投資者保障. 6.1 買賣 A 股並不享有根據《證券及期貨條例》設立的投資者賠償基金提供的保障。因此，有別於買賣聯交所上市證券，如客戶因香港證券及期貨事務監察委員會持牌或註冊人士失責而蒙受任何損失，客戶將不會獲得投資者賠償基金的賠償。
投資者保障 Sample Clauses
Related to 投資者保障
Line Splitting 3.7.1 Line splitting allows a provider of data services (a Data LEC) and a provider of voice services (a Voice CLEC) to deliver voice and data service to End Users over the same Loop. The Voice CLEC and Data LEC may be the same or different carriers.
Wash all machine-washable bedding, drapes, and clothing, on the hottest water temperature and dry on the highest heat setting. Items that cannot be washed must be taken to a dry cleaner who MUST be informed of the issue. You must safely discard ALL items that cannot be decontaminated.
KITCHEN Discard all leftover food in large trash receptacle in kitchen and empty any smaller trash receptacles if used into large trash can in kitchen. Empty large trash bin into the dumpster, (if feasible). If not, please notify front desk. Flatware is to be pre-soaked, washed in dishwasher, dried, returned to drawers and placed facing in the same direction. Dishes, glassware, chopping boards, cooking utensils, pots/pans, baking sheets etc. should be washed in accordance with the instructions on the dish washing machine and returned DRY to dish carts and cupboards. Please check for lipstick/chap stick marks and clean those off accordingly before putting glasses/cups away. Wipe down outside of dishwasher, empty dishwasher food trap into trash and wash out. Counters and sinks wiped down with the water and bleach solution. If used, please wipe inside and out microwave oven; wall/warming ovens, inside the refrigerator and refrigerator door. Run garbage disposal in large double sink by dishwashing machine to clear food waste (Please do not put any food waste in small sinks). Wipe out Alto-Shaam (Warming Ovens) and clean food trays if used. Rinse out any Dish Tubs. Empty any tubs of excess ice outside, if used. Sweep floor of food debris. Empty large trash bin into the dumpster (if feasible). If not please notify front desk. B BQ’s: Make sure propane is turned off after use Clean grill racks with wire brush and wipe up any spills /food debris from the BBQ Leave outside to cool. Please check with Front Desk regarding storage of cold and cleaned BBQ’s PATIO: Return outdoor umbrellas and furniture to original positions. Wipe down outdoor furniture if spills have occurred. Dispose of trash/food waste and cigarette butts in trash receptacles. The following applies if any food and/or beverages have been served in these rooms: GREAT ROOM: Wipe down tables with bleach /water solution. (Located under the sink in the kitchen next to the coffee maker). If linens have been used or rented, please shake off any food debris in trash receptacles and place linens in mesh bags provided. Sorting by color or type is not necessary. Notify front desk of any beverage spills as soon as they occur. Empty any trash receptacles into large trash can in kitchen and then empty that into the dumpster (if feasible). If not please notify front desk. Sweep/Vacuum carpet of any food debris. (These items are located in the cupboard next to Men’s restroom.
Stabling Without prejudice to Network Rail’s obligations, if any, under Schedule 5 to provide Stabling, Network Rail shall use all reasonable endeavours to provide such Stabling facilities as are necessary or expedient for or in connection with the provision of the Services in accordance with the Working Timetable.
Class All REMIC I Regular Interests or the Class R-1 Residual Interest having the same priority and rights to payments on the Mortgage Loans from the REMIC I Available Distribution Amount, all REMIC II Regular Interests or the Class R-2 Residual Interest having the same priority and rights to payments on the REMIC I Regular Interests from the REMIC II Available Distribution Amount, and all REMIC III Regular Interests or the Class R-3 Residual Interest having the same priority and rights to payments on the REMIC II Regular Interests from the REMIC III Available Distribution Amount, as applicable, which REMIC I Regular Interests, REMIC II Regular Interests, REMIC III Regular Interests and Class R Residual Interests, as applicable, shall be designated as a separate Class, and which, in the case of the Certificates (including the Class R Certificates representing ownership of the Class R Residual Interests), shall be set forth in the applicable forms of Certificates attached hereto as Exhibits A and B. Each Class of REMIC I Regular Interests and the Class R-1 Residual Interest shall be entitled to receive the amounts allocated to such Class pursuant to the definition of "REMIC I Distribution Amount" only to the extent of the REMIC I Available Distribution Amount for such Distribution Date remaining after distributions in accordance with prior clauses of the definition of "REMIC I Distribution Amount," each Class of REMIC II Regular Interests and the Class R-2 Residual Interest shall be entitled to receive the amounts allocated to such Class pursuant to the definition of "REMIC II Distribution Amount" only to the extent of the REMIC II Available Distribution Amount for such Distribution Date remaining after distributions in accordance with prior clauses of the definition of "REMIC II Distribution Amount" and each Class of REMIC III Regular Interests and the Class R-3 Residual Interest shall be entitled to receive the amounts allocated to such Class pursuant to the definition of "REMIC III Distribution Amount" only to the extent of the REMIC III Available Distribution Amount for such Distribution Date remaining after distributions in accordance with prior clauses of the definition of "REMIC III Distribution Amount."
Remote Terminal Unit Prior to the Initial Synchronization Date of the Large Generating Facility, a Remote Terminal Unit, or equivalent data collection and transfer equipment acceptable to the Parties, shall be installed by Developer, or by Connecting Transmission Owner at Developer’s expense, to gather accumulated and instantaneous data to be telemetered to the location(s) designated by Connecting Transmission Owner and NYISO through use of a dedicated point-to-point data circuit(s) as indicated in Article 8.1. The communication protocol for the data circuit(s) shall be specified by Connecting Transmission Owner and NYISO. Instantaneous bi-directional analog real power and reactive power flow information must be telemetered directly to the location(s) specified by Connecting Transmission Owner and NYISO. Each Party will promptly advise the appropriate other Party if it detects or otherwise learns of any metering, telemetry or communications equipment errors or malfunctions that require the attention and/or correction by that other Party. The Party owning such equipment shall correct such error or malfunction as soon as reasonably feasible.
Culture e) History and past behavior;
Cooking The University will permit cooking only in the designated kitchen areas of the University Housing. In all other areas, cooking is permitted only with University approved appliances. The following appliances are prohibited: toaster ovens, microwave ovens larger than 800 xxxxx, refrigerators larger than 4.2 cubic feet, gas grills, steamers and any open-flame cooking device or heating unit. For a complete list please reference the Residential Handbook.
Lockers Where working conditions or weather requires regular employees to have additional clothing available at their regular point of assembly, the Employer shall provide appropriate secure individual lockers within the assembly room building.
Provisioning Line Splitting and Splitter Space 3.8.1 The Data LEC, Voice CLEC or BellSouth may provide the splitter. When EZ Phone or its authorized agent owns the splitter, Line Splitting requires the following: a non-designed analog Loop from the serving wire center to the NID at the End User’s location; a collocation cross connection connecting the Loop to the collocation space; a second collocation cross connection from the collocation space connected to a voice port; the high frequency spectrum line activation, and a splitter. The Loop and port cannot be a Loop and port combination (i.e. UNE-P), but must be individual stand-alone Network Elements. When BellSouth owns the splitter, Line Splitting requires the following: a non designed analog Loop from the serving wire center to the NID at the End User’s location with CFA and splitter port assignments, and a collocation cross connection from the collocation space connected to a voice port.
