and Classifications. C. The remainder of the articles in the agreement does not apply to ASEs who are employed in the summer session. D. The topic of Summer Session, and effects of changes on terms and conditions of employment for ASEs employed in Summer Session, shall be reopened for bargaining commencing no later than January 2, 2001.
Notice to Union The Employer will give the Union written notice of technological change at least three (3) months prior to the date the change is to be effected. During this period the parties will meet to discuss the steps to be taken to assist Employees who could be affected.
Check Meters Developer, at its option and expense, may install and operate, on its premises and on its side of the Point of Interconnection, one or more check meters to check Connecting Transmission Owner’s meters. Such check meters shall be for check purposes only and shall not be used for the measurement of power flows for purposes of this Agreement, except as provided in Article 7.4 below. The check meters shall be subject at all reasonable times to inspection and examination by Connecting Transmission Owner or its designee. The installation, operation and maintenance thereof shall be performed entirely by Developer in accordance with Good Utility Practice.
Christmas Closedown 15.1 It is agreed that whenever annual leave is taken in conjunction with the Christmas/New Year period (as per Calendar in sub-clause 2.11), it is to be taken in accordance with the following procedure. 15.2 Employees who have not accrued sufficient pro rata annual leave prior to commencement of the Christmas/New Year period, may be granted leave without pay by their Employer to give that employee at least the minimum leave of absence required. 15.3 Where the Employer decides to close a site over the Christmas/New Year period for any period in excess of the agreed minimum closedown, up to and including 20 Annual Leave days, then the Employer shall give at least 2 months’ notice to employees as per the relevant Award. Employees who have no, or insufficient, accrued annual leave equal to the period of the closure, may be granted leave without pay for that period. 15.4 Notwithstanding anything elsewhere contained in this Agreement, the Employer may require any employee to work in unforeseen or emergency circumstances during the Christmas period. 15.5 Where an employee requests that annual leave be allowed in one continuous period at Christmas, such a request shall not be unreasonably refused. 15.6 It is a breach of this Agreement and the Award for an employee to be paid his/her full accrual, or part thereof, of annual leave at Christmas or any other time, unless that employee takes such annual leave or his/her employment is terminated. Employment is not to be terminated for reasons of avoidance of this clause.
Notice to NASD In the event any person or entity (regardless of any NASD affiliation or association) is engaged to assist the Company in its search for a merger candidate or to provide any other merger and acquisition services, the Company will provide the following to the NASD and EBC prior to the consummation of the Business Combination: (i) complete details of all services and copies of agreements governing such services; and (ii) justification as to why the person or entity providing the merger and acquisition services should not be considered an "underwriter and related person" with respect to the Company's initial public offering, as such term is defined in Rule 2710 of the NASD's Conduct Rules. The Company also agrees that proper disclosure of such arrangement or potential arrangement will be made in the proxy statement which the Company will file for purposes of soliciting stockholder approval for the Business Combination.
Notice to Centrelink Where a decision has been made to terminate the employment of employees, the employer shall notify Centrelink thereof as soon as possible giving relevant information including the number and categories of the employees likely to be affected and the period over which the terminations are intended to be carried out.
Adjustments Not Yet Effective Notwithstanding anything to the contrary in this Indenture or the Notes, if: (i) a Note is to be converted pursuant to Physical Settlement or Combination Settlement; (ii) the record date, effective date or Expiration Time for any event that requires an adjustment to the Conversion Rate pursuant to Section 5.05(A) has occurred on or before the Conversion Date for such conversion (in the case of Physical Settlement) or on or before any VWAP Trading Day in the Observation Period for such conversion (in the case of Combination Settlement), but an adjustment to the Conversion Rate for such event has not yet become effective as of such Conversion Date or VWAP Trading Day, as applicable; (iii) the Conversion Consideration due upon such conversion includes any whole shares of Common Stock (in the case of Physical Settlement) or due in respect of such VWAP Trading Day includes any whole or fractional shares of Common Stock (in the case of Combination Settlement); and (iv) such shares are not entitled to participate in such event (because they were not held on the related record date or otherwise), then, solely for purposes of such conversion, the Company will, without duplication, give effect to such adjustment on such Conversion Date (in the case of Physical Settlement) or such VWAP Trading Day (in the case of Combination Settlement). In such case, if the date on which the Company is otherwise required to deliver the consideration due upon such conversion is before the first date on which the amount of such adjustment can be determined, then the Company will delay the settlement of such conversion until the second (2nd) Business Day after such first date.
Commercial Operation Date 6.4.1 The SPV shall ensure that the Project Commercial Operation Date is achieved on or prior to the Scheduled Commercial Operation Date. The SPV shall provide a written notice to MSEDCL at least 30 (thirty) days in advance intimating MSEDCL of the proposed date on which the Commercial Operation Date of a Unit or the Project is proposed to be achieved. 6.4.2 If the Commercial Operation Date for the Units having a capacity equivalent to at least 75% (seventy five percent) of the Contracted Capacity is achieved before the Scheduled Commercial Operation Date, then all Units in respect of which the Commercial Operation Date has been achieved prior to the Scheduled Commercial Operation Date would be eligible for incentives as follows: (a) the Unit(s) injecting energy at 11 kV /22 kV shall be given an incentive of Rs. 0.25/ kWh; and (b) the Unit(s) injecting energy at 33 kV shall be given an incentive of Rs. 0.15/ kWh, for the power sold to MSEDCL for the first 3 (three) years from the Commercial Operation Date. To receive such incentives from MSAPL, which shall be over and above the Tariff, the SPV shall follow the process agreed to by the SPV under the Implementation Agreement. 6.4.3 It is hereby clarified that the aforementioned incentive shall not be available: (i) in respect of any Unit if the Commercial Operation Date for such Unit has not been achieved prior to the Scheduled Commercial Operation Date; and (ii) if the aggregate capacity of the Units for which the Commercial Operation Date has been achieved prior to Scheduled Commercial Operation Date is less than 75% (seventy five percent) of the Contracted Capacity. 6.4.4 In the event that Commercial Operation Date for any of the Units is achieved after the Scheduled Commercial Operation Date, the SPV shall be liable to pay Liquidated Damages as per the provisions set out below. 6.4.5 Without prejudice to any other rights of MSEDCL under this PPA, in case one or more Units of the SPV are unable to achieve Commercial Operation Date within a period of 2 (two) months from the Scheduled Commercial Operation Date, the capacity of such Units shall be annulled, and the Contracted Capacity shall be reduced to that extent. For Illustration: The Project has a Contracted Capacity of 100 MW and comprises of 10 Units of 10 MW each. If at the end of the aforementioned period of 14 (fourteen) months from the Effective Date, the SPV has achieved Commissioning for only 8 out of 10 Units, then the Contracted Capacity of the Project will stand reduced for the capacity of the 2 Units which have not been Commissioned, i.e. the Contracted Capacity will be 80 (100 (original Contracted Capacity)) – 10 (capacity of each Unit)*2 (number of Units not Commissioned).
Review Periods Owner shall have up to ten (10) Business Days from its receipt of the documents listed in Sections 1.3 and 1.4 above, to issue to Contractor written comments on such documents, Drawings and Specifications. The Owner’s approval rights only apply to documents listed in Section 1.3. If comments are not received for items listed in Section 1.3 in ten (10) Business Days, the Contractor may proceed with the development of the Drawings and Specifications with the design reflected in the uncommented document. Owner will annotate the Drawings and Specifications as appropriate and return to Contractor. In the event that Owner disapproves the Drawings or Specifications, Owner shall provide Contractor with a written statement of the reasons for such rejection within the time period required for Owner’s response, and Contractor shall provide Owner with agreed to revised and corrected Drawings and Specifications as soon as possible thereafter.
Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.
