Safety Co-operation. The Union and the Employer shall cooperate in continuing and perfecting regulations which will afford adequate protection to employees engaged in hazardous work.
Safety Co-operation Sample Clauses
Related to Safety Co-operation
Co-operation Each Party acknowledges that this ESA must be approved by the Department and agree that they shall use Commercially Reasonable efforts to cooperate in seeking to secure such approval.
Safety Boots Each employee, after 3 months’ continuous service, will be reimbursed (on production of a receipt), the cost of one pair of safety boots (approved by the employer), in each year, to a maximum of $110.00. All protective clothing such as wet weather jackets, safety helmets, welding jackets, welding xxxxxxx, welding gauntlets, rubber boots, etc, (which remain the property of the Company), will be supplied on all occasions deemed necessary.
Safety Footwear 1. The State will provide employees in the positions listed in Section 3 below, and employees who are currently required to wear safety footwear by Department Work Rules, an allowance of one hundred fifty dollars ($150.00) for replacement of safety footwear. This allowance will be paid to employees on a semiannual basis, with half paid in January and half paid in July to eligible employees on the payroll at the time of the payments. Employees of Departments with work rules that provide such safety footwear will not be eligible for the safety footwear allowance. 2. Safety footwear purchased must meet ANSI standards where applicable. Requirements for the wearing of safety footwear will be in accordance with work rules published by the State. 3. Positions required to wear safety footwear:
Joint Occupational Health and Safety Committee The Employer and the Union recognize the role of the joint Occupational Health and Safety Committee in promoting a safe and healthful workplace. The parties agree that a Joint Occupational Health and Safety Committee shall be established for each Employer covered by this Collective Agreement. The Committee shall govern itself in accordance with the provisions of the Industrial Health and Safety Regulations made pursuant to the Workers’ Compensation Act. The Committee shall be as between the Employer and the Union, with equal representation, and with each party appointing its own representatives. Representatives of the Union shall be chosen by the Union membership or appointed by the Union. All minutes of the meetings of the Joint Occupational Health & Safety Committee will be recorded in a mutually agreeable format and will be sent to the Union. The Union further agrees to actively pursue with the other Health Care Unions a Joint Union Committee for the purposes of this Article. The Employer agrees to provide or cause to be provided to Employer members of the Joint Occupational Health and Safety Committee adequate training and orientation to the duties and responsibilities of committee members to allow the incumbents to fulfil those duties competently. The Union agrees to provide or cause to be provided to Union members of the Joint Occupational Health and Safety Committee adequate training and orientation to the duties and responsibilities of committee members to allow the incumbents to fulfil those duties competently. Such training and orientation shall take place within six (6) months of taking office.
Occupational Health and Safety Committee (a) The parties agree that a joint occupational health and safety committee will be established. The Committee shall govern itself in accordance with the provisions of the Occupational Health and Safety Regulations made pursuant to the Workers Compensation Act. The Committee shall be between the Employer and the Union, with equal representation, and with each party appointing its own representatives. The Union agrees to actively pursue with the other Health Care unions, where more than one union is certified with the Employer, a joint union/employer committee for the purposes of the Occupational Health and Safety Regulations. (b) Employees who are members of the Committee shall be granted leave without loss of pay or receive straight-time regular wages while attending meetings of the Joint Committee. Employees who are members of the Committee shall be granted leave without loss of pay or receive straight-time regular wages to participate in joint workplace inspections and joint accident investigations at the request of the Committee pursuant to the WCB Occupational Health and Safety Regulations. Committee meetings, workplace inspections and accident investigations shall be scheduled during normal working hours whenever practicable. (c) The Occupational Health and Safety Committee shall have as part of its mandate the jurisdiction to receive complaints or concerns regarding workload problems which are safety-related, the right to investigate such complaints, the right to define the problem and the right to make recommendations for a solution. Where the Committee determines that a safety-related workload problem exists, it shall inform the Employer. Within 21 days thereafter, the Employer shall advise the Committee what steps it has taken or proposes to take to rectify the safety-related workload problem identified by the Committee. If the Union is not satisfied with the Employer's response, it may refer the matter to the Industry Trouble shooter for a written recommendation. (d) No employee shall be disciplined for refusal to work when excused by the provisions of the
Synchronization, Commissioning and Commercial Operation 4.1.1 The Power Producer shall give at least fifteen (15) days written notice to the SLDC / ALDC / DISCOM as the case may be, of the date on which it intends to synchronize the Power Project to the Grid System. 4.1.2 Subject to Article 4.1.1, the Power Project may be synchronized by the Power Producer to the Grid System when it meets all the connection conditions prescribed in the Grid Code and otherwise meets all other Indian legal requirements for synchronization to the Grid System. 4.1.3 The synchronization equipment and all necessary arrangements / equipment including Remote Terminal Unit (RTU) for scheduling of power generated from the Project and transmission of data to the concerned authority as per applicable regulation shall be installed by the Power Producer at its generation facility of the Power Project at its own cost. The Power Producer shall synchronize its system with the Grid System only after the approval of GETCO / SLDC / ALDC and GEDA. 4.1.4 The Power Producer shall immediately after each synchronization / tripping of generator, inform the sub-station of the Grid System to which the Power Project is electrically connected in accordance with applicable Grid Code. 4.1.5 The Power Producer shall commission the Project within SCOD. 4.1.6 The Power Producer shall be required to obtain Developer and/ or Transfer Permission, Key Plan drawing etc, if required, from GEDA. In cases of conversion of land from Agricultural to Non-Agriculture, the commissioning shall be taken up by GEDA only upon submission of N.A. permission by the Power Producer. 4.1.7 The Power Producer shall be required to follow the Forecasting and Scheduling procedures as per the Regulations issued by Hon’ble GERC from time to time. It is to clarify that in terms of GERC (Forecasting, Scheduling, Deviation Settlement and Related Matters of Solar and Wind Generation Sources) Regulations, 2019 the procedures for Forecasting, Scheduling & Deviation Settlment are applicable to all solar generators having combined installed capacity above 1 MW connected to the State Grid / Substation including those connected via pooling stations.
Safe Operations Notwithstanding any other provision of this Agreement, an NTO may take, or cause to be taken, such action with respect to the operation of its facilities as it deems necessary to maintain Safe Operations. To ensure Safe Operations, the local operating rules of the ITO(s) shall govern the connection and disconnection of generation with NTO transmission facilities. Safe Operations include the application and enforcement of rules, procedures and protocols that are intended to ensure the safety of personnel operating or performing work or tests on transmission facilities.
SAFETY & HEALTH A. Employees covered by this Agreement who are uniformly and periodically required by the Company to take physical examinations because of the duties they perform shall be scheduled and paid for the time spent taking such examinations in accordance with the Company's established procedures for employees under this Agreement. The Company will schedule the exam in a way that is not unduly burdensome to the employee or the Company. The provisions of this Paragraph shall not apply to employees required to take physical examinations after absence due to illness or any physical examinations other than those specified above. B. The Company hereby agrees to maintain safe, sanitary and healthful working conditions in all shops and facilities and to maintain on all shifts emergency first aid equipment at a first aid station to take care of its employees in case of accident or illness, and that sufficient employees will be given initial and recurrent first aid / CPR training. It is understood that this does not require the Company to maintain a nurse or doctor on the property, but in an emergency the Company will utilize the appropriate emergency services. C. The Company agrees to furnish good drinking water and sanitary fountains; the floors of the toilets and washrooms will be kept in good repair and in a clean, dry, sanitary condition. Employees will cooperate in maintaining the foregoing conditions Shops and washrooms will be lighted and heated in the best manner possible consistent with the source of heat and light available. Individual lockers will be provided for all employees where space and lockers are available. Every effort will be made as early as possible to provide space and lockers for all employees. D. The Company, Union, and employees will cooperate toward the prevention of accidents and the furtherance of an aggressive safety program. A joint Company- E. The Company shall furnish all necessary safety devices for employees working on hazardous or unsanitary work, and employees will be required to use or wear such devices in performing such work. F. The Company will furnish appropriate aprons, gloves and shoes to all employees required to work with acids and chemicals that are injurious to clothing while such employees are engaged in such activities, and employees will be required to wear such equipment. G. Employees taken sick or injured while at work, shall be given medical attention as promptly as reasonably practicable. Employees will not be refused permission to return to work because they have not signed releases of liability pending the disposition or settlement of any claims which they may have for compensation arising out of such sickness or injury. H. In cases of occupational injury or illness employees may elect to be treated by their personal physician, and decline treatment from others, provided they have their physician registered with United's medical department prior to the occurrence of illness or injury. The Company's physician will retain the right to monitor the employee's course of treatment. I. United will maintain a Bloodborne Pathogen Exposure Control Plan which satisfies the requirements of the OSHA Bloodborne Pathogen regulations. Corporate Safety agrees to consider any proposed changes to the Plan that may be suggested by the Union in an effort to improve the safety of employees in their work environment and to solicit comments from the Union whenever routine revisions are made to the Plan. The Company agrees to make available, at no cost to covered employees, complete post- exposure evaluation including necessary blood work and medications. J. The Flight Safety Committee shall function as described in Letter of Agreement #21. K. In the event the IBT and the Company jointly petition the National Transportation Safety Board (NTSB) for, and are granted, formal party or observer status in connection with an investigation involving a Company incident or accident, the Company and the IBT will L. Any MSAP program will be covered in a stand alone MOU between the Company, the Union and the FAA. While there is a valid MOU the Company will sponsor 1 full-time, IBT representative to participate on the ERC scheduled Mon-Fri, on traditional business hours. This position will in all respects be treated in a similar manner regarding necessary transportation as other IBT staff positions. The Company agrees to supply access to office space appropriate for the confidentiality needs of the position and access to office supplies. M. In the event the Company requires employees covered by this Agreement to wear protective footwear as personal protective equipment, the Company will provide an allowance to such employees for the actual cost of protective footwear that complies with Company standards. Such allowance shall be up to a maximum of $52.80 per year per employee on a rolling calendar basis.
Safety Compliance Comply with Site safety programs, as they apply to RPR, and if required to do so by such safety programs, receive safety training specifically related to RPR’s own personal safety while at the Site.
System Operation The Parties shall adhere to any applicable operational requirements of PJM necessary to protect the integrity of the transmission system within the PJM Control Area and the transmission systems of interconnected control areas, and shall satisfy any and all PJM, RFC and NERC criteria, when applicable. The DS Supplier shall also adhere to any applicable operational requirements of the Company necessary to protect the integrity of the Company’s local distribution system.
