Design and Installation of Remote Grid System Sample Clauses

Design and Installation of Remote Grid System. The Supplemental Provisions Agreement addresses the design and installation of the SPS, noting that the installed capacity of the system will be determined based on the Applicant’s then-existing load and energy usage. Should the Applicant have a need for increased load subsequent to the date PG&E is first ready to provide service, PG&E will work with the Applicant to optimize the Applicant’s demand profile. Should the Applicant request an increase in the system peak power and maximum energy usage after the date PG&E is first ready to provide service, PG&E will determine whether it can safely increase the installed capacity of the system. Any reinforcement or replacement of the SPS to serve incremental load would be treated in the same manner as for Distribution Lines under the new line extension provisions of Electric Rules 15 and 16. As a practical matter, the application of these existing Rules to these distribution assets means that a Remote Grid customer would not be charged for changes to the Remote Grid system’s distribution facilities to accommodate reasonable increases (such as increases within the existing capacity of the customer service panel) in the customer’s capacity or energy requirements. This is consistent with existing standards for PG&E to maintain a robust distribution system to serve existing and future loads. That said, the existing Rules allow PG&E to seek approval to allocate costs differently for exceptional cases involving very large changes in load, and those same Rules would apply in the Remote Grid scenario. Service Facilities that extend from the SPS equipment area to the Service Delivery Point would continue to be the customer’s cost responsibility as dictated by Rule 16.
AutoNDA by SimpleDocs

Related to Design and Installation of Remote Grid System

  • INSTALLATION AND REMOVAL Show Management reserves the right to fix the time for the installation of a booth prior to the Show opening and for its removal after the conclusion of the Show. Installation of all exhibits must be fully completed by the opening time of the exposition. Any space not claimed and occupied three hours prior to opening, may be resold or reassigned without refund. No exhibitor will be allowed to dismantle or repack any part of his exhibit until after the closing of the Show. 6.

  • Delivered and Installed Off loaded, and installed. Installation shall include but not limited to; any and all labor, material, and tools necessary to install furniture in accordance with approved plans and specifications and/or the direction of authorized agency personnel. The installation company will be responsible for the removal of any trash, packing material, and cartons associated with their installation. The contractor/installation company will repair/replace (to the satisfaction of the ordering entity) any damage to the building or its’ contents that they (the contractor) caused in the course of their work. This includes but is not limited to: walls, floors, floor coverings, ceilings, elevators, doors, doorways, and any existing fixtures and furniture. The agency may withhold payment until repairs are satisfactorily completed.

  • Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract.

  • Responsibility for Quality of Materials and Installation Contractor acknowledges that he has full, total, and complete responsibility for providing materials, labor, and all other items necessary for providing the level of quality specified in the Contract Documents. He agrees that this responsibility is indivisible, non-delegable, non- transferable, and not diminished by any inspections provided by the Design Professional or his consulting engineers, nor by any inspections provided by the Owner. In recognition of this, Contractor will prepare for submission and review by the Design Professional, a written program describing the efforts that will be taken to insure the proper quality level is achieved. The program shall be submitted prior to the issuance of a Proceed Order.

  • Licenses for Permanent Installation The contractor must comply with all State mandatory licensing requirements prior to installation. Questions on licensing requirements should be directed to the State Licensing Board. Contractor must furnish and install all furniture and materials in compliance with all applicable codes, whether local, state, or federal; and that all permits or licenses required for installation will be obtained without cost to the State.

  • System Upgrade Facilities and System Deliverability Upgrades Connecting Transmission Owner shall design, procure, construct, install, and own the System Upgrade Facilities and System Deliverability Upgrades described in Appendix A hereto. The responsibility of the Developer for costs related to System Upgrade Facilities and System Deliverability Upgrades shall be determined in accordance with the provisions of Attachment S to the NYISO OATT.

  • Graffiti Removal Graffiti is detrimental to the health, safety and welfare of the community in that it promotes a perception in the community that the laws protecting public and private property can be disregarded with impunity. This perception fosters a sense of disrespect of the law that results in an increase in crime; degrades the community and leads to urban blight; is detrimental to property values, business opportunities and the enjoyment of life; is inconsistent with the City’s property maintenance goals and aesthetic standards; and results in additional graffiti and in other properties becoming the target of graffiti unless it is quickly removed from public and private property. Graffiti results in visual pollution and is a public nuisance. Graffiti must be abated as quickly as possible to avoid detrimental impacts on the City and County and its residents, and to prevent the further spread of graffiti.

  • Snow Removal Only the right of way will be plowed in the parking lots. Licensee is responsible for removing snow around his/her own vehicle (without causing damage or inconvenience to any other vehicles lawfully on the Premises).

  • Maintenance, Alteration and Repair (a) Resident is responsible for and agrees to take good care of the premises, fixtures and all common areas. Resident may not remove any of Owner’s property and will not perform any repairs, upgrades, painting, wallpapering, electric changes or other alterations of the premises without prior written consent from Owner. Resident will be responsible for damage from waste stoppages caused by foreign or improper objects or improper use in lines serving bathrooms, damage to fixtures, appliances, doors, windows, screens, damage from water faucets left on or from doors left open, and repairs or replacements to alarm devices necessitated by misuse or damage by Resident and/or guests. Extraordinary appliances or furnishings such as satellite dishes, hot tubs, pool tables, water beds or high utility-consuming devices may not be installed or placed on the premises or anywhere at the Property without Owner’s prior written consent, in its sole discretion. SAMPLE

  • Delivery and Installation Delivery

Time is Money Join Law Insider Premium to draft better contracts faster.