Unsafe Working Conditions Employees shall be recognized by the Employer to have the competence to determine what constitutes unsafe working conditions within their discipline. No employee shall be disciplined for refusal to work in a situation which is deemed unsafe beyond the reasonable requirements of the employee's job.
GENERAL WORKING CONDITIONS Section 18-1. Employment begins and ends at each project site. Section 18-2. The selection of craft foremen and/or general foremen and the number of foremen required shall be entirely the responsibility of the Employer, it being understood that in the selection of such foremen and/or general foremen the Employer will give primary consideration to the qualified individuals available in the local area. After giving such consideration, the Employer may select such individuals from other areas. All foremen shall take orders from the designated Employer representatives. Craft foremen shall be designated working foremen at the request of the Employer. Section 18-3. There shall be no limit on production by employees nor restrictions on the full use of tools or equipment. Employees using tools shall perform any of the work of the trade and shall work under the direction of the craft foremen. There shall be no restrictions on efficient use of manpower other than as may be required by safety regulations. Section 18-4. Employees shall be at their place of work at the starting time and shall remain at their place of work performing their assigned functions under the supervision of the Employer until quitting time. The parties reaffirm their policy of a fair day’s work for a fair day’s wage. Section 18-5. All equipment assigned to a project shall be under the control of the Employer. The Employer shall have the right to determine how many pieces of equipment an individual employee shall operate. In an emergency, foremen shall operate any equipment assigned by the Employer, and there shall be no restriction on foremen in the use of the tools of his or her craft in such emergency. The foremen shall be from the craft normally operating the equipment. In accordance with currently recognized craft jurisdiction, the Employer shall determine the assignment of employees to start, stop, and maintain small portable construction equipment. Such work may be assigned to craft employees within a reasonable distance of their primary duties or an employee may be assigned full time to start, stop and maintain the Employer’s small, portable equipment on the job site. There shall be no over xxxxxxx of this type of equipment. The number of employees assigned to rigging and scaffolding operations shall be at the sole discretion of the Employer. The ratio of journeyperson to welders shall be determined solely by the Employer. Section 18-6. The Employer may utilize the most efficient methods or techniques of construction, tools or other labor saving devices to accomplish the work. Practices not a part of the terms and conditions of this Agreement, stand by crews and feather bedding practices will not be recognized. Section 18-7. It is recognized that specialized or unusual equipment may be installed and/ or serviced by individuals who have special training, skill, or qualifications and are not covered by this Agreement. Testing, inspection, or service performed on plant equipment under warranty may be performed by the vendor’s personnel. Section 18-8. Neither the Union nor its local unions shall coerce or in any way interfere with the Owner’s personnel, operation or facilities at the plant site. The Owner’s right to contract directly with other companies for work at the plant site shall not be limited, and the Union shall cooperate and not interfere with the Employer’s operations. Section 18-9. It is agreed that overtime is undesirable and not in the best interest of the industry or the employees; therefore, except in unusual circumstances, overtime will not be worked. Where unusual circumstances do exist, however, the Employer will have the right to assign specific employees and/or crews to perform such overtime work as is necessary to accomplish the job. Section 18-10. There will be no rest periods, organized coffee breaks or other non-working time established during working hours. Section 18-11. Individual seniority shall not be recognized or applied to employees working on projects under this Agreement. Section 18-12. The Employer shall establish such reasonable project rules as the Employer deems appropriate. These rules will be reviewed at the pre-job conference and posted at the project site by the Employer, and may be amended thereafter as necessary.
Unsafe Work Conditions No Employee shall be disciplined for refusal to work on a job which in the opinion of: (a) A member of a safety committee; or (b) A person designated by a safety committee; or (c) A safety officer after an on-site inspection and following discussion with a representative of the Employer, does not meet the standards established pursuant to the Workers' Compensation Act.
Geographic Area and Sector Specific Allowances, Conditions and Exceptions The following allowances and conditions shall apply where relevant. Where the Employer does work which falls under the following headings, the Employer agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.
Safe Working Conditions The Employer undertakes to maintain office furniture, equipment, etc., in a practical and safe condition in order to avoid injury to employees or damage to their attire. Employees, for their part and in their own interest, are expected to advise the Employer of any such potentially injurious equipment.
Suspension of unsafe Construction Works (i) Upon recommendation of the Authority’s Engineer to this effect, the Authority may by notice require the Contractor to suspend forthwith the whole or any part of the Works if, in the reasonable opinion of the Authority’s Engineer, such work threatens the safety of the Users and pedestrians. (ii) The Contractor shall, pursuant to the notice under Clause 11.17 (i), suspend the Works or any part thereof for such time and in such manner as may be specified by the Authority and thereupon carry out remedial measures to secure the safety of suspended works, the Users and pedestrians. The Contractor may by notice require the Authority’s Engineer to inspect such remedial measures forthwith and make a report to the Authority recommending whether or not the suspension hereunder may be revoked. Upon receiving the recommendations of the Authority’s Engineer, the Authority shall either revoke such suspension or instruct the Contractor to carry out such other and further remedial measures as may be necessary in the reasonable opinion of the Authority, and the procedure set forth in this Clause 11.17 shall be repeated until the suspension hereunder is revoked. (iii) Subject to the provisions of Clause 21.6, all reasonable costs incurred for maintaining and protecting the Works or part thereof during the period of suspension (the “Preservation Costs”), shall be borne by the Contractor; provided that if the suspension has occurred as a result of any breach of this Agreement by the Authority, the Preservation Costs shall be borne by the Authority. (iv) If suspension of Works is for reasons not attributable to the Contractor, the Authority’s Engineer shall determine any Time Extension to which the Contractor is reasonably entitled.
Conditions of Use CLIENT acknowledges that its use of the Site is subject to and conditioned upon the following terms and agrees that TAILGATE GUYS may exercise any of the remedies set forth herein for CLIENTS failure to comply: a. CLIENT shall comply with all rules and regulations established by TAILGATE GUYS, University of Michigan, and any other applicable authority, including but not limited to parking regulations in effect on campus. A copy of current rules and regulations is attached hereto as Exhibit A, which shall be subject to adjustment at any time by TAILGATE GUYS, University of Michigan or other applicable authorities. b. CLIENT shall be permitted to access the Site at the respective times set forth in the rules or otherwise determined by TAILGATE GUYS and University of Michigan. c. CLIENT acknowledges all risks related to its attendance and use of the site, including risk of damage to or loss of property or risk of serious personal injury or death, and accepts sole responsibility for such risks. CLIENT shall secure all personal property in and around the Site and shall take all precautions necessary to prevent theft or destruction thereof. CLIENT expressly acknowledges and agrees that TAILGATE GUYS shall not be responsible for any personal property of or injury to CLIENT at any time. TAILGATE GUYS will not remove or hold for safe-keeping any personal items left on the Site after event closing and same will be subject to removal by University of Michigan facilities. CLIENT may be subject to costs and fees associated with such removal. d. Eligibility for any TAILGATE GUYS drop off service is determined by Tailgate Guys in its sole discretion and is based on University restrictions, staffing availability and other factors. If CLIENT is eligible to participate in any TAILGATE GUYS drop off service, the CLIENT is responsible for properly packaging all items that will be transported and otherwise agrees to comply with procedures established by TAILGATE GUYS for this “drop off service,” including but not limited to any limitations with regard to the amount and size of items to be transported. TAILGATE GUYS will not be responsible for any damaged or broken items during unloading or loading and transportation to or from the Site. e. CLIENT shall respect the interests of other fans and clients of TAILGATE GUYS and shall not engage in or permit disorderly or offensive conduct in or around the Site. CLIENT further agrees not to exceed the maximum number of guests allowed within the as set forth in the Exhibit A. Should CLIENT violate these provisions, TAILGATE GUYS management will give CLIENT a verbal warning. If CLIENT fails to promptly come into compliance, TAILGATE GUYS may immediately revoke CLIENT’s rights to the Site and in its sole and absolute discretion terminate this Agreement. Upon such revocation or termination, all amounts paid to TAILGATE GUYS with be forfeited by CLIENT and retained by TAILGATE GUYS. f. CLIENT shall not move, alter, or disrupt operation of any media equipment provided by TAILGATE GUYS. In the event of inclement weather, TAILGATE GUYS reserves the exclusive right to cover and protect all equipment associated with the Media Package with such materials and coverings as it deems appropriate, which may include gator covers or hard cases for TV’s, plastic bags for receivers and generators or the like (collectively, the "Protective Equipment"). CLIENT shall not remove any Protective Equipment or items contained inside Protective Equipment, and expressly acknowledges and agrees that only TAILGATE GUYS staff shall have authority to do so. CLIENT acknowledges and agrees that its right to use the media equipment may be suspended, without refund, at TAILGATE GUYS option, for violation of these provisions, and CLIENT further assumes all responsibility for any damages to media equipment resulting from violation of these provisions and shall reimburse TAILGATE GUYS for the cost to repair or replace damaged equipment. g. CLIENT shall keep the Site in a neat and orderly manner at all times and may incur fees set forth on Exhibit A, attached hereto and made a part hereof. h. CLIENT acknowledges and agrees that the signage identifying each Site is uniform and provided by TAILGATE GUYS, who reserves the right to omit any vulgar, offensive or discriminatory content requested by CLIENT, in the sole and absolute discretion of TAILGATE GUYS. i. TAILGATE GUYS reserves the right to immediately terminate CLIENT’s use of the Site for violation of the conditions of use. In addition, CLIENT shall be responsible for payment of all damages incurred by TAILGATE GUYS as a result of CLIENT’s failure to comply with the foregoing conditions of use or as a result of damages by CLIENT of any equipment of TAILGATE GUYS. To insure compliance and payment of damages or fines, CLIENT agrees to keep a credit card on file with TAILGATE GUYS, and hereby authorizes TAILGATE to charge said credit card amounts owing as a result of its breach; provided that TAILGATE GUYS delivers to CLIENT an itemization of said charges and receipt for payment thereof.
Notifications of Outages and Maintenance In the event that a Registry Operator plans maintenance, it will provide notice to the ICANN emergency operations department, at least, twenty-‐four (24) hours ahead of that maintenance. ICANN’s emergency operations department will note planned maintenance times, and suspend Emergency Escalation services for the monitored services during the expected maintenance outage period. If Registry Operator declares an outage, as per its contractual obligations with ICANN, on services under a service level agreement and performance requirements, it will notify the ICANN emergency operations department. During that declared outage, ICANN’s emergency operations department will note and suspend emergency escalation services for the monitored services involved.
Additional Conditions to Obligations of Seller The obligation of Seller to effect the Merger is subject to the satisfaction of each of the following conditions, any of which may be waived, in writing, exclusively by Seller:
General Conditions Costs Contractor is entitled to receive payment for the actual cost of the allowable General Conditions items incurred after receipt of a Notice to Proceed with Construction from Owner through Substantial Completion of the Project, plus 30 calendar days. Contractor is not entitled to reimbursement for General Conditions Costs incurred before receipt of the Notice to Proceed. General Conditions Costs incurred after Substantial Completion, plus 30 calendar days, must be approved in advance by Owner. Allowable General Conditions items are identified below and in Exhibit “D” attached to this Agreement. These items shall be included in the General Conditions Cost amount shown as a line item in the Guaranteed Maximum Price Proposal and as detailed on the Schedule of Values. Items not specifically included below or in Exhibit “D” will not be allowed as General Condition Costs.