Extra Duties The Trustee shall be entitled to refuse to approve any Substituted Obligor if, pursuant to the law of the jurisdiction of incorporation of the Substituted Obligor, the assumption by the Substituted Obligor of its obligations hereunder imposes responsibilities on the Trustee over and above those which have been assumed under this Trust Deed.
Typical Duties Measures distance points from reference points and marks guidelines on working surface to lay out work. • Determines vertical and horizontal alignment of courses using xxxxx xxx, gauge line (tightly stretched cord) and level. • Spreads soft layer of mortar that serves as base and binder for brick or block using trowel. • Breaks or cut bricks or blocks to size, using power or hand tools. • Shapes stone preparatory to setting, using a chisel hammer and other shaping tools. • Applies mortar to end of brick or block and positions same in mortar bed. • Spreads mortar over stone and foundation with trowel and sets stone in place by hand or with aid of a crane. • Removes excess mortar from face using trowel. • Taps brick or block with trowel to level, align and embed in mortar, allowing for specified thickness of joint. • Aligns stone with plumb line and finishes joints between stone with a pointing trowel. • Fastens brick, block, or terra cotta veneer to face of buildings or structures with appropriate ties embedded in mortar between units or in anchor holes in units. • Grouts, insulates, and places all reinforcing rods, anchors, and flashing in masonry walls. • Lays refractory brick, block, and insulation in place by spreading, dipping, or spraying materials to build furnaces, line boilers or like fire resistant structures. • Finishes mortar between brick and block with pointing tool or trowel. • Points, cleans, caulks and waterproofs masonry. • Cleans excess mortar or grout from surface of stone using sponge, brush, water, or acid. Brick Trowel, Pointing trowel, Brick Hammer, 2’’& 4’’ Levels, Standard Square, Speed Square, Sliding T Bevel, Braided Masonry Line, Line pins & Line Blocks, Standard Tape Measure, Brick Spacing & Modular tapes, Gauge Rod, Tuck Pointers. APPENDIX A CLASSIFICATIONS, WAGES & BENEFITS UNION BASE RATE CREDIT UNION PROVISION (See Note b) PENSION FUND HEALTH & WELFARE APPREN- TICESHIP FUND ANNUITY (See Note b) CARPENTERS (Effective (06/01/2023 – 05/31/2024) Group I $ 36.55 (a) $ 2.40 $ 5.66 $ 8.00 $ 0.78 $ 0.50 Group II $ 36.98 (a) $ 2.40 $ 5.66 $ 8.00 $ 0.78 $ 0.50 Group III $ 37.22 (a) $ 2.40 $ 5.66 $ 8.00 $ 0.78 $ 0.50 General Xxxxxxx: To be negotiated between the GF and the Company but will be at a rate no less than 12% per hour over the Journeyman scale of the classification under his/her supervision.
Fas Duties As Administrator, and subject to the supervision and control of the Investment Company’s Board of Trustees/Directors (the “Board”), FAS will provide facilities, equipment, and personnel to perform or cause to be performed the following “Administrative Services” for operation of the business and affairs of the Investment Company and each of its Funds and any additional Administrative Services that FAS shall agree in writing to perform, or cause to be performed, for the Investment Company from time to time:
Certain Duties and Responsibilities The duties and responsibilities of the Trustee shall be as provided by the Trust Indenture Act. Notwithstanding the foregoing, no provision of this Indenture shall require the Trustee to expend or risk its own funds or otherwise incur any financial liability in the performance of any of its duties hereunder, or in the exercise of any of its rights or powers, if it shall have reasonable grounds for believing that repayment of such funds or adequate indemnity against such risk or liability is not reasonably assured to it. Whether or not therein expressly so provided, every provision of this Indenture relating to the conduct or affecting the liability of or affording protection to the Trustee shall be subject to the provisions of this Section.
Basic Duties 1. For each product the basic duty, to which the successive reductions set out in this Agreement are to be applied, shall be the most-favoured-nation rate of duty (MFN rate) applied on 1 January 2000.
2. If, before, by or after entry into force of this Agreement, any tariff reduction is applied on an erga omnes basis, in particular reductions in accordance with commitments resulting from multilateral negotiations under the WTO, such reduced duties shall replace the basic duties referred to in paragraph 1 as from the date when such reductions are applied, or from the entry into force of this Agreement if this is later.
3. The reduced duties calculated in accordance with Article 4(2) (Customs duties on imports and charges having equivalent effect) shall be applied rounded to the first decimal place or, in case of specific duties, to the second decimal place.
General Duties and Responsibilities 1. Responsibilities under the General Conditions of the Contract for Construction: In addition to the responsibilities herein set forth, Consulting Engineer/Architect agrees to be responsible for those matters identified in the General Conditions as being responsibilities of the Consulting Engineer/Architect. Consulting Engineer/Architect specifically acknowledges receipt of a copy of the General Conditions and acceptance of the responsibilities as set forth therein.
Job Duties It is understood by the parties that every incidental duty connected with operations enumerated in job descriptions is not always specifically described and employees may be required to perform other job-related duties not specifically contained in the job description; however, employees required to perform such duties shall be qualified for the work to be performed.
Customs Duties (1) Aircraft operated in international air services by the designated airlines of one Contracting Party, their regular equipment, fuel, lubricants, consumable technical supplies, spare parts including engines, and aircraft stores (including but not limited to such items as food, beverages and tobacco) which are on board such aircraft shall be exempted by the other Contracting Party on the basis of reciprocity from all customs duties, excise taxes and similar fees and charges not based on the cost of services provided on arrival, provided such regular equipment and such other items remain on board the aircraft.
(2) Regular equipment, fuel, lubricants, consumable technical supplies, spare parts including engines, aircraft stores (including but not limited to such items as food, beverages and tobacco), printed ticket stock, air waybills, any printed material which bears insignia of a designated airline of one Contracting Party and usual publicity material distributed without charge by that designated airline, introduced into the area of the other Contracting Party by or on behalf of that designated airline or taken on board the aircraft operated by that designated airline, shall be exempted by the other Contracting Party on the basis of reciprocity from all customs duties, excise taxes and similar fees and charges not based on the cost of services provided on arrival, even when such regular equipment and such other items are to be used on any part of a journey performed over the area of the other Contracting Party.
(3) The regular equipment and the other items referred to in paragraphs (1) and (2) of this Article may be required to be kept under the supervision or control of the customs authorities of the other Contracting Party.
(4) The regular equipment and the other items referred to in paragraph (1) of this Article may be unloaded in the area of the other Contracting Party with the approval of the customs authorities of that other Contracting Party. In these circumstances, such regular equipment and such items shall enjoy, on the basis of reciprocity, the exemptions provided for by paragraph (1) of this Article until they are re-exported or otherwise disposed of in accordance with customs regulations. The customs authorities of that other Contracting Party may however require that such regular equipment and such items be placed under their supervision up to such time.
(5) The exemptions provided for by this Article shall also be available in situations where a designated airline of one Contracting Party has entered into arrangements with another airline or airlines for the loan or transfer in the area of the other Contracting Party of the regular equipment and the other items referred to in paragraphs (1) and (2) of this Article, provided that that other airline or airlines similarly enjoy such exemptions from that other Contracting Party.
(6) Baggage and cargo in direct transit across the area of a Contracting Party shall be exempt from customs duties, excise taxes and similar fees and charges not based on the cost of services provided on arrival.
Position, Duties and Responsibilities During the Term (as defined in Section 2.01 below), Executive shall serve as Chief Financial Officer of Company as well as in such other positions or capacities as may be reasonably requested by the Board of Directors of Company (the “Board”) or the Chief Executive Officer of Company (the “CEO”) and shall have such duties and responsibilities as are customary for, and are consistent with, such position(s) as may, from time to time, be assigned by the Board, the CEO and/or any of their respective nominees. Executive’s employment by Company shall be full-time and exclusive to Company and Executive shall (a) report to Company’s CEO, (b) comply with Company’s policies and procedures in place from time to time, and (c) serve Company faithfully and to the best of Executive’s ability. During the Term, and except for paid time off in accordance with the terms of Section 3.01(G) below or absences due to illness or incapacity, Executive shall devote all of Executive’s business time, attention, skill and efforts exclusively to the business and affairs of Company (including its affiliates) and the promotion of its interests. Notwithstanding anything contained herein to the contrary, Executive may do the following, provided that such activities do not inhibit or prohibit the performance of Executive’s duties hereunder or inhibit or conflict with the business of Company and/or its affiliates: (i) engage in charitable, educational, religious, civic and similar types of activities and manage Executive’s personal investments, and (ii) with consent of the Board which shall not be unreasonably withheld, serve on the board of directors, managers, advisors (or their equivalent) of outside business enterprises for up to 30 hours in the aggregate per calendar quarter (including but not limited to AngelMed, GenPro, and eNeura). Executive shall be required to spend on average eight days per month at the Company’s corporate offices in either Florida or Israel including travel. Executive acknowledges that he shall be required to travel as reasonably necessary to perform Executive’s duties hereunder, including international travel.
Higher Duties 29.1 Where an Employee on any one day performs two or more classes of work to which different rates of pay are applicable, the Employer shall pay to the Employee the higher hourly rate for the entire day if the Employee is required to work in that class of work for more than 2 hours, and if for less than 2 hours during any one day the Employee will be paid the higher rate for the time so worked.
