Interior Lighting definition

Interior Lighting. See Reflected Ceiling Plan. Lab and Surrounding Area: Furnish and install 12” x 4’, 12” x 8’, and 12” x 12’ “ice cube tray” fixtures suspended by xxxx chains. Height of fixtures, number of fixtures, and location to be verified by Wellesley Building Company in writing. Wellesley Building Company will provide a lighting layout prior to installation. Modifications of said layout, to be approved, in writing, by Wellesley Building Company, Subcontractor responsible to assemble, install, secure, and wire all fixtures as necessary. Verify locations with Wellesley Building Company in writing prior to any drilling, cutting, or installation.
Interior Lighting. The interior lighting system shall provide a minimum 8 foot-candle illumination on a 1 sq. ft. plane at an angle of 45 degrees from horizontal, centered 33 in. above the floor and 24 in. in front of the seat back at each seat position. Allowable average light level for the rear bench seats shall be 7 foot-candles. The switch for these lamps shall be mounted in the dash, back lighted, and labeled.
Interior Lighting. Landlord shall provide lighting inside of bathrooms, utility closets and stairs. Tenant shall be responsible, at its sole cost and expense, for all other interior lighting to suit Tenant’s program. Parking: Parking lots will be resurfaced and striped. Tenant shall be responsible, at its sole cost and expense, for additional parking equipment, if desired by Tenant, in Tenant’s sole and absolute discretion.

Examples of Interior Lighting in a sentence

  • Any defects in heating, lighting and ventilation should be reported to the Premises Manager or the Bursar who will take action to rectify the fault.Lighting – The Chartered Institution of Building Services, in its Code for Interior Lighting 1984, recommends levels of 300 lux in halls, classrooms, libraries, gymnasium and workshops and 500 lux in art rooms, needlerooms (with supplementary local lighting) and laboratories, (p.

  • Adapted from AS 1680 – Interior Lighting Quality of lightThis refers not only to the level of lighting, but also to other factors which have a significant impact on how well we are able to perform a task.

  • Therefore, the code/ standard practice baseline for hard- wired fixtures that were not previously covered by 2018 Phase 1 dispositions shall be 100 1 “Statewide Interior Lighting Standard Practices Study,” sponsored by SCE and authored by TRC.

  • Interior lighting for the offices floors must be designed in accordance with “CIBSE Code for Interior Lighting, 1994” guidelines on maintained illuminance on the working plane, illuminance variation and limiting glare index.

  • The Interior Lighting Design Criteria shall be used as the basis of CMU lighting design.

  • Multifamily Unit Renovation – Doors and Hardware • Replace 12 interior doors, hinges and hardware • Doors shall be 3x7, solid core wood doors • Grade 2 locksets with knobs • Replace 2 push bar exist devices and door closers on exit doors – Interior Lighting • Replace all lay-in troffer fixtures on first and second floors.

  • Our leading positions in Seating and Interiors (including SAS) combined with Hella’s leading position in Interior Lighting and both companies’ Electronics should significantly strengthen our Cockpit of the Future strategy.

  • The only major building s not included in the audit are the highway garage and the transfer station ( as well as some buildings like th e salt shed and yard fixtures.)PDF: COMPREHENSIVE ENERGY AUDIT PE3 Action: Interior Lighting Upgrades 2 Points Program Summary: The City hired a contractor via Central Hudson to upgrade City Hall lighting fixtures in 2015.

  • These skills are further supplemented through elective subjects such as Interior Lighting, Interior Landscape, Sustainable Interior, Set Design, Interior Project Management, Furniture Design and Product Design.

  • Interior Lighting All lighting must be on the HOUSE EMERGENCY GENERATOR provided by the LESSOR.


More Definitions of Interior Lighting

Interior Lighting. All Parks
Interior Lighting. All T12 fixtures were replaced with LED’s. All incandescent lamps were replaced with 18 watt CFL’s. Existing T8 and CFL lamps that have over 5000 burn hours were retrofitted with LED lamps. All existing heat lamps were replaced with CFL bulbs. Existing CFL lamps remained in place. All Parks • Exterior Lighting: Metal halide, high pressure sodium, and incandescent flood lights were replaced with LED lamps and fixtures. All Parks • Occupancy sensors were installed in convention centers, meeting rooms, dining spaces, offices, closets, and restrooms. Occupancy controls were installed on vending machines. All malfunctioning photocells were replaced with new. All Parks • *Building Envelope Improvements • All exterior doors were weather stripped. All Parks • Existing HVAC openings for PTAC units, piping, ductwork, and louvers were sealed to minimize infiltration. All Parks • Duct penetrations, open voids, holes, penetrations will be sealed. Insulation repaired and installed. Carter Caves, Natural Bridge, Fort Boonesborough. • Existing cabins will be caulked and chinked. Pine Mountain • *Laundry Ozone • All parks except Xxxx Xxxxxxx and Fort Boonesborough received one ArtiClean ozone laundry system. • *Water Efficiency Upgrades • All parks lodge rooms received 2.0 gpm showerheads. All faucet aerators replaced with 1.0 gpm aerators. All bathhouse and pool showerheads replaced with 1.5 gpm vandal resistant heads. All common guest area toilets replaced with 1.5 gallons per flush fixtures. All existing urinals replaced with .125 gallons per flush urinals. Individual lodge room toilets were not replaced. All Parks
Interior Lighting. Seventy Four (74) 400 watt, metal halide light fixtures are provided to serve the Building Shell. Windows: Sixteen (16) 16' wide x 6' tall windows are provided at the main level. All windows are 1" insulated and tinted glass installed in an aluminum framing system. Standard 1" aluminum horizontal blinds will be installed on all windows.

Related to Interior Lighting

  • Interior lot means a lot other than a corner lot.

  • Interior means the spaces, parts, components or elements of an individual dwelling unit.

  • Roof means a non-porous cover for a structure such as (by way of example and not limitation) Lexan barriers or shingles but not a shade trellis, ivy or other open or porous material that may also be used as a cover.

  • HVAC means heating, ventilation and air conditioning.

  • Building means any structure used or intended for supporting or sheltering any use or occupancy.

  • Installations means all property of any kind paid for by Landlord, all Alterations, all fixtures, and all partitions, hardware, built-in machinery, built-in casework and cabinets and other similar additions, equipment, property and improvements built into the Premises so as to become an integral part of the Premises, including, without limitation, fume hoods which penetrate the roof or plenum area, built-in cold rooms, built-in warm rooms, walk-in cold rooms, walk-in warm rooms, deionized water systems, glass washing equipment, autoclaves, chillers, built-in plumbing, electrical and mechanical equipment and systems, and any power generator and transfer switch.

  • Landscaping means the treatment of land (other than buildings) being the site or part of the site in respect of which this planning permission is granted, for the purpose of enhancing or protecting the amenities of the site and the area in which it is situated and includes screening by fences, walls or other means of enclosure; measures to screen the refuse provision; planting of trees, hedges, shrubs or grass; formation of banks, terraces or other earth works, laying out of gardens, paved areas or courts and other amenity features.

  • Installation Site means the site at which the Product is originally installed.

  • Common Area means all areas and facilities within the Project that are not designated by Landlord for the exclusive use of Tenant or any other lessee or other occupant of the Project, including the parking areas, access and perimeter roads, pedestrian sidewalks, landscaped areas, trash enclosures, recreation areas and the like.

  • Water surface elevation means the height, in relation to the National Geodetic Vertical Datum (NGVD) of 1929, the North American Vertical Datum (NAVD) of 1988, or other datum, where specified, of floods of various magnitudes and frequencies in the floodplains of riverine areas.

  • Work area means a room or defined space in a workplace where hazardous chemicals are produced or used, and where employees are present.

  • drainage work means any watercourse and includes any land which is expected to provide flood storage capacity for any watercourse and any bank, wall, embankment or other structure, or any appliance, constructed or used for land drainage or flood defence;

  • Building Systems means any electrical, mechanical, structural, plumbing, heating, ventilating, air conditioning, sprinkler, life safety or security systems serving the Building.

  • Plumbing means plumbing as defined in Section 1(1) of the Act.

  • Electrical work Means any labor or material used in installing, altering, maintaining, or extending an electrical wiring system and the appurtenances, apparatus, or equipment used in connection with the use of electrical energy in, on, outside, or attached to a building, residence, structure, property, or premises. The term includes service entrance conductors as defined by the National Electrical Code.

  • The Building means any building of which the Property forms part.

  • Bathroom means any room containing a built-in flush-type toilet.

  • Exterior container means a MIL-STD-129 defined container, bundle, or assembly that is sufficient by reason of material, design, and construction to protect unit packs and intermediate containers and their contents during shipment and storage. It can be a unit pack or a container with a combination of unit packs or intermediate containers. An exterior container may or may not be used as a shipping container.

  • Building system means plans, specifications and docu- mentation for a system of manufactured building or for a type or a system of building components, which may include structural, electrical, mechanical, plumbing and variations which are sub- mitted as part of the building system.

  • Building Drain means that part of the lowest horizontal piping of a drainage system which receives the discharge from soil, waste, and other drainage pipes inside the walls of the building and conveys it to the building sewer, beginning five (5) feet (1.5 meters) outside the inner face of the building wall.

  • Plumbing fixture means a receptacle or device that is permanently or temporarily connected to the water distribution system of the premises and demands a supply of water from the system; or discharges used water, waste materials, or sewage directly or indirectly to the drainage system of the premises.

  • Building Common Areas means with respect to the Tower, the areas, facilities and amenities specified in Schedule [E] which are to be used and enjoyed in common with all the other Apartment Acquirers of the Units in the Building; and

  • Base Building shall include the structural portions of the Building, the public restrooms and the Building mechanical, electrical and plumbing systems and equipment located in the internal core of the Building on the floor or floors on which the Premises are located. Tenant shall promptly provide Landlord with copies of any notices it receives regarding an alleged violation of Law. Tenant shall comply with the rules and regulations of the Building attached as Exhibit E and such other reasonable rules and regulations adopted by Landlord from time to time, including rules and regulations for the performance of Alterations (defined in Section 9).

  • Install means the complete installation of any item, equipment or material.

  • Water Surface Elevation (WSE means the height, in relation to NAVD 1988, of floods of various magnitudes and frequencies in the floodplains of riverine areas.

  • Plumbing system means water supply distribution and disposal piping on the premises, including appliances and equipment attached thereto, between their connection points to a public or private system.