Service Flash Hot Water Sample Clauses

Service Flash Hot Water. Heater Check for any deposits and clean them from the system. Inspect pilot light and gas system to ensure it is functioning properly and safely. Check the pipes for fumes. Verify there are separate temperature and pressure relief valves (PRV and TRV) or combination temperature and pressure relief valves (TPRV) installed. Verify that TPRV drain piping is installed to direct discharge to floor. Verify that TPRV drain piping is not reduced, threaded at the end and has no uphill runs. Verify that TPRV drain piping has no other valve downstream of TPRV. Ensure that exhaust gases are vented outdoors away from intakes and windows. Ensure there is an adequate combustion air ducted to unit or an unobstructed area large enough to provide adequate combustion air. Ensure that small mechanical areas have sufficient combustion air and ventilation openings. Ensure there is no hazardous or flammable vapor sources near combustion equipment. Check that there are warning labels present in both English and Italian. If there is no warning label, one will be provided by the COR. Check that there is adequate clearance from the exhaust flue and equipment to the combustion materials. Check that all gas service is supplied through rigid pipe (iron or steel) or tubing (steel, brass or copper). Ensure there is a manual shut-off valve on gas service pipes within 1.8 m (6 ft) of appliance. Set the thermostat to 49° C. Ensure that the system complies to all local codes. Perform first echelon maintenance. Report to COR any malfunctions or deficiencies.
Sample 1
AutoNDA by SimpleDocs

Related to Service Flash Hot Water

  • Network Resource Interconnection Service (check if selected)

  • Electrical Service Electrical service for new construction or a renovated existing building shall be 480/277-volt, 3-phase, 4-wire or approved equal. Service shall be sized for HVAC and other mechanical system(s) loads, lighting, general building services, and dedicated computer based office equipment loads. 5 xxxxx per square foot shall be provided for lighting and general service receptacles. Size of neutral conductor of 3- phase circuits shall be twice that of phase conductor to accommodate potential harmonic currents associated with computer system electronic power supplies and fluorescent lighting fixtures electronic ballasts. An adequately sized 3 phase “wye” wound step down transformer shall be provided to supply 208/120-volt, 3 phase power, for lighting, general service receptacles and dedicated computer based office equipment. Dedicated, isolated ground circuits shall be supplied from separate isolated ground power distribution panel(s). Lighting circuits shall be supplied from separate lighting panel(s). Panels shall have 20% spare capacity and be complete with 10% spare breakers of each size, but no less than 1 spare. No more than 4 duplex receptacles shall be connected to any single 20-amp dedicated isolated ground circuit or general service circuit.

  • PROPANE GAS SYSTEM SERVICE AREA If the Property is located in a propane gas system service area owned by a distribution system retailer, Seller must give Buyer written notice as required by §141.010, Texas Utilities Code. An addendum containing the notice approved by TREC or required by the parties should be used.

  • PIPELINE SERVICE FUND The Employer shall deduct from each employee covered by this Agreement twenty-five cents ($0.25) for each hour of work earned and remit it monthly to the Pipeline Service Fund.

  • Energy Resource Interconnection Service (ER Interconnection Service).

  • Network Interconnection Architecture Each Party will plan, design, construct and maintain the facilities within their respective systems as are necessary and proper for the provision of traffic covered by this Agreement. These facilities include but are not limited to, a sufficient number of trunks to the point of interconnection with the tandem company, and sufficient interoffice and interexchange facilities and trunks between its own central offices to adequately handle traffic between all central offices within the service areas at P.01 grade of service or better. The provisioning and engineering of such services and facilities will comply with generally accepted industry methods and practices, and will observe the rules and regulations of the lawfully established tariffs applicable to the services provided.

  • Interconnection Customer Provided Services The services provided by Interconnection Customer under this LGIA are set forth in Article 9.6 and Article 13.5.1. Interconnection Customer shall be paid for such services in accordance with Article 11.6.

  • Interconnection Service Interconnection Service allows the Interconnection Customer to connect the Large Generating Facility to the Participating TO’s Transmission System and be eligible to deliver the Large Generating Facility’s output using the available capacity of the CAISO Controlled Grid. To the extent the Interconnection Customer wants to receive Interconnection Service, the Participating TO shall construct facilities identified in Appendices A and C that the Participating TO is responsible to construct. Interconnection Service does not necessarily provide the Interconnection Customer with the capability to physically deliver the output of its Large Generating Facility to any particular load on the CAISO Controlled Grid without incurring congestion costs. In the event of transmission constraints on the CAISO Controlled Grid, the Interconnection Customer's Large Generating Facility shall be subject to the applicable congestion management procedures in the CAISO Tariff in the same manner as all other resources.

  • Configuration Management The Contractor shall maintain a configuration management program, which shall provide for the administrative and functional systems necessary for configuration identification, control, status accounting and reporting, to ensure configuration identity with the UCEU and associated cables produced by the Contractor. The Contractor shall maintain a Contractor approved Configuration Management Plan that complies with ANSI/EIA-649 2011. Notwithstanding ANSI/EIA-649 2011, the Contractor’s configuration management program shall comply with the VLS Configuration Management Plans, TL130-AD-PLN-010-VLS, and shall comply with the following:

  • Infertility Services This plan covers the following services, in accordance with R.I. General Law §27-20-20. • Services for the diagnosis and treatment of infertility if you are:

Time is Money Join Law Insider Premium to draft better contracts faster.