DRAWINGS AND COORDINATION WITH OTHER WORK Sample Clauses

DRAWINGS AND COORDINATION WITH OTHER WORK. A. Exact routing of wiring and locations of outlets, panels, etc., shall be governed by structural conditions, obstructions and existing conditions. Architect / Engineer reserves right, at no increase in price, to make any reasonable change in locations of electrical items, exposed at ceiling and/or on walls, to group them into orderly relationships and/or increase their utility. Contractor shall verify Architects / Engineer requirements in this regard prior to roughing-in. B. Dimensions, location of doors, partitions, and similar physical features shall be taken from architectural drawings for exact location of outlets to center with Architectural features, panels, etc., at the approximate location shown on Electrical Drawings. C. Verify dimensions and the correct location of equipment and coordinate with other trades for any requirement, notify University’s Representative of all changes of location requirements before proceeding with the roughing-in of connection. D. Mounting heights of brackets, outlets, etc., shall be as required to suit equipment served. E. Drawings indicate, generally, routes of all branch circuits. All runs to panels are indicated as starting from nearest outlet, pointing in direction of panel. Continue all such circuits to panel as though routes were indicated in their entirety. F. All scaled and figured dimensions are approximate of typical equipment of the class indicated. Before proceeding with any Work, carefully check and verify all dimensions, sizes, and mounting requirements with the approved submittals and drawings to see that the equipment being installed will fit into the spaces provided. G. The Contractor shall be responsible for verifying that equipment being provided will fit dimensionally in locations shown on Drawings.
Sample 1
AutoNDA by SimpleDocs

Related to DRAWINGS AND COORDINATION WITH OTHER WORK

  • Construction With Other Parts Of The Tariff This ISA shall not be construed as an application for service under Part II or Part III of the Tariff.

  • Additional Work If changes in the work seem merited by Consultant or the City, and informal consultations with the other party indicate that a change is warranted, it shall be processed in the following manner: a letter outlining the changes shall be forwarded to the City by Consultant with a statement of estimated changes in fee or time schedule. An amendment to this Agreement shall be prepared by the City and executed by both Parties before performance of such services, or the City will not be required to pay for the changes in the scope of work. Such amendment shall not render ineffective or invalidate unaffected portions of this Agreement.

  • Other Activities/Renovations A. The Contractor acknowledges its responsibility to assure the Judicial Council’s quiet enjoyment of the Program and to provide the full service level of the Property for the Program, free from outside distractions, disturbances, and/or interruptions. The Contractor shall avoid assigning any rooms to the Judicial Council or the Attendees during the Program which are adjacent to or across from any group or activity that may generate noise or other distractions, such as construction or other conduct, sufficient to detract from quiet enjoyment of the Program on the Property. B. Additionally, the Contractor shall notify the Judicial Council of any actual or contemplated renovations or other construction that will or may occur on or adjacent to the Property during the Program, no later than fourteen (14) Days from the time the Contractor learns of such renovation or construction activity. C. For any disturbance, renovation, or construction activity that is potentially or actually inconvenient or disruptive to the Program, upon the Judicial Council’s request, the Contractor shall: i. Immediately cause such disturbance to cease, if possible, or suspend or minimize construction or renovation on the Property, if necessary, in order to maintain a proper environment for the Program; and/or ii. Immediately provide equivalent alternate space on the Property, satisfactory to the Program Manager, conducive to conducting the Program in a proper environment. D. If the Contractor is unable to comply with the conditions set forth in this provision, the Judicial Council may terminate the Agreement pursuant to the termination for cause provision set forth herein.

  • Construction Activities Please list all major construction activities, both planned and completed, to be performed by Seller or the EPC Contractor. Activity EPC Contractor / Subcontractor Completion Date __/__/____ (expected / actual) __/__/____ (expected / actual)

  • Construction Work The regulation at 41 C.F.R. § 60-1.3 defines “construction work” as the construction, rehabilitation, alteration, conversion, extension, demolition or repair of buildings, highways, or other changes or improvements to real property, including facilities providing utility services. The term also includes the supervision, inspection, and other onsite functions incidental to the actual construction.

  • Drawings and Specifications 9.1 A complete list of all Drawings that form a part of the Contract Documents are to be found as an index on the Drawings themselves, and/or may be provided to Developer and/or in the Table of Contents. 9.2 Materials or Work described in words that so applied have a well-known technical or trade meaning shall be deemed to refer to recognized standards, unless noted otherwise. 9.3 Trade Name or Trade Term It is not the intention of the Contract Documents to go into detailed descriptions of any materials and/or methods commonly known to the trade under “trade name” or “trade term.” The mere mention or notation of “trade name” or “trade term” shall be considered a sufficient notice to Developer that it will be required to complete the work so named, complete, finished, and operable, with all its appurtenances, according to the best practices of the trade. 9.4 The naming of any material and/or equipment shall mean furnishing and installing of same, including all incidental and accessory items thereto and/or labor therefor, as per best practices of the trade(s) involved, unless specifically noted otherwise. 9.5 Contract Documents are complementary, and what is called for by one shall be binding as if called for by all. As such, Drawings and Specifications are intended to be fully cooperative and to agree. However, if Developer observes that Drawings and Specifications are in conflict with the Contract Documents, Developer shall promptly notify District and Architect in writing, and any necessary changes shall be made as provided in the Contract Documents. 9.6 Figured dimensions shall be followed in preference to scaled dimensions, and Developer shall make all additional measurements necessary for the work and shall be responsible for their accuracy. Before ordering any material or doing any work, each Developer shall verify all measurements at the building and shall be responsible for the correctness of same. 9.7 Should any question arise concerning the intent or meaning of the Contract Documents, including the Plans and Specifications, the question shall be submitted to the District for interpretation. If a conflict exists in the Contract Documents, these Construction Provisions shall control over the Facilities Lease, which shall control over the Site Lease, which shall control over Division 1 Documents, which shall control over Division 2 through Division 49 documents, which shall control over figured dimensions, which shall control over large-scale drawings, which shall control over small-scale drawings. In no case shall a document calling for lower quality and/or quantity of material or workmanship control. However, in the case of discrepancy or ambiguity solely between and among the Drawings and Specifications, the discrepancy or ambiguity shall be resolved in favor of the interpretation that will provide District with the functionally complete and operable Project described in the Drawings and Specifications. 9.8 Drawings and Specifications are intended to comply with all laws, ordinances, rules, and regulations of constituted authorities having jurisdiction, and where referred to in the Contract Documents, the laws, ordinances, rules, and regulations shall be considered as a part of the Contract Documents within the limits specified. 9.9 As required by Section 4-317(c), Part 1, Title 24, CCR: “Should any existing conditions such as deterioration or non-complying construction be discovered which is not covered by the DSA-approved documents wherein the finished work will not comply with Title 24, California Code of Regulations, a construction change document, or a separate set of plans and specifications, detailing and specifying the required repair work shall be submitted to and approved by DSA before proceeding with the repair work.”

  • ACCESS AND COOPERATION; DUE DILIGENCE (i) Between the date of this Agreement and the Closing Date, the COMPANY will afford to the officers and authorized representatives of URSI and the Founding Companies other than the COMPANY access to all of the COMPANY's (including the COMPANY's Subsidiaries) key employees, sites, properties, books and records and will furnish URSI with such additional financial and operating data and other information as to the business and properties of the COMPANY (including the COMPANY's Subsidiaries) as URSI or the Founding Companies other than the COMPANY may from time to time reasonably request. The COMPANY will cooperate with URSI and the Founding Companies other than the COMPANY, its representatives, auditors and counsel in the preparation of any documents or other material which may be required in connection with any documents or materials required by this Agreement. URSI, the STOCKHOLDERS and the COMPANY will treat all information obtained in connection with the negotiation and performance of this Agreement or the due diligence investigations conducted with respect to the Founding Companies other than the COMPANY as confidential in accordance with the provisions of Section 14 hereof. In addition, URSI will cause each of the Founding Companies other than the COMPANY to enter into a provision similar to this Section 7.1 requiring each such Founding Company to keep confidential any information obtained by such Founding Company. (ii) Between the date of this Agreement and the Closing Date, URSI will afford to the officers and authorized representatives of the COMPANY access to all of URSI's sites, properties, books and records and will furnish the COMPANY with such additional financial and operating data and other information as to the business and properties of URSI as the COMPANY may from time to time reasonably request. URSI will cooperate with the COMPANY, its representatives, engineers, auditors and counsel in the preparation of any documents or other material which may be required in connection with any documents or materials required by this Agreement. The COMPANY will cause all information obtained in connection with the negotiation and performance of this Agreement to be treated as confidential in accordance with the provisions of Section 14 hereof.

  • Coordination with Workers' Compensation When an employee has incurred an on-the- job injury or an on-the-job disability and has filed a claim for workers' compensation, medical costs connected with the injury or disability shall be paid by the employee's health plan, pursuant to M.S. 176.191, Subdivision 3.

  • Project Work PURCHASER shall complete the following projects in accordance with the specifications provided in Exhibits B, C, D, E, and F and written instructions from STATE. Project locations are shown on Exhibit A unless otherwise described. PURCHASER shall furnish all material unless otherwise specified.

  • Completion of Due Diligence Each Purchaser shall have completed its legal, business and financial due diligence of the Company to its full satisfaction and shall be fully satisfied with the results thereof.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!