Where AT& Sample Clauses

Where AT&. T utilizes portions of the BellSouth network in originating or terminating traffic, the Tandem Switching rates are applied in call scenarios where the Tandem Switching Network Element has been utilized. Because switch recordings cannot accurately indicate on a per call basis when the Tandem Switching Network Element has been utilized for a BellSouth transported interoffice call originating from a UNE port and terminating to a BellSouth, Independent Company or Facility-Based CLEC office, BellSouth has developed, based upon trunk studies, a melded rate that takes into account the average percentage of calls that utilize Tandem Switching in these scenarios. BellSouth shall apply the melded Tandem Switching rate for every call in these scenarios. The melded Tandem Switching charge shall be displayed on BellSouth’s standard UNE bill in the Unbundled Transport Tandem Switching and Trunk Port section under Undetermined Routing – Originating for both Local and Access. BellSouth shall utilize the melded Tandem Switching Rate until BellSouth has the capability to measure actual Tandem Switch usage in each call scenario specifically mentioned above, at which point the rate for the actual Tandem Switch usage shall apply. The UNE Call Flows set forth on BellSouth's website, as of the effective date of this amendment illustrate when the full or melded Tandem Switching rates apply for specific UNE-P call scenarios.
Sample 1Sample 2
AutoNDA by SimpleDocs
Where AT&. T KENTUCKY manages the E911 Database, AT&T KENTUCKY shall provide an initial MSAG load and updates to INdigital telecom for use in submitting MSAG valid End User record information to AT&T KENTUCKY’s DBMS for those E911 Selective Routers that INdigital telecom has End Users. INdigital telecom shall be responsible for accepting and maintaining the updates from AT&T KENTUCKY. AT&T KENTUCKY will make updates available as frequently as the state’s system currently provides.
Sample 1

Related to Where AT&

  • Check Meters Developer, at its option and expense, may install and operate, on its premises and on its side of the Point of Interconnection, one or more check meters to check Connecting Transmission Owner’s meters. Such check meters shall be for check purposes only and shall not be used for the measurement of power flows for purposes of this Agreement, except as provided in Article 7.4 below. The check meters shall be subject at all reasonable times to inspection and examination by Connecting Transmission Owner or its designee. The installation, operation and maintenance thereof shall be performed entirely by Developer in accordance with Good Utility Practice.

  • Surveys Each Borrower shall submit the Ship owned by it regularly to all periodical or other surveys which may be required for classification purposes and, if so required by the Security Trustee provide the Security Trustee, with copies of all survey reports.

  • CHECK-OFF OF DUES It is the desire of the Union and the Employer to eliminate possible friction by the following arrangement:

  • Physical Exams The Employer agrees to provide without cost to employees, physical examinations and/or other appropriate tests when such tests are deemed necessary by management to determine whether the health of employees is being or has been adversely affected by exposure to potentially harmful physical agents, toxic materials, or infectious agents, or by attacks and assaults. The Employer agrees to provide to each affected employee who requests it a complete and accurate written report of any such medical examination or other appropriate tests related to occupational exposure. Additionally, written results of an industrial hygiene measurements or investigations related to an employee's occupational exposure will also be provided, upon request, to the employee or the employee's authorized representative. The Union and/or members of the applicable Health and Safety Committee will be provided copies of summary reports, but such reports will not contain personally identifying information.

  • Site Lands or areas indicated in the Contract Documents as being furnished by the Owner upon which the Work is to be performed, including rights-of-way and easements for access thereto, and such other lands furnished by the Owner that are designated for the use of the Contractor. Also referred to as Project Site, Job Site and Premises.

  • – OWNERSHIP OF THE RESULTS - INTELLECTUAL AND INDUSTRIAL PROPERTY Any results or rights thereon, including copyright and other intellectual or industrial property rights, obtained in performance of the Contract, shall be owned solely by the Community, which may use, publish, assign or transfer them as it sees fit, without geographical or other limitation, except where industrial or intellectual property rights exist prior to the Contract being entered into.

  • Risk Assessments a. Risk Assessment - Transfer Agent shall, at least annually, perform risk assessments that are designed to identify material threats (both internal and external) against Fund Data, the likelihood of those threats occurring and the impact of those threats upon the Transfer Agent organization to evaluate and analyze the appropriate level of information security safeguards (“Risk Assessments”).

  • Workshops During the month of September or October of each year during the term of this Agreement, there shall be held at each University a workshop for Department Chairs at which will be discussed their roles and responsibilities as such. Representatives of the University, at its election, and representatives of the Association, at its election, shall be permitted to participate jointly in such workshop.

Time is Money Join Law Insider Premium to draft better contracts faster.