Termination Conditions Such license shall not be terminated or its exploitation enjoined, until and unless: (i) Hitachi has committed a material breach of its obligations under this IP License Agreement, Opto-Device has given written notice of such breach to Hitachi and such breach remains uncured after the Cure Period, or, in the case of a breach, which cannot be cured within such Cure Period, Hitachi has not instituted within such Cure Period steps necessary to remedy the default and/or thereafter has not diligently pursued the same to completion; or (ii) such a material breach is incurable. In the event the breach is a curable breach that cannot be cured within the Cure Period but with respect to which Hitachi has instituted steps necessary to remedy the default and is thereafter diligently pursuing such cure, both parties shall negotiate to determine whether further pursuit of such cure is reasonable. If the parties cannot agree on a resolution in such negotiations, then this issue shall be referred to arbitration pursuant to the arbitration procedures set forth in Exhibit B hereto to decide whether such breach can be cured or any other alternative remedy should be adopted. In the event the breach is an incurable breach, the parties agree that the matter shall be referred to arbitration pursuant to the arbitration procedures set forth in Exhibit B hereto to determine the appropriate remedy. In the event that either party submits the dispute to arbitration, both parties shall cooperate in such binding arbitration in accordance with Exhibit B.
Release Conditions As used in this Agreement, "Release Conditions" shall mean the following:
Service Conditions Customer acknowledges that in the event of a service issue, Customer is responsible for on-site cooperative testing with LightEdge Technical Support to assist in the diagnosis of the trouble. Customer agrees to be bound to current terms of LightEdge Acceptable Use Policy. Terms of the Acceptable Use Policy are subject to change without notice. Current Acceptable Use Policy can be found here: xxxx://xxx.xxxxxxxxx.xxx/legal Customer agrees that any service complaints including concerns regarding level of support, products, service reliability, or any other concerns related to LightEdge or Services being provided by LIghtEdge will be communicated to LightEdge by sending an email to xx@xxxxxxxxx.xxx.
Site Conditions A. Existing Site Conditions: Information with respect to the site of the Work given in drawings or specifications has been obtained by County's representatives and is believed to be reasonably correct, but the County does not warrant either the completeness or accuracy of such information, and it is the responsibility of the Contractor to verify all such information.
Existing Conditions Tenant accepts the Property in its condition as of the execution of the Lease, subject to all recorded matters, laws, ordinances, and governmental regulations and orders. Except as provided herein, Tenant acknowledges that neither Landlord nor any agent of Landlord has made any representation as to the condition of the Property or the suitability of the Property for Tenant's intended use. Tenant represents and warrants that Tenant has made its own inspection of and inquiry regarding the condition of the Property and is not relying on any representations of Landlord or any Broker with respect thereto. If Landlord or Landlord's Broker has provided a Property Information Sheet or other Disclosure Statement regarding the Property, a copy is attached as an exhibit to the Lease.
Safe Conditions Whenever an employee reports a condition which the employee feels represents a violation of safety or health rules and regulations or which is an unreasonable hazard to persons or property, such conditions shall be promptly investigated. The appropriate administrator shall reply to the concern, in writing, if the employee's concern is communicated in writing.
Market Conditions Notwithstanding any provision of this Agreement to the contrary, settlement and payment for Foreign Assets received for the account of the Portfolios and delivery of Foreign Assets maintained for the account of the Portfolios may be effected in accordance with the customary established securities trading or processing practices and procedures in the country or market in which the transaction occurs, including, without limitation, delivering Foreign Assets to the purchaser thereof or to a dealer therefor (or an agent for such purchaser or dealer) with the expectation of receiving later payment for such Foreign Assets from such purchaser or dealer. The Custodian shall provide to each Board the information with respect to custody and settlement practices in countries in which the Custodian employs a Foreign Sub-Custodian described on Schedule C hereto at the time or times set forth on such Schedule. The Custodian may revise Schedule C from time to time, provided that no such revision shall result in a Board being provided with substantively less information than had been previously provided hereunder.
Vendor’s Conditions The Vendor shall not be obligated to complete the Transaction unless, at or before the Closing Time, each of the conditions listed below in this section has been satisfied, it being understood that the said conditions are included for the exclusive benefit of the Vendor:
(a) The representations and warranties of YC in this Agreement shall be true and correct on the Closing Date.
(b) YC shall have performed and complied with all of the terms and conditions in this Agreement and the Payment Undertaking on its part to be performed or complied with on or before the Closing Date.
(c) As evidence of the satisfaction of the conditions in sections 7.1 (a) and (b), YC shall deliver to the Vendor at the Closing Time a certificate of YC confirming the matters in sections 7.1 (a) and (b) and to the effect that as of the Closing Time all other conditions set forth in this section have been satisfied. The certificate shall be signed by two senior executive officers of YC acceptable to the Vendor, acting reasonably. Notwithstanding the foregoing, the receipt of such certificate and the completion of the Transaction shall not constitute a waiver (in whole or in part) of, or have the effect of modifying or qualifying in any way, any of the representations and warranties of YC made in or pursuant to this Agreement, each of which shall survive the Closing and remain in full force and effect for the benefit of the Vendor as provided in Article 9.
(d) YC and the Buyer shall have delivered to the Vendor a legal opinion from counsel acceptable to the Vendor, acting reasonably, and in form and content satisfactory to the Vendor subject to reasonable qualifications, as to the due incorporation and organization of YC and the Buyer, the corporate power and authority of YC and the Buyer, the receipt of all necessary approvals by YC and the Buyer and the enforceability of this Agreement, the Payment Undertaking and the Covenant Escrow Agreement as against YC and the Buyer and the non-conflict of this Agreement, the Payment Undertaking and the Covenant Escrow Agreement with respect to the constating documents of YC and the Buyer and any Applicable Laws.
(e) The Vendor Regulatory Approval shall have been granted, obtained and received unconditionally or on terms satisfactory to the Vendor, acting reasonably.
(f) No Order shall have been made and no Legal Proceeding shall have been commenced or shall be pending or threatened against the other Party or its affiliates or which enjoins, restricts or prohibits, or which asserts a claim or seeks a remedy that would have the effect of enjoining, restricting or prohibiting the completion of the Transaction. If any condition in this section has not been fulfilled on or before the Closing Date or if any such condition is or becomes impossible to satisfy, other than as a result of the failure of the Vendor to comply with its obligations under this Agreement, then the Vendor in its sole discretion may, without limiting any rights or remedies available to the Vendor at law or in equity, either terminate this Agreement by written notice to YC, in which case the provisions of sections 2.5(c)(iii), (iv) or (v) shall be applicable, or waive compliance with any such condition without prejudice to its right of termination in the event of non-fulfilment of any other condition.
WORKING CONDITIONS 9.01 Lunch periods shall be at mid-shift.
9.02 The Employer shall allow each employee two (2) breaks of ten (10) minutes each, but not more in a work shift. Time of breaks shall be mutually agreed upon.
9.03 Essential protective clothing including welder’s gloves, protective vests or leather jackets, noise abatement devices, and rainwear shall be supplied at no charge to the employee. In the event that an employee does not return the foregoing items supplied to him by the Employer, the Employer shall charge the cost of same to the employee and deduct this cost from any money owing to the employee.
9.04 Chemical or flush toilets shall be provided from the commencement of work on all jobs. Where the sewer or chemical toilets are not available, sanitary toilet facilities shall be provided as called for in local sanitary regulations. Toilet houses shall be painted, at least on the inside, and cleaned out daily. Toilet paper will be provided.
9.05 Where there is no running tap water available, drinking water in approved sanitary containers shall be provided. Paper cups will be supplied. Salt tablets shall be supplied during the summer months.
9.06 If requested by the Union or employee, the Employer will provide within three (3) calendar days, a termination slip which shall state the reason for the employee’s termination and whether or not he is eligible for rehire.
9.07 Adequate time will be allowed prior to quitting time for picking up tools.
9.08 A lock-up shall be provided for employees for drying clothes, and dressing room, as well as lunch room. The lock-up shall have tables, and benches with provision for drying clothes. Such lock-up shall have windows and venting with adequate lighting and provision for continuous heat twenty-four (24) hours a day. The Employer shall be responsible for having the lock-up cleaned out daily and kept cleared of building material and other construction paraphernalia. Additional shelters shall be provided for employees to eat their lunch as may be required.
9.09 In case of fire or burglary on property or premises provided by the Employer, the Employer shall protect the value of an employee’s work clothes up to a total of three hundred and fifty dollars ($350.00). The Employer shall also provide fire and burglary insurance for the employees required tools to a total value of the tools, tool for tool, make for make, provided an inventory of tools and clothing is filed with the Employer. The Employer shall supply the required forms and obtain the inventory from each employee. The employee shall receive a signed copy of the inventory from the Employer. Coverage will commence at the date of the filing of the inventory with the Employer. Where an employee fails to file an inventory his rights to submit a claim shall be waived.
(a) All mechanics, welders, servicemen, tire servicemen, drill doctors, steel sharpeners, bodymen painters, and mechanics and welder apprentices who request coveralls shall have these supplied and cleaned by the Employer. There shall be one change a week available in the employee’s proper size. Employees are expected to take reasonable care of coveralls supplied. In the event that an employee does not return the coveralls supplied to him by the Employer, the Employer shall charge the cost of same to the employee and deduct this cost from any monies owing to the employee. When requested, coveralls shall be supplied on a temporary basis to employees who assist on work as described above, or where the Employer and the Union mutually agree that coveralls are required.
(b) Employees entitled to receive coveralls as provided herein may obtain an additional change of coveralls in any one week providing the condition of the coveralls requires a change. The shop xxxxxxx shall use discretion in authorizing the additional change.
(c) All shops shall provide adequate clean-up facilities.
9.11 The Employer shall pay the cost of obtaining operators’ licences other than those required under the Motor Vehicles Act for employees covered by this Agreement.
9.12 No employee will be permitted to use his own motor vehicle in a manner which is unfair to other members or against the best interest of the Union.
9.13 Each employee being terminated will be given one (1) hour’s notice of termination by the Employer or one (1) hour’s pay allowed in lieu thereof. Heavy duty mechanics and apprentice mechanics may utilize this hour to gather together their tools and put them in shape for their next job.
9.14 When a mechanic leaves the employ of the Employer, the Employer shall be required to pay cost of shipping mechanic’s tools. Tools shall be shipped within forty-eight (48) hours of his leaving his employment, subject to the same conditions as govern transportation. When an Operating Engineer elects to transport his own tools to and from the jobsite, the employee shall be paid the rate of two dollars and seventy-five cents ($2.75) per one hundred (100) pounds per one hundred (100) miles. (e.g. $2.75 x 528 pounds x 273 miles = $39.64). Where the Employer fails to comply with the above, the employee shall be deemed to be still on the payroll of the Employer and shall receive his usual wages and all other conditions of this Agreement until there is compliance with these provisions.
9.15 Where an employee is involved in an accident while on the job and as a result is unable to perform his work, he shall receive a full day’s pay for the day of the accident.
Payment Conditions The price of the whole accommodation service booked is always payable by the Guest in advance, at the latest upon arrival in the hotel. Set-off by the Guest is excluded unless the set- off relates to an undisputed or legally confirmed claim. Valid means of payment are cash in Euros, EC card, Master Card, Visa Card, Diners Card and American Express. For payment settlement we use the 3D Secure 2.0 system for secure and additional customer authorisation. For further information on data processing for payment transactions see xxxxx://xxx.xxxxx-xxx.xxx/en/data-privacy/.
