Access to trade Clause Samples

Access to trade. (a) Subject to this agreement, the Operator will give all Trading Participants access to the Trading System to the extent required for the purpose of participating in Exchange trading for all Products which that Trading Participant has been admitted to trade under clause 6.3. (b) The Operator must register a Member as a Trading Participant if that Member has applied to become a Trading Participant and the Operator is satisfied that the Member, or the Agent Member for each Appointing Member: (i) has met the requirements in clause 6.1(b); (ii) has an active Austraclear account and has given its account information to the Operator; and (iii) is registered for GST purposes and has executed and delivered to the Operator a recipient created tax invoice agreement in the form specified by the Operator from time to time.
View SourceView Similar (11)
Access to trade. Subject to this agreement, the Operator will give all Trading Participants access to the Trading System to the extent required for the purpose of participating in Exchange trading for all Products which that Trading Participant has been admitted to trade under clause 6.3. The Operator must register a Member as a Trading Participant if that Member has applied to become a Trading Participant and the Operator is satisfied that: the Member has met the requirements in clause 6.1(b); the Member has an active Austraclear account and has given its account information to the Operator; and the Member is registered for GST purposes and has executed and delivered to the Operator a recipient created tax invoice agreement in the form specified by the Operator from time to time.
View SourceView Similar (2)

Related to Access to trade

  • Access to Site 3.05.1 Contractor may enter and leave the premises at all reasonable times without charge. Contractor and its employees may use the common areas and roadways of the premises where it is to perform the services together with all facilities, equipment, improvements, and services provided in connection with the premises for common use. This excludes parking for Contractor’s personnel. Contractor shall repair any damage caused by it or its employees as a result of its use of the common areas.

  • Access to Property Borrower shall permit agents, representatives and employees of Lender to inspect the Property or any part thereof at reasonable hours upon reasonable advance notice.

  • Access to NID 2.7.3.1 NewPhone may access the customer’s premises wiring by any of the following means and NewPhone shall not disturb the existing form of electrical protection and shall maintain the physical integrity of the NID: 2.7.3.1.1 BellSouth shall allow NewPhone to connect its Loops directly to BellSouth’s multi-line residential NID enclosures that have additional space and are not used by BellSouth or any other telecommunications carriers to provide service to the premises; 2.7.3.1.2 Where an adequate length of the customer’s premises wiring is present and environmental conditions permit, either Party may remove the customer premises wiring from the other Party’s NID and connect such wiring to that Party’s own NID; 2.7.3.1.3 Either Party may enter the subscriber access chamber or dual chamber NID enclosures for the purpose of extending a cross-connect or spliced jumper wire from the customer premises wiring through a suitable “punch-out” hole of such NID enclosures; or 2.7.3.1.4 NewPhone may request BellSouth to make other rearrangements to the customer premises wiring terminations or terminal enclosure on a time and materials cost basis. 2.7.3.2 In no case shall either Party remove or disconnect the other Party’s loop facilities from either Party’s NIDs, enclosures, or protectors unless the applicable Commission has expressly permitted the same and the disconnecting Party provides prior notice to the other Party. In such cases, it shall be the responsibility of the Party disconnecting loop facilities to leave undisturbed the existing form of electrical protection and to maintain the physical integrity of the NID. It will be NewPhone’s responsibility to ensure there is no safety hazard, and NewPhone will hold BellSouth harmless for any liability associated with the removal of the BellSouth Loop from the BellSouth NID. Furthermore, it shall be the responsibility of the disconnecting Party, once the other Party’s loop has been disconnected from the NID, to reconnect the disconnected loop to a nationally recognized testing laboratory listed station protector, which has been grounded as per Article 800 of the National Electrical Code. If no spare station protector exists in the NID, the disconnected loop must be appropriately cleared, capped and stored. 2.7.3.3 NewPhone shall not remove or disconnect ground wires from BellSouth’s NIDs, enclosures, or protectors. 2.7.3.4 NewPhone shall not remove or disconnect NID modules, protectors, or terminals from BellSouth’s NID enclosures. 2.7.3.5 Due to the wide variety of NID enclosures and outside plant environments, BellSouth will work with NewPhone to develop specific procedures to establish the most effective means of implementing this section if the procedures set forth herein do not apply to the NID in question.

  • Access to Data Operator shall make Data in the possession of the Operator available to the LEA within five (5) business days of a request by the LEA.

  • Access to Tax Records The Companies and their respective Affiliates shall make available to each other for inspection and copying during normal business hours upon reasonable notice all Tax Records in their possession to the extent reasonably required by the other Company in connection with the preparation of Tax Returns, audits, litigation, or the resolution of items under this Agreement.