We use cookies on our site to analyze traffic, enhance your experience, and provide you with tailored content.

For more information visit our privacy policy.

AT&T SOUTHWEST REGION 5-STATE Sample Clauses

AT&T SOUTHWEST REGION 5-STATE. “Rate Center” means a uniquely defined geographical location within an Exchange Area (or a location outside the Exchange Area) for which mileage measurements are determined for the application of interstate tariffs.
AT&T SOUTHWEST REGION 5-STATE. As used herein, AT&T SOUTHWEST REGION 5-STATE means Southwestern Bell Telephone Company d/b/a AT&T Arkansas, AT&T Kansas, AT&T Missouri, AT&T Oklahoma and/or AT&T Texas the applicable above listed ILEC(s) doing business in Arkansas, Kansas, Missouri, Oklahoma, and Texas.
AT&T SOUTHWEST REGION 5-STATE. (on behalf of itself and AT&T CONNECTICUT) and AT&T CALIFORNIA will use a Fraud Monitoring System to determine suspected occurrences of ABT-related fraud for CLEC using the same criteria AT&T SOUTHWEST REGION 5-STATE and AT&T CALIFORNIA use to monitor fraud on their respective accounts.
AT&T SOUTHWEST REGION 5-STATE. An initial non-recurring charge applies per state, per brand, per operator assistance switch, for the establishment of Carrier specific branding. An additional non-recurring charge applies per state, per brand, per operator assistance switch for each subsequent change to the branding announcement. In addition, a per call charge applies for every DA call handled by AT&T SOUTHWEST REGION 5-STATE on behalf of Carrier for such services when multiple brands are required on a single Operator Services trunk group.
AT&T SOUTHWEST REGION 5-STATE reserves the right to initiate a one-way IntraLATA Trunk Group to CLEC in order to provide Tandem relief when a community of interest is outside the local Exchange Area in which CLEC is interconnected.
AT&T SOUTHWEST REGION 5-STATE. FCC No. 73, Access Services Tariff, 2Section 13.4.2(B)
AT&T SOUTHWEST REGION 5-STATE s and AT&T CALIFORNIA's LIDB currently accept the following Queries under this Agreement: CNAM Query GetData Query The following Query access to AT&T SOUTHWST REGION 5-STATE's and AT&T CALIFORNIA's LIDB are not available under this Agreement but are available pursuant to effective switched access tariffs, as revised:

Related to AT&T SOUTHWEST REGION 5-STATE

  • AT&T-12STATE acknowledges that CLEC may have an embedded base of one-way trunks ordered and installed prior to the Effective Date of this Agreement that were used for termination of CLEC’s Section 251(b)(5)/IntraLATA Toll Traffic to AT&T-12STATE (Embedded Base). To the extent that CLEC has such an Embedded Base, CLEC shall only augment trunk groups in the Embedded Base with the mutual agreement of the Parties. CLEC shall not order any new one-way trunk groups following the Effective Date of this Agreement. Moreover, the Parties agree that the Embedded Base will be converted to two-way trunk groups under the following circumstances: 4.2.1.1 With reasonable notification from AT&T-12STATE and upon AT&T-12STATE’s request, CLEC shall convert all of its Embedded Base to two-way trunks. 4.2.1.2 At any time an Embedded Base trunk group (either originating or terminating) requires augmentation, AT&T-12STATE can require the associated originating and terminating trunks to be converted to a single two-way trunk group prior to the augmentation. 4.2.1.3 When any network changes are to be performed on a project basis (i.e., central office conversions, tandem re-homes, etc.), upon request and reasonable notice by AT&T-12STATE, CLEC will convert all of its Embedded Base affected by the project within the intervals and due dates required by the project parameters. 4.2.1.4 In addition to the foregoing, CLEC may choose, at any time, to convert its Embedded Base to two-way trunk groups. 4.2.1.5 The Parties will coordinate any trunk group migration, trunk group prioritization and implementation schedule. AT&T-12STATE agrees to develop a cutover plan within thirty (30) days of notification to CLEC of the need to convert pursuant to Section 4.2.1.1 above and Section 4.2.1.3 above.

  • COVID-19 Employees of Contractor and/or persons working on its behalf, including, but not limited to, subcontractors (collectively, “Contractor Personnel”), while performing services under this Agreement and prior to interacting in person with City employees, contractors, volunteers, or members of the public (collectively, “In-Person Services”) must be fully vaccinated against the novel coronavirus 2019 (“COVID-19”). “Fully vaccinated” means that 14 or more days have passed since Contractor Personnel have received the final dose of a two-dose COVID-19 vaccine series (Moderna or Pfizer-BioNTech) or a single dose of a one-dose COVID-19 vaccine (Xxxxxxx & Xxxxxxx/Xxxxxxx) and all booster doses recommended by the Centers for Disease Control and Prevention. Prior to assigning Contractor Personnel to perform In-Person Services, Contractor shall obtain proof that such Contractor Personnel have been fully vaccinated. Contractor shall retain such proof for the document retention period set forth in this Agreement. Contractor shall grant medical or religious exemptions (“Exemptions”) to Contractor Personnel as required by law. If Contractor wishes to assign Contractor Personnel with Exemptions to perform In- Person Services, Contractor shall require such Contractor Personnel to undergo weekly COVID-19 testing, with the full cost of testing to be borne by Contractor. If Contractor Personnel test positive, they shall not be assigned to perform In-Person Services or, to the extent they have already been performing In-Person Services, shall be immediately removed from those assignments. Furthermore, Contractor shall immediately notify City if Contractor Personnel performing In-Person Services (1) have tested positive for or have been diagnosed with COVID-19, (2) have been informed by a medical professional that they are likely to have COVID-19, or (3) meet the criteria for isolation under applicable government orders.

  • Electric Service 1. The Authority shall make available Electric Service to enable the Customer to receive the Allocation in accordance with this Agreement, Service Tariff No. WNY-2 and the Rules. 2. The Customer shall not be entitled to receive Electric Service under this Agreement for any EP and/or RP allocation unless such EP and/or RP allocation is identified in Schedule A. 3. The Authority will provide, and the Customer shall accept and pay for, Electric Service with respect to the Allocation specified in Schedule A. If Schedule C specifies a Takedown Schedule for the Allocation, the Authority will provide, and the Customer shall accept and pay for, Electric Service with respect to the Allocation in accordance with such Takedown Schedule. 4. The Authority shall provide UCAP in amounts necessary to meet the Customer’s NYISO UCAP requirements associated with the Allocation in accordance with the NYISO Tariffs. The Customer shall be responsible to pay the Authority for such UCAP in accordance with Service Tariff No. WNY-2. 5. The provision of Electric Service associated with the Allocation is an unbundled service separate from the transmission and delivery of power and energy to the Customer. The Customer acknowledges and agrees that Customer’s local electric utility, not the Authority, shall be responsible for delivering the Allocation to the Facility specified in Schedule A in accordance with the applicable Utility Tariff(s). 6. The Contract Demand for the Customer’s Allocation may be modified by the Authority if the amount of Firm Power and Firm Energy available for sale as EP or RP from the Project is modified as required to comply with any ruling, order, or decision of any regulatory or judicial body having jurisdiction, including but not limited to FERC. Any such modification will be made on a pro rata basis to all EP and RP customers, as applicable, based on the terms of such ruling, order, or decision. 7. The Contract Demand may not exceed the Allocation. 8. The Customer’s Facility must be metered by the Customer’s local electric utility in a manner satisfactory to the Authority, or another metering arrangement satisfactory to the Authority must be provided (collectively, “Metering Arrangement”). A Metering Arrangement that is not satisfactory to the Authority shall be grounds, after notice to the Customer, for the Authority to modify, withhold, suspend, or terminate Electric Service to the Customer. If a Metering Arrangement is not made to conform to the Authority’s requirements within thirty

  • Television Equipment Recycling Program If this Contract is for the purchase or lease of covered television equipment, then Contractor certifies that it is compliance with Subchapter Z, Chapter 361 of the Texas Health and Safety Code related to the Television Equipment Recycling Program.