Check Meters Developer, at its option and expense, may install and operate, on its premises and on its side of the Point of Interconnection, one or more check meters to check Connecting Transmission Owner’s meters. Such check meters shall be for check purposes only and shall not be used for the measurement of power flows for purposes of this Agreement, except as provided in Article 7.4 below. The check meters shall be subject at all reasonable times to inspection and examination by Connecting Transmission Owner or its designee. The installation, operation and maintenance thereof shall be performed entirely by Developer in accordance with Good Utility Practice.
Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.
Transit Traffic 7.2.2.3.1 CenturyLink will accept traffic originated by CLEC’s network and/or its end user(s) for termination to other Telecommunications Carrier’s network and/or its end users that is connected to CenturyLink's Switch. CenturyLink will also terminate traffic from these other Telecommunications Carriers’ network and/or its end users to CLEC’s network and/or its end users. For purposes of the Agreement, transit traffic does not include traffic carried by Interexchange Carriers. That traffic is defined as Jointly Provided Switched Access.
7.2.2.3.2 The Parties involved in transporting transit traffic will deliver calls to each involved network with CCS/SS7 protocol and the appropriate ISUP/TCAP messages to facilitate full Interoperability and Billing functions.
7.2.2.3.3 The originating company is responsible for payment of appropriate rates to the transit company and to the terminating company. The Parties agree to enter into traffic exchange agreements with third party Telecommunications Carriers prior to delivering traffic to be transited to third party Telecommunications Carriers. In the event one Party originates traffic that transits the second Party’s network to reach a third party Telecommunications Carrier with whom the originating Party does not have a traffic exchange agreement, then the originating Party will indemnify, defend and hold harmless the second Party against any and all charges levied by such third party Telecommunications Carrier, including any termination charges related to such traffic and any attorneys fees and expenses. In the case of IntraLATA LEC Toll traffic where CenturyLink is the designated IntraLATA Toll provider for existing LECs, CenturyLink will be responsible for payment of appropriate usage rates.
7.2.2.3.4 When CenturyLink receives an unqueried call from CLEC to a telephone number that has been ported to another local services provider, the transit rate will apply in addition to any query rates.
7.2.2.3.5 In the case of a transit call that terminates in the Local Calling Area but in a different state than the call originated, and the CLEC does not have an agreement with CenturyLink in the state where the transit call terminated, CLEC must execute an agreement for that state if it is a state served by CenturyLink. In the absence of a second agreement, the transit rate in Exhibit A of this Agreement will be billed to the CLEC.
Vessels (A) All of the vessels described in the Registration Statement, the General Disclosure Package and the Prospectus, except for the Contracted Vessels (each of which a Subsidiary has contracted to acquire), are owned directly by Subsidiaries); each of the vessels listed on Schedule F-1 (the “Owned Vessels”) hereto has been duly registered as a vessel under the laws and regulations and flag of the jurisdiction set forth opposite its name on Schedule F-1 in the sole ownership of the Subsidiary set forth opposite its name on Schedule F-1 and no other action is necessary to establish and perfect such entity’s title to and interest in such vessel as against any charterer or third party; each such Subsidiary has good title to the applicable Owned Vessel, free and clear of all mortgages, pledges, liens, security interests and claims and all defects of the title of record except for those liens arising under Credit Facilities, each as disclosed in the Registration Statement, the General Disclosure Package and the Prospectus, and such other encumbrances which would not, in the aggregate, result in a Material Adverse Effect; and each such Owned Vessel is in good standing with respect to the payment of past and current taxes, fees and other amounts payable under the laws of the jurisdiction where it is registered as would affect its registry with the ship registry of such jurisdiction except for failures to be in good standing which would not, in the aggregate, result in a Material Adverse Effect. Upon delivery to and acceptance by the relevant Subsidiary under the MoAs and the Newbuilding Contracts described in the Registration Statement, General Disclosure Package and Prospectus, each of the vessels listed on Schedule F-2 hereto and specified as being under contract (the “Contracted Vessels”) for delivery to and acceptance by a Subsidiary will be duly registered as a vessel under the laws of the jurisdiction set forth opposite its name on Schedule F-2, or under the laws of a generally accepted shipping industry flag jurisdiction, in the sole ownership of the Subsidiary set forth opposite its name on Schedule F-2, on such date, each such Subsidiary will have good title to the applicable Contracted Vessel, free and clear of all mortgages, pledges, liens, security interests, claims and all defects of the title of record, except for any mortgages, pledges, liens, security interests or claims arising from any financing arrangement which the Company or Subsidiary may enter to finance the acquisition of the Contracted Vessel and except such encumbrances which would not, in the aggregate, result in a Material Adverse Effect; and each such Contracted Vessel will be in good standing with respect to the payment of past and current taxes, fees and other amounts payable under the laws of the jurisdiction where it is registered as would affect its registry with the ship registry of such jurisdiction.
(B) Each Owned Vessel is, and the Company will use reasonable commercial efforts to ensure that each Contracted Vessel will be, operated in compliance with the rules, codes of practice, conventions, protocols, guidelines or similar requirements or restrictions imposed, published or promulgated by any Governmental Authority, classification society or insurer applicable to the respective vessel (collectively, “Maritime Guidelines”) and all applicable international, national, state and local conventions, laws, regulations, orders, Governmental Licenses and other requirements (including, without limitation, all Environmental Laws), except where such failure to be in compliance would not have, individually or in the aggregate, a Material Adverse Effect. The Company and each applicable Subsidiary are, and with respect to the Contracted Vessels will be, qualified to own or lease, as the case may be, and operate such vessels under all applicable international, national, state and local conventions, laws, regulations, orders, Governmental Licenses and other requirements (including, without limitation, all Environmental Laws) and Maritime Guidelines, including the laws, regulations and orders of each such vessel’s flag state, except where such failure to be so qualified would not have, individually or in the aggregate, a Material Adverse Effect.
(C) Each Owned Vessel is, and each Contracted Vessel will be, classed by any of Lloyd’s Register of Shipping, American Bureau of Shipping, Det Norske Veritas or a classification society which is a full member of the International Association of Classification Societies and each Owned Vessel is, and the Company will use reasonable commercial efforts to ensure each Contracted Vessel will be, in class with valid class and trading certificates, without any overdue recommendations.
Welding Welding and use of cutting torches or cutoff saws will be permitted only in areas that have been cleared or are free of all material capable of carrying fire. Flammable debris and vegetation must be removed from within a minimum 10-foot radius of all welding and cutting operations. A shovel and a 5-gallon standard backpack water container filled and with handpump attached shall be immediately available for use in the event of a fire start. C8.64 – DEBARMENT AND SUSPENSION CERTIFICATION (3/18). Pursuant to 2 CFR 180 and 2 CFR 417, Purchaser shall certify and obtain certifications from its Subcontractors regarding debarment, suspension, ineligibility, and voluntary exclusion, including additional Subcontractors obtained after award of this contract. “Subcontractors” are participants in lower tier covered transactions. Purchaser may rely upon a certification of a prospective Subcontractor that it is not proposed for debarment under 48 CFR 9.4, debarred, suspended, ineligible, or voluntarily excluded from participating in covered transactions or timber sales, unless Purchaser knows that the certification is erroneous. Purchaser shall keep the certifications of its Subcontractors on file until timber sale Termination Date and any extensions thereof, and will provide a copy at the written request of Contracting Officer. Nothing contained in the foregoing shall be construed to require establishment of a system of records in order to render in good faith the certification required by this Subsection. The knowledge and information of Purchaser is not required to exceed that which is normally possessed by a prudent person in the ordinary course of business dealings. If Purchaser knowingly enters into a timber sale transaction with a person who is proposed for debarment under 48 CFR 9.4, suspended, debarred, ineligible, or voluntarily excluded from participation in covered transactions or timber sales, in addition to other remedies available to the Government, Forest Service may pursue available remedies, including suspension and/or debarment. Contracting Officer shall provide a copy of Forms AD-1047 Certification Regarding Debarment, Suspension and Other Responsibility Matters – Primary Covered Transactions and AD-1048 Certification Regarding Debarment, Suspension, Ineligibility and Voluntary Exclusion – Lower Tier Covered Transactions to the Purchaser. Purchaser shall complete form AD-1047 and provide to the Contracting Officer upon request. Purchaser shall require each subcontractor to complete form AD-1048 and provide to the Contracting Officer upon request.
Scaling “Scaling,” as used herein, involves:
Meters (a) You must allow safe and unhindered access to your premises for the purposes of reading and maintaining the meters (where relevant).
(b) We will use our best endeavours to ensure that a meter reading is carried out as frequently as is needed to prepare your bills, consistently with the metering rules and in any event at least once every 12 months.
Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning):
1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises.
2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated.
3. If capacity exists, provide "side-door" porting through the switch.
4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch).
2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases.
2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.
Fabrication Making up data or results and recording or reporting them.
Speed The relative importance we attach is “high”.
