Application for Leave Any request for a leave of absence shall be submitted in writing by the employee to the Employer or designee. The request shall state the reason the leave of absence is being requested and the length of time off the employee desires. Authorization for a leave of absence shall be furnished to the employee by the Employer or designee, and it shall be in writing.
New Application for Licensure Any time after the three-month period has lapsed from the Effective Date of this Agreement and Respondent has paid the Administrative Penalty set forth in Section III, Paragraph 1 of this Order, Respondent may apply for a new mortgage loan originator license or, as applicable, petition for the reinstatement of an MLO Activity Endorsement in any or all of the Participating States with the understanding that each State Mortgage Regulator reserves the rights to fully investigate such application for licensure or petition for reinstatement of an MLO Activity Endorsement and may either approve or deny such application or petition pursuant to the normal process for such licensing or endorsement investigations. No license application or petition described in this paragraph will be denied solely based on the facts, circumstances, or consensual resolution provided for in this Agreement. Respondent further agrees that Respondent must satisfy the Administrative Penalty provision prior to submitting an application for a new mortgage loan originator license or, as applicable, petition for the reinstatement of an MLO Activity Endorsement.
Notification of Absence A unit member shall contact the office of the division xxxx whenever there is a need to be absent and at least thirty (30) minutes prior to missing any work assignment. Should circumstances prohibit this notification, the unit member shall notify the division office in writing within one week of returning to work, providing the reasons why the advance notification was not given.
Application for Benefits Requests for short-term leaves shall be in writing, upon the appropriate form prescribed and provided by the District, and shall be filed with the unit member's supervisor and the appropriate manager five (5) days in advance of the intended leave (except in emergency situations), unless otherwise stated by the provisions of the specific leave.
Application of Funding Techniques to Programs 6.3.1 The State shall apply the following funding techniques when requesting Federal funds for the component cash flows of the programs listed in sections 4.2 and 4.3 of this Agreement. 6.3.2 Programs Below are programs listed in Section 4.2 and Section 4.3.
Application Form To apply for a pole attachment or conduit occupancy license under this Agreement, Applicant shall submit to SWBT two signed copies of the appropriate application forms. SWBT represents that the forms specified in subsections (a)-(b) are forms in use prior to the effective date of this Agreement and that SWBT is in the process of revising such forms to conform to the provisions of this Agreement and to streamline the application process. The parties therefore agree that the forms specified in subsections (a) and (b) will be interim forms only. SWBT reserves the right to change the format and content of these forms upon 60 days written notice to Applicant. (a) To apply for a pole attachment license, Applicant shall submit to SWBT two signed copies of SWBT’s Form SW-9434 (“Access Application and Make- Ready Authorization”) together with completed Form SW-9433 (“Pole Attachments”). An application for a pole attachment license will not be complete or subject to processing by SWBT until these forms have been submitted to SWBT; provided, however, that such forms will be deemed to be substantially complete if they contain the information specified in subsections (c)-(h) below, as applicable. Copies of Forms SW-9433 and SW-9434 are attached to this Agreement as parts of APPENDIX III. (b) To apply for a conduit occupancy license, Applicant shall submit to SWBT two signed copies of SWBT’s Form SW-9434 (“Access Application and Make-Ready Authorization”) together with completed Form SW-9435 (“Conduit Occupancy”). An application for a conduit occupancy license will not be complete or subject to processing by SWBT until these forms have been submitted to SWBT; provided, however, that such forms will be deemed to be substantially complete if they contain the information specified in subsections (c)-(h) below, as applicable. Copies of Forms SW-9434 and SW-9435 are attached to this Agreement as parts of APPENDIX III. (c) Each application for a license under this Agreement shall include, at a minimum, the following information: (1) the poles, ducts, and conduits (including all manholes) along Applicant’s proposed route to or within which Applicant desires to attach or place its facilities; (2) a description of the facilities to be attached to SWBT’s poles and a description of the facilities to be placed within each component of SWBT’s conduit system (including but not limited to ducts, conduits, manholes, and handholes) along the proposed route; (3) for poles, the proposed points of attachment; (4) for building entrance or building distribution ducts or conduits or other space within a building, a conspicuous statement, as required by Section 5.06 of this Agreement, that the application pertains to a building entrance or building distribution duct or conduit or other space within a building; (5) if applicable, a conspicuous notation that the space requested is not to be assigned (or billed) to Applicant until SWBT has received Applicant’s written instruction to make such assignment or issued a license authorizing Applicant to occupy the space requested; and (6) if applicable, a conspicuous statement that Applicant intends to occupy the space before the issuance of a license, as provided in Section 8.03 of this Agreement. (d) Facilities descriptions which apply to multiple pole attachments or conduit occupancies need only be described once on any form. Facilities descriptions shall include, at a minimum, the following information: (1) the number and types of cables, including the physical size (diameter) and weight (weight per foot); (2) the number and types of strands, if any, which will be used to support the cables, including the rated holding capacity expressed in thousand pound increments (e.g., 2.2M) of such strands; and (3) sufficient information to identify and describe the physical characteristics (size, dimensions, and weight) of apparatus enclosures and other facilities to be attached to SWBT’s poles or placed in SWBT’s conduit system. (e) When it appears to Applicant that facilities modification, capacity expansion, or make-ready work may be required to accommodate Applicant’s access requests, Applicant shall describe the facilities modification, capacity expansion, or make-ready work which Applicant proposes. Applicant shall also describe its plans, if any, to use any infrequent construction technique or connectivity solution authorized under Section 6.03 to avoid high or unusual expenditures and state its reasons for the use of such technique or solution. (f) Applicant acknowledges that the poles along a particular pole line or route may include poles owned by firms (such as electric utilities) other than SWBT, that it may be necessary for SWBT to rearrange its facilities or perform other make-ready work on poles other than poles it owns or controls in order to accommodate Applicant’s request for access to SWBT’s poles and that, at the time an application is submitted, it may be difficult for Applicant to determine with certainty whether a particular pole is owned or controlled by SWBT or by another entity. Accordingly, the application shall, to the extent feasible, identify all poles utilized by SWBT (without regard to ownership) along Applicant’s proposed route. (g) Each application for a license under this Agreement shall be accompanied by a construction schedule showing Applicant’s projected dates for beginning and completing construction at the sites specified in the application. Information on this schedule may be used by SWBT’s engineering and outside plant construction personnel in scheduling work required to process Applicant’s applications and scheduling such capacity expansions, make- ready work, and facilities modifications, if any, as may be necessary to accommodate Applicant’s facilities. (h) Applicant may include multiple cables in a single license application and may provide multiple services (e.g., CATV and non-CATV services) under the same cable sheath or jacket. When both CATV and non-CATV services are provided under the same cable sheath or jacket, or CATV and non-CATV services are provided using different cables attached or lashed to the same strand or otherwise occupying the same space on a pole or the same duct or inner duct within a conduit, Applicant will so advise SWBT and SWBT shall, if permitted by law, adjust its charges to enable SWBT to charge Applicant the rate applicable to telecommunications carriers rather than the rate applicable to cable television systems solely to provide cable service.
Application of Agreement 4.1 This Agreement applies to: (a) Xxxxx Fabrications Pty Ltd (the Employer) (b) the CFMEU (the Union) (c) all Employees of the Employer engaged in construction work and for whom classifications and rates of pay are provided by this Agreement (the Employee). Collectively known as Parties 4.2 This Agreement only applies to work done in Queensland or Northern Territory and to work temporarily done outside Queensland or Northern Territory by Employees who are based in Queensland or Northern Territory, except where employees are covered by a subsequent Greenfields agreement made under s.182(3) of the Fair Work Act 2009 (Cth) and approved by the Fair Work Commission.
Application of Seniority Seniority shall be the controlling factor in the following situations:
Application for Employment Employee understands and agrees that, as a condition of this Agreement, Employee shall not be entitled to any employment with the Company, and Employee hereby waives any right, or alleged right, of employment or re-employment with the Company. Employee further agrees not to apply for employment with the Company and not otherwise pursue an independent contractor or vendor relationship with the Company.
Maternity/Paternity/Adoption Leave An Employee who is expecting the birth or adoption of a child shall be entitled to maternity/paternity/adoption leave without pay, provided she presents a medical certificate confirming the probable date of confinement, or in the case of adoption, gives the Employer notice of eligibility. Except in extenuating circumstances, the notice shall be submitted in writing at least twenty-eight (28) days in advance of the leave and shall specify the probable date of commencement and the anticipated length of leave. The following conditions shall apply: (a) Leave of Absence for maternity/paternity/adoption shall be for up to eighteen (18) months as requested by the Employee, except in extenuating circumstances when, in the opinion of a medical practitioner, the leave should be further extended. (b) Upon return from such leave, the Employee will resume employment at the same worksite, in the same or in a comparable position prior to the granting of such leave. In the event the Employee on Maternity/Paternity/Adoption Leave is affected by lay off, she shall be afforded access to the provisions of Article 26, Layoff And Work Resumption. (c) Notice of intention to return to work or request for a change of the length of the leave of absence, must be forwarded to the Employer twenty-eight (28) days prior to the expiration of the leave. The Employee shall be entitled to one (1) extension of said leave. However, the entire length of such leave of absence shall not exceed eighteen (18) months. (d) An Employee shall have access to sick leave credits as per Article 12.07. (e) Accrual of seniority when on such leave is calculated as follows: (i) For full-time Employees, seniority shall accrue as if they were working. (ii) For other than full-time Employees who have worked for one (1) year or more: 52 Week of Leave (iii) For other than full-time Employees who have worked for less than one (1) year: (f) Supplemental Employment Insurance Maternity/Paternity/Adoption Supplemental Employment Benefit (SEB) The Employer will implement a Supplemental Employment Benefits Plan. Employees will receive the Supplementary Employment Benefits if they meet eligibility requirements. Maternity/Paternity/Adoption Supplemental Employment Benefit (SEB) shall apply to all Employees.