CORRECTED NET PLANT CAPACITY Sample Clauses

CORRECTED NET PLANT CAPACITY. OUTPUT The net, as-tested, Capacity output, determined during the test, is based on plant operating conditions. These operating conditions may be different from Standard Operating Conditions (Table 2-1). Net capacity depends on ambient conditions, which are beyond the control of Tenaska. Because of this, if the values of these conditions are different from the Standard Operating Conditions, adjustments will be made to the as-tested generator output to account for these differences. After the as-tested values for each of the one-hour performance runs are calculated, the adjustments will be performed. The correction factors that will be applied to the as-tested gross generator output include the following: -- Compressor inlet temperature -- Barometric pressure A description of the correction method is as follows: kWnetc = kWGTc - kWaux where: kWnetc = Corrected net plant output, kW kWGTc = Gas turbine adjusted gross electrical output, kW (the sum of all corrected gas turbine outputs with each corrected independently such that kWGTc= kWGTxCgtkwCITxCgtkwBP for each unit) kWaux = Auxiliary electrical consumption, including transformer losses, kW CgtkwCIT = Gas turbine electrical output correction for compressor inlet temperature (for each unit) CgtkwBP = Gas turbine electrical output correction for barometric pressure The specific curves used for correcting the Capacity Test to be provided by manufacturers include: Gas Turbine Output vs CIT and Gas Turbine Output vs Barometric Pressure. Corrected net plant output results from the two one-hour performance runs will be arithmetically averaged and rounded off to the nearest 100 kW. This value will be referred to as Corrected Capacity Test Output. No correction for measurement uncertainty will be allowed.
Sample 1Sample 2
AutoNDA by SimpleDocs

Related to CORRECTED NET PLANT CAPACITY

  • Contract Capacity The electric power producing capability of the Generating Facility which is committed to Edison.

  • Local Circuit Switching Capability, including Tandem Switching Capability 4.1.3.1 Definition 4.1.3.2 Notwithstanding BellSouth’s general duty to unbundle local circuit switching, BellSouth shall not be required to unbundle local circuit switching for <<customer_name>> when <<customer_name>> serves end-users with four (4) or more voice-grade (DS-0) equivalents or lines in locations served by BellSouth’s local circuit switches, which are in the following MSAs: Atlanta, GA; Miami, FL; Orlando, FL; Ft. Lauderdale, FL; Charlotte-Gastonia-Rock Hill, NC; Greensboro-Winston Salem-High Point, NC; Nashville, TN; and New Orleans, LA, and BellSouth has provided non-discriminatory cost based access to the Enhanced Extended Link (EEL) throughout Density Zone 1 as determined by NECA Tariff No. 4 as in effect on January 1, 1999. 4.1.3.3 In the event that <<customer_name>> orders local circuit switching for a single end user account name at a single physical end user location with four (4) or more 2-wire voice-grade loops from a BellSouth central office in an MSA listed above, BellSouth shall charge <<customer_name>> the market based rate in Exhibit C for use of the local circuit switching functionality for the affected facilities. 4.1.3.4 A featureless port is one that has a line port, switching facilities, and an interoffice port. A featured port is a port that includes all features then capable or a number of then capable features specifically requested by <<customer_name>>. Any features that are not currently then capable but are technically feasible through the switch can be requested through the NBR/BFR process. 4.1.3.5 BellSouth will provide to <<customer_name>> customized routing of calls: (i) to a requested directory assistance services platform; (ii) to an operator services platform pursuant to Section 10 of Attachment 2; (iii) for <<customer_name>>’s PIC’ed toll traffic in a two (2) PIC environment to an alternative OS/DA platform designated by <<customer_name>>. <<customer_name>> customers may use the same dialing arrangements as BellSouth customers. 4.1.3.6 Remote Switching Module functionality is included in Switching Capability. The switching capabilities used will be based on the line side features they support. 4.1.3.7 Switching Capability will also be capable of routing local, intraLATA, interLATA, and calls to international customer’s preferred carrier; call features (e.g. call forwarding) and Centrex capabilities. 4.1.3.8 Where required to do so in order to comply with an effective Commission order, BellSouth will provide to <<customer_name>> purchasing local BellSouth switching and reselling BellSouth local exchange service under Attachment 1, selective routing of calls to a requested directory assistance services platform or operator services platform. <<customer_name>> customers may use the same dialing arrangements as BellSouth customers, but obtain a <<customer_name>> branded service.

  • FREQUENCY AND CAPACITY LEVELS No restriction on frequency, capacity or aircraft type.

  • Casual Labour 19.1.1 A casual employee is an employee employed on an occasional basis and whose work pattern is not regular and systematic. When a person is engaged for casual employment the employee will be informed in writing that the employee is to be employed as a casual, the job to be performed, the classification level, the actual or likely length of engagement including number of hours to be worked per week, and the relevant rate of pay. 19.1.2 A casual employee shall be entitled to all the applicable rates and conditions of employment prescribed in this Agreement except annual leave, personal leave, parental leave, jury service and public holidays. 19.1.3 On each occasion a casual employee is required to attend work the employee shall be entitled to payment for a minimum of four hours work plus the relevant fares and travel allowance. 19.1.4 A casual employee for working ordinary hours shall be paid 125 percent of the hourly rate prescribed in this Agreement for the employees’ classification. 19.1.5 A casual employee required to work overtime or weekend shall be entitled to the relevant penalty rates prescribed in this Agreement provided that: Where the relevant penalty rate is time and a half the employee shall be paid 175 percent of the hourly rate prescribed in this Agreement for the employee’s classification and where the relevant penalty rate is double time the employee shall be paid 225 percent of the hourly rate prescribed in this Agreement for the employee's classification. 19.1.6 A casual employee required to work on a public holiday shall be paid 275 percent of the hourly rate prescribed in this Agreement for the employee's classification. 19.1.7 Termination of all casual employment shall require one hours notice on either side or the payment or forfeiture of one hours pay, as the case may be.

  • Independent Capacity of Contractor The Contractor and Contractor Parties shall act in an independent capacity and not as officers or employees of the state of Connecticut or of the Agency.

  • CLEC OUTAGE For a problem limited to one CLEC (or a building with multiple CLECs), BellSouth has several options available for restoring service quickly. For those CLECs that have agreements with other CLECs, BellSouth can immediately start directing traffic to a provisional CLEC for completion. This alternative is dependent upon BellSouth having concurrence from the affected CLECs. Whether or not the affected CLECs have requested a traffic transfer to another CLEC will not impact BellSouth's resolve to re-establish traffic to the original destination as quickly as possible.

  • INDEPENDENT CAPACITY The employees or agents of each party who are engaged in the performance of this Agreement shall continue to be employees or agents of that party and shall not be considered for any purpose to be employees or agents of the other party.

  • Power Factor Design Criteria (Reactive Power A wind generating plant shall maintain a power factor within the range of 0.95 leading to 0.95 lagging, measured at the Point of Interconnection as defined in this LGIA, if the ISO’s System Reliability Impact Study shows that such a requirement is necessary to ensure safety or reliability. The power factor range standards can be met using, for example without limitation, power electronics designed to supply this level of reactive capability (taking into account any limitations due to voltage level, real power output, etc.) or fixed and switched capacitors if agreed to by the Connecting Transmission Owner for the Transmission District to which the wind generating plant will be interconnected, or a combination of the two. The Developer shall not disable power factor equipment while the wind plant is in operation. Wind plants shall also be able to provide sufficient dynamic voltage support in lieu of the power system stabilizer and automatic voltage regulation at the generator excitation system if the System Reliability Impact Study shows this to be required for system safety or reliability.

  • SLEEPING CAPACITY/DISTURBANCES Tenant and all other occupants will be required to vacate the premises and forfeit the rental fee and security deposit for any of the following: Occupancy exceeding the sleeping capacity, using the premises for any illegal activity, causing damage to the premises rented or to any of the neighboring properties and any other acts which interfere with neighbors' right to quiet enjoyment of their premises. iTrip or the Owner, does not assume any liability for loss, damage or injury to persons or their personal property. Neither does the owner accept any liability for any inconveniences, damage, loss or injury arising from any temporary defects or stoppage in supply of water, gas, cable service, electricity or plumbing, as well as due to weather conditions, natural disasters, acts of God, or other reasons beyond its control. Tenant hereby acknowledges that the premises they have reserved may include a pool and the undersigned agrees and acknowledges that the pool and patio/deck can be dangerous areas, that the deck/patio can be slippery when wet, and that injury may occur to anyone who is not careful. With full knowledge of the above facts and warnings, the undersigned Tenant accepts and assumes all risks involved to Tenant and all of Tenant's guests in or related to the use of the community pool and patio areas.

  • INDEPENDENT CAPACITY OF THE CONTRACTOR The parties intend that an independent contractor relationship will be created by this contract. The CONTRACTOR and his or her employees or agents performing under this contract are not employees or agents of the AGENCY. The CONTRACTOR will not hold himself/herself out as or claim to be an officer or employee of the AGENCY or of the State of Washington by reason hereof, nor will the CONTRACTOR make any claim of right, privilege or benefit that would accrue to such employee under law. Conduct and control of the work will be solely with the CONTRACTOR.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!