Training and Shared Learning Activities
Training and Shared Learning Activities Sample Clauses
Related to Training and Shared Learning Activities
Training and Professional Development 11.1 The Employer will develop and maintain an employee training and development plan and provide such plan to the Union upon request. Staff training is intended to provide an opportunity for classified staff employees for training sponsored by the University Training and Development and the UW Medical Centers Organizational Development and Training. Education/Professional Leave is intended to facilitate employee access to continuing education opportunities. Training and educational/professional leave may be used for the purpose of improving job performance, maintaining and increasing proficiency, preparing staff for greater responsibility, or increasing promotional opportunities within the framework of staff positions available at the University. 11.2 Any release time for training for employees accepted for such classes shall be in accordance with the Executive Order (currently No. 52) governing this matter. In the event that two or more employees request the same training period and supervision must limit the number of persons who may participate at one time due to work requirements, the selection will be made on a mutually agreeable basis within the department. 11.3 The training program is a proper subject for discussion by either departmental or University-wide Joint Union/Management Committees. 11.4 If the Employer requires an employee to receive training, reimbursement will be provided in accordance with the University travel rules. Employee attendance at Employer required training, either during or outside working hours, will be considered time worked and compensated in accordance with the provisions of this Agreement. 11.5 Employee attendance at training not required by the Employer and not covered by Executive Order 52, either on approved leave from or outside of working hours, will be voluntary and not considered time worked.
Training and Orientation (a) No employee shall be required to work on any job or operate any piece of equipment until he/she has received proper training and instruction. (b) The Employer shall provide sufficient and adequate training and/or orientation to any employee working in a new or unfamiliar work area or position.
Training and Promotion a. The contractor will assist in locating, qualifying, and increasing the skills of minorities and women who are applicants for employment or current employees. Such efforts should be aimed at developing full journey level status employees in the type of trade or job classification involved. b. Consistent with the contractor's work force requirements and as permissible under Federal and State regulations, the contractor shall make full use of training programs, i.e., apprenticeship, and on-the-job training programs for the geographical area of contract performance. In the event a special provision for training is provided under this contract, this subparagraph will be superseded as indicated in the special provision. The contracting agency may reserve training positions for persons who receive welfare assistance in accordance with 23 U.S.C. 140(a). c. The contractor will advise employees and applicants for employment of available training programs and entrance requirements for each. d. The contractor will periodically review the training and promotion potential of employees who are minorities and women and will encourage eligible employees to apply for such training and promotion.
Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.
Union Activities If the Contract Amount is $50,000 or more, no Judicial Council funds received under this Agreement will be used to assist, promote or deter union organizing during the term of this Agreement (including any extension or renewal term).
TRAINING AND EMPLOYEE DEVELOPMENT 9.1 The Employer and the Union recognize the value and benefit of education and training designed to enhance an employee’s ability to perform their job duties. Training and employee development opportunities will be provided to employees in accordance with Employer policies and available resources. 9.2 Attendance at employer-required training will be considered time worked. The Employer will make reasonable attempts to schedule employer-required training during an employee’s regular work shift. The Employer will pay the registration and associated travel costs in accordance with Article 23, Travel, for employer-required training.
Transition Planning The AGENCY will be responsible for the development of the student’s Transition Plan, which begins upon entry and is completed prior to the student’s exit.
Regulatory Activities Beginning on the Effective Date and to the extent UGNX remains the Lead Development Party with respect to a particular territory, subject to and in accordance with the terms and conditions of this Agreement and the requirements of Applicable Laws, UGNX, shall: (a) use Commercially Reasonable Efforts to file (or have filed) all Regulatory Filings with respect to the Licensed Products in the Field in order to obtain Marketing Approvals in each country in the Territory and the European Territory (or to obtain the European Centralized Approval in the European Core Territory) and in order to obtain Pricing and/or Reimbursement Approvals in the Profit Share Territory; (b) respond in a timely fashion to requests for data and information from Regulatory Authorities with respect to the Licensed Products in the Field in the Territory and the European Territory; and (c) meet with officials of the Regulatory Authorities at such times as may be requested by such Regulatory Authorities with respect to the Core Development Activities (“Regulatory Activities”), provided that KHK will have primary responsibility for obtaining, and UGNX shall provide all assistance reasonably requested by KHK, in relation to Pricing and/or Reimbursement Approvals for the Licensed Products in the Field in the European Territory. For the avoidance of doubt, UGNX will be responsible for obtaining, and KHK will provide all assistance reasonably requested by UGNX, in relation to Pricing and/or Reimbursement Approvals, if any, for the Licensed Products in the Field in the Profit Share Territory as part of the UGNX Core Development Activities, it being understood that the costs incurred by UGNX in connection with such activities will be shared equally (50/50). All such Regulatory Activities will be conducted in a manner consistent with the Core Development Plan and coordinated by the JSC in accordance with Article 3. Without limiting the applicability of the foregoing and the remainder of this Article 5, UGNX shall interface with the applicable Regulatory Authority(ies) and, through the JDC, shall keep KHK reasonably informed of all material events and developments occurring in the course of the Regulatory Activities, including scheduled UGNX regulatory strategy discussions and meetings with Regulatory Authorities in the Territory and the European Territory relating to the Licensed Products in the Field.
Time Off for Union Activities The employer agrees to grant the necessary time off, without discrimination or loss of seniority rights and without pay, to any employee designated by the Union to attend a labor convention provided that there is two-week notice of any union convention. Due consideration shall be given to the number of personnel affected in order that there shall be no disruptions of employer's operations due to lack of available employees.
Training Program It is agreed that there shall be an Apprenticeship Training Program, the provisions of which are set forth in Exhibit "D", which is attached hereto and forms part of this Agreement.
