Drafter’s Note definition

Drafter’s Note. Remove the information within the brackets [ ] below when not applicable to the Agreement. Remove the brackets [ ].

Drafter’s Note. Check BPA address and phone number prefix to ensure it is applicable.) If to «Customer Name»: «Utility Name» «Street Address» «P.O. Box » «City, State, Zip» Attn: «Contact Name» «Contact Title» Phone: «###-###-####» FAX: «###-###-####» E-Mail: «E-mail address»

Drafter’s Note. If the sub-consultant(s) cost are close to $25,000, they must develop a cost plus fixed fee breakout of those costs and if not pre-qualified, include documentation to support the overhead rate used in the cost estimate.] Subcontract Pass-Through Costs (Identify by Name **indicates DBE firm(s)) [DRAFTER’s NOTE: do the Hours x Rate = cost? Are the subtotal added correctly?] [DRAFTER’s NOTE: the overhead rate listed must be the accepted provisional overhead rate determined by MoDOT through the annual financial pre-qualification process] Other Direct Costs [DRAFTER’s NOTE: If the sub-consultant(s) cost are close to $25,000, they must develop a cost plus fixed fee breakout of those costs and if not pre-qualified, include documentation to support the overhead rate used in the cost estimate.] Subcontract Pass-Through Costs (Identify by Name **indicates DBE firm(s)) [DRAFTER’s NOTE: the overhead rate listed must be the accepted provisional overhead rate determined by MoDOT through the annual financial pre-qualification process]

Examples of Drafter’s Note in a sentence

• Such adjustments shall be specified in writing between BPA and «Customer Name»; Drafter’s Note: Edit this to include any exceptions for this POD.

• Drafter’s Note: Include any special provisions here that are applicable to this resource.

• If there are none or only one, then format similar to Metering Loss Adjustment above.Exception«s»: Drafter’s Note: The following exceptions are guidelines for possible exceptions needed in sections 1.1 and 1.2 of the Metering Exhibit.

• Subject to this section 11.1, «Customer Name» shall have a one-time right to change its purchase obligation, identified in section 3, to another purchase obligation available from BPA, including (Drafter’s Note: Delete product customer is currently purchasing) «Load Following/Block» or Slice/Block.

• Drafter’s Note: Fill in the table with customer’s CHWM.Drafter’s Note: New customers will receive the “Note” but will not receive the number 1 footnote.Note: BPA shall round the number in the table above to three decimal places.

More Definitions of Drafter’s Note

Drafter’s Note. If customer has more than one CF/CT, number each separately as (1), (2)

Drafter’s Note. If there is only one Point of Interchange, remove the numbering “(a)” from this section, move indent appropriately to line up, and renumber the metering to start with “1.1”.

Drafter’s Note. The table below will be blank at contract signing.

Drafter’s Note. List all meters for this Interchange Point. If there is only one meter, remove the numbering “(A)” from this section and move indent appropriately to line up.

Drafter’s Note. List each Specified Resource, in the applicable section, using the format shown below in section 2.1

Drafter’s Note. The following notes and terms are guidelines for developing the Metering Exhibit. Do not include the following in the final exhibit. Footnote 1 should be edited to only have abbreviations needed.)

Drafter’s Note. Check BPA address and phone number prefix to ensure it is applicable.) If to «Customer Name»: «Utility Name» «Street Address» «P.O. Box » «City, State, Zip» Attn: «Contact Name» «Contact Title» Phone: «###-###-####» FAX: «###-###-####» E-Mail: «E-mail address» If to BPA: Bonneville Power Administration «Street Address» «P.O. Box» «City, State, Zip» Attn: «AE Name - Routing» «Senior» Account Executive Phone: «###-###-####» FAX: «###-###-####» E-Mail: «E-mail address»