Research and coordination; utilities Sample Clauses

Research and coordination; utilities. Design-Builder accepts an affirmative obligation to seek out and obtain information from UGAA, utilities, governmental agencies, authorities, and officials, and others possessing information needed to: (i) determine the adequacy of available utility service, limits and restrictions on construction and use of the subject Property or Project site, and the existing conditions impacting the Project; (ii) perform the Design Services completely and in accordance with the Design Professional’s Standard of Care as set forth in Article XVI; and (iii) assure that the Work complies with applicable Laws and with the Contract Documents. Design-Builder shall also confirm the information contained in the following subparagraphs. Although, all such inquiry and confirmation must be complete before Design- Builder begins the Work, and all such inquiry by Design Professional shall be completed before its submittal of designs, drawings, specifications, Construction Documents, reports, certifications, and other deliverables (“Deliverables”), this duty of inquiry and confirmation is ongoing throughout the performance of the Work. If Design-Builder believes that UGAA has (or must provide) information not otherwise available to the Design-Builder through the foregoing inquiry, and that information is essential to Design-Builder’s performance of the Work or the Design Services, Design-Builder shall request that information from the ADR in a written RFI before execution of this Agreement or at the earliest possible time thereafter, but in no case before it performs Work or Design Services that depend upon the Design-Builder’s obtaining the information. The absence of such a request from Design-Builder shall be deemed to indicate Design-Builder’s representation that it already possesses sufficient information to competently and completely perform the Work and the Design Services.
Sample 1Sample 2
AutoNDA by SimpleDocs
Research and coordination; utilities. CM accepts an affirmative obligation to seek out and obtain information from UGAA, utilities, governmental agencies, authorities, and officials, and others possessing information needed to: (i) determine the adequacy of available utility service, limits and restrictions on construction and use of the subject Property or Project site, and the existing conditions impacting the Project; and (ii) assure that the Work complies with the Contract Documents. CM shall also confirm the information contained in the following subparagraphs of this ¶ III(E). Although, all such inquiry and confirmation must be complete before CM begins the Work, this duty of inquiry and confirmation is ongoing throughout the performance of the Work. If CM believes that UGAA has (or must provide) information not otherwise available to the CM through the foregoing inquiry, and that information is essential to CM’s performance of the Work, CM shall request that information from the ADR in a written RFI before execution of this Agreement or at the earliest possible time thereafter, but in no case before it performs Work that depends upon the CM’s obtaining the information. The absence of such a request from CM shall be deemed to indicate CM’s representation that it already possesses sufficient information to competently and completely perform the Work.
Sample 1

Related to Research and coordination; utilities

  • Project Management and Coordination The Engineer shall coordinate all subconsultant activity to include quality of and consistency of work and administration of the invoices and monthly progress reports. The Engineer shall coordinate with necessary local entities.

  • Project Coordination The Engineer shall coordinate all subconsultant activity to include quality and consistency of deliverables and administration of the invoices and monthly progress reports. The Engineer shall coordinate with necessary local entities.

  • Operation and Coordination The ISO shall direct the operation of, and coordinate the maintenance scheduling of, certain facilities of the NYS Power System, including coordination with control centers maintained by the Transmission Owners in accordance with the Reliability Rules, as follows:

  • Cooperation and Coordination The Parties acknowledge and agree that it is their mutual objective and intent to minimize, to the extent feasible and legal, taxes payable with respect to their collaborative efforts under this Agreement and that they shall use all commercially reasonable efforts to cooperate and coordinate with each other to achieve such objective.

  • Utility Coordination Identify all potential utility conflicts and provide preliminary office check plans showing the problem locations, posted to the City’s FTP site. Plans will clearly identify specific utility company facilities by color and by name (i.e. not just “gas” or “fiber optic”). ENGINEER shall include a conflict list for each utility, also posted to the FTP site. ENGINEER shall meet with utility company representatives to review plans and utility verification forms (Attachment No. 3 to Exhibit “A”) at each milestone date and as directed by the CITY and as determined necessary by the ENGINEER. This in- formation will be compiled into a summary report (Attachment No. 4 to Exhibit “A” also available on the City’s FTP site) maintained and updated by ENGINEER as necessary to present a cohesive and reflective status of utilities, and provided to the City as necessary. ENGINEER shall maintain involvement with utility companies until all conflicts have been resolved (not just identified). When appropriate, the City Engineer will approve the identification on plans of conflicts to be resolved during construction. ENGINEER shall meet with involved utility company/ies and project contractor to resolve any conflicts with utilities that occur during construction.

  • Donor Coordination Throughout the multi-year development of the Compact, MCC and the Government have engaged in an inclusive process that included consultations with the United States Government, Nepali communities and key private sector actors, non-government actors, and other donors as well as multilateral organizations. In particular, MCC worked closely with the World Bank and the Asian Development Bank in reviewing and agreeing on various power sector reforms required in Nepal for future programming by the two banks. MCC also consulted frequently with the United Kingdom’s Department for International Development (“DFID”) during its preparation of a political economy analysis of power sector reform.

  • General Coordination 5.1.1 Contractor’s Pre-Construction Phase Services team shall attend Project Team meetings with Owner, Owner representatives, and A/E at regularly scheduled intervals throughout the Pre-Construction Phase. Frequent Project Team meetings are anticipated prior to Owner acceptance of the GMP and during completion of the Construction Documents.

  • Professional Development Reimbursement Management will provide reimbursement for approved professional development expenses for Lieutenants and Sergeants. Funds may be used for the purpose of improving job performance, maintaining and increasing proficiency, preparing Lieutenants and Sergeants for greater responsibility, or increasing promotional opportunities. Management must approve of the specific professional development request in advance. Denial will require written notification to the requesting Lieutenant or Sergeant.

  • Design Development Phase Services 3.3.1 Based on the Owner’s approval of the Schematic Design Documents, and on the Owner’s authorization of any adjustments in the Project requirements and the budget for the Cost of the Work, the Architect shall prepare Design Development Documents for the Owner’s approval. The Design Development Documents shall illustrate and describe the development of the approved Schematic Design Documents and shall consist of drawings and other documents including plans, sections, elevations, typical construction details, and diagrammatic layouts of building systems to fix and describe the size and character of the Project as to architectural, structural, mechanical and electrical systems, and other appropriate elements. The Design Development Documents shall also include outline specifications that identify major materials and systems and establish, in general, their quality levels.

  • Services and Utilities Landlord shall furnish all normal services and utilities such as elevator service, lighting replacement for building standard lights, restroom supplies, window washing, janitorial services, heating, ventilation and air conditioning (“HVAC”) maintenance, landscape maintenance, parking lot sweeping, pest control services, and fire alarm monitoring (if installed and required) in a manner that such services are customarily furnished to comparable office buildings in the area. Landlord shall also provide water, sewer, electric, gas and trash removal services to the building as required. Provided that Tenant is not in default hereunder, Landlord agrees to furnish to the Premises at all times , electricity for normal desk top office equipment, .normal copying equipment, technical equipment, and “HVAC” as is reasonably required for the comfortable use and occupancy of the Premises. The normally recognized business hours for the Building are as follows: 7:00 am to 6:00 pm Monday through Friday (except Holidays), and 8:00 am to 1:00 p.m. on Saturdays. If Tenant desires HVAC and/or electricity at any other time, Tenant may override the HVAC and/or electricity system for additional heating, cooling or electricity outside of the normal business hours. Such additional HVAC and/or electricity usage shall be electronically monitored, and Tenant shall pay Landlord’s direct charges therefore on demand. Landlord shall also maintain and keep lighted the common stairs, common entries and restrooms in the Building. Landlord shall not be in default hereunder or be liable for any damages directly or indirectly resulting from, nor shall the Rent be abated by reason of (i) the installation, use or interruption of use of any equipment in connection with the furnishing of any of the foregoing services, (ii) failure to furnish or delay in furnishing any such services where such failure or delay is caused by accident or any condition or event beyond the reasonable control of Landlord, or by the making of necessary repairs or improvements to the Premises, Building or Project, or (iii) the limitation, curtailment or rationing of, or restrictions on, use of water, electricity, gas or any other form of energy serving the Premises, Building or Project, which has been imposed upon the Landlord. Landlord shall not be liable except where Landlord is found to be grossly negligent for a loss of or injury to property or business, however occurring, through or in connection with or incidental to failure to furnish any such services. If Tenant uses heat generating machines or equipment in the Premises which affect the temperature otherwise maintained by the HVAC system, Landlord reserves the right to install supplementary air conditioning units in the Premises and the cost thereof, including the cost of installation, operation and maintenance thereof, shall be paid by Tenant to Landlord upon demand by Landlord. Should Tenant consume water or electric current in excess of that usually furnished or supplied for the use of premises as general office space Landlord may have installed a water meter or electrical current meter in the Premises to measure the amount of water or electric current consumed. The cost of any such meter and its installation, maintenance and repair shall be paid for by the Tenant and Tenant agrees to pay to Landlord promptly upon demand for all such water and electric current consumed as shown by said meters, at the rates charged for such services by the local public utility. If a separate meter is not installed, the excess cost for such water and electric current shall be established by an estimate made by a utility company or an electrical engineer hired jointly by Landlord and Tenant and at Tenant’s expense. Nothing contained in this Section shall restrict Landlord’s right to require at any time separate metering of utilities furnished to the Premises. In the event utilities are separately metered, Tenant shall pay promptly upon demand for all utilities consumed at utility rates charged by the local public utility plus any additional expense incurred by Landlord in keeping account of the utilities so consumed. Tenant shall be responsible for the maintenance and repair of any such meters at its sole cost.

Time is Money Join Law Insider Premium to draft better contracts faster.