Compensation and Billing 4.1 If you are not an embedded retail generator, you agree that, subject to any applicable law:
CLASSIFICATION AND WAGES 21.01 The Job Classifications and applicable Wage Rates under this agreement are set forth at Appendix “A” (attached).
Classification and Wage Rates For the avoidance of any doubt, there will be no industrial action (protected or otherwise) taken by the employees who are bound by this Agreement in relation to the quantum of the wages, allowances and payments arising from the provisions of Clause 7
CLASSIFICATION AND COMPENSATION The parties hereto agree that the employees covered by this Agreement shall be considered engaged in the type of work and classification as set forth on Schedule A attached hereto and made a part hereof by reference.
Employment and Training Administration The ratio of trainees to journeymen on the job site shall not be greater than permitted under the plan approved by the Employment and Training Administration. Every trainee must be paid at not less than the rate specified in the approved program for the trainee's level of progress, expressed as a percentage of the journeyman hourly rate specified in the applicable wage determination. Trainees shall be paid fringe benefits in accordance with the provisions of the trainee program. If the trainee program does not mention fringe benefits, trainees shall be paid the full amount of fringe benefits listed on the wage determination unless the Administrator of the Wage and Hour Division determines that there is an apprenticeship program associated with the corresponding journeyman wage rate on the wage determination which provides for less than full fringe benefits for apprentices. Any employee listed on the payroll at a trainee rate who is not registered and participating in a training plan approved by the Employment and Training Administration shall be paid not less than the applicable wage rate on the wage determination for the classification of work actually performed. In addition, any trainee performing work on the job site in excess of the ratio permitted under the registered program shall be paid not less than the applicable wage rate on the wage determination for the work actually performed. In the event the Employment and Training Administration withdraws approval of a training program, the contractor will no longer be permitted to utilize trainees at less than the applicable predetermined rate for the work performed until an acceptable program is approved.
Orientation and Training A transferring employee will be orientated separately to both or their new home in accordance with Article 20 the collective agreement of the designated employer.
Contract Duration and Annual Salary 1. The College hereby employs the Administrator in the capacity of Director of Adult Educational Development, Assistant Professor for one year, commencing on July 1, 2023 and terminating on June 30, 2024. The Administrator accepts such employment on the conditions hereinafter set forth, and any applicable provisions of the Board of Trustees Policy Manual. In the event of conflict between Board Policy and this Contract, the Contract shall govern.
Weighing and Scaling Costs Purchaser agrees to pay for all weighing costs for logs delivered regardless if logs are purchased on a weight or scale basis. In addition, Purchaser agrees to pay for all scaling costs for logs delivered on a scale basis. Purchaser also agrees to pay for all costs associated with the transmission and reporting of scale or weight data.
- INCOME PROTECTION AND WORKERS COMPENSATION 2301 A nurse having accumulated income protection may claim basic pay for such income protection against such accumulation with respect to periods during which:
Faculty Selection, Supervision, and Evaluation A. Faculty for a dual credit course will be approved and employed by Hill College. The instructor must meet credential requirements of Hill College and minimum requirements as specified by the Southern Association of Colleges and Schools Commission on Colleges (SACSCOC). Each faculty member assigned to teach an academic course will have a master’s degree plus 18 hours in the specific discipline. Technical course instructors will have at least an associate degree and three years of work experience in the related business or industry.