Federal [and State] Historic Credit Initial Year Adjuster Sample Clauses

Federal [and State] Historic Credit Initial Year Adjuster. In addition to any other adjustment to the Limited Partner’s Capital Contribution or payments required under this Section 3.3, following placement of the Project in service pursuant to Section 47 of the Code, if the Federal Historic Credits allocated to the Limited Partner for 20 are then determined to be less than the Projected Credit Amount for such Federal Historic Credits on Exhibit A-3 because the Project is not placed in service in 20 for purposes of qualifying for Federal Historic Credits in such year [and/or the State Historic Credits allocated to the Limited Partner for 20 are then determined to be less than the Projected Credit Amount for such State Historic Credits on Exhibit A-3 because the Project is not placed in service in 20 for purposes of qualifying for State Historic Credits in such year], then the Capital Contribution of the Limited Partner to the Partnership shall be reduced by an amount equal to the Projected Federal Historic Credit minus the actual Federal Historic Credit, if any, allocated to the Limited Partner for 20 , which amount shall be multiplied by [$TBD] [and/or the Capital Contribution of the Limited Partner to the Partnership shall be reduced by an amount equal to the Projected State Historic Credit minus the actual State Historic Credit, if any, allocated to the Limited Partner for 20 , which amount shall be multiplied by [$TBD]] ([collectively,] the “Historic Timing Reduction Amount”). Any reduction in the Limited Partner’s Capital Contribution caused by the Historic Timing Reduction Amount shall first be applied to reduce any unfunded Capital Contributions (in the chronological order of such unfunded Capital Contributions). If the amount of the Historic Timing Adjustment Amount is greater than all unfunded Capital Contributions, then the General Partner shall immediately make a Credit Adjuster Advance, in the aggregate amount set forth in, and pursuant to, Section 3.3(i). It is understood and agreed that the provisions of this Section 3.3(d) are intended to address any delays in the delivery of Federal Historic Credits, but only after Federal Historic Credits have been adjusted pursuant to Section 3.3(a). It is intended that the adjustments and/or payments required by this Section 3.3(d) are to compensate the Limited Partner for the delay in the receipt of Federal Historic Credits.
Sample 1
AutoNDA by SimpleDocs

Related to Federal [and State] Historic Credit Initial Year Adjuster

  • Please see the current Washtenaw Community College catalog for up-to-date program requirements Secondary / Post-Secondary Program Alignment Welding HIGH SCHOOL COURSE SEQUENCE 9th Grade 10th Grade 11th Grade 12th Grade English 9 Algebra I World History/Geography Biology World Language Phys Ed/Health English 10 Geometry U.S. History/Geography Physics or Chemistry World Language Visual/Performing/Applied Arts English 11 Algebra II Civics/Economics Welding English 12 Math Credit Science Credit Welding WASHTENAW COMMUNITY COLLEGE Welding Associate in Applied Science Semester 1 Math Elective(s)* 3 WAF 105 Introduction to Welding Processes 2 WAF 111 Oxy-fuel Welding 4 WAF 112 Shielded Metal Arc Welding 4 Semester Total 13 Semester 2 Speech Elective(s) 3 WAF 106 Blueprint Reading for Welders 3 WAF 123 Advanced Oxy-fuel Welding 4 WAF 124 Advanced Shielded Metal Arc Welding 4 Semester Total 14 Semester 3 Arts/Human. Elective(s) 3 Computer Lit. Elective(s) 3 WAF 215 Advanced Gas Tungsten Arc Welding 4 WAF 288 Gas Metal Arc Welding 4 Semester Total 14 Semester 4 WAF 200 Layout Theory Welding 3 WAF 210 Welding Metallurgy 3 Soc. Sci. Elective(s) 3 WAF 226 Specialized Welding Procedures 4 Semester Total 13 Semester 5 Nat. Sci. Elective(s) 4 WAF 227 Basic Fabrication 3 WAF 229 Shape Cutting Operations 3 Writing Elective(s) 3 Semester Total 13 Program Totals 67

  • OFFSET CREDIT/COOPERATION This Contract has been entered into in direct support of LOCKHEED XXXXXX'x international offset programs. All offset benefit credits resulting from this Contract are the sole property of LOCKHEED XXXXXX to be applied to the offset program of its choice. SELLER shall assist LOCKHEED XXXXXX in securing appropriate offset credits from the respective country government authorities.

  • State of New York Executive Department Office of General Services Procurement Services ‌ Corning Tower - 00xx Xxxxx Xxxxxx Xxxxx Xxxxx Xxxxxx, XX 00000 THIS CONTRACT (hereinafter “Contract” or “Centralized Contract”) for the acquisition of Project Based Information Technology Consulting Services is made between the People of the State of New York, acting by and through the Commissioner of the Office of General Services (hereinafter “State” or “OGS”) whose principal place of business is the 41st Floor, Corning Tower, The Governor Xxxxxx X. Xxxxxxxxxxx Empire Xxxxx Xxxxx, Xxxxxx, Xxx Xxxx 00000, pursuant to authority granted under New York State Finance Law §163, and SVAM INTERNATIONAL, INC. (hereinafter “Contractor”), with its principal place of business at 000 Xxxx Xxxxx Xxxx, Xxxxx 000, Xxxxx Xxxx, XX 00000. The foregoing are collectively referred to as the “Parties.”

  • Credit Union Examination We may disregard any information on any check or draft other than the signature of the drawer, the amount, and any magnetic encoding. You agree that we do not fail to exercise ordinary care in paying an item solely because our procedures do not provide for sight examination of items.

  • BUY AMERICA REQUIREMENT (Applies only to Federally Funded Highway and Transit Projects) With respect to products purchased by Customer for use in federally funded highway projects, Contractor shall comply with all federal procurement laws and regulations with respect to such projects, including the Buy American provisions set forth in 23 U.S.C. Section 313, 23 C.F.R. Section 635.410, as amended, and the Steel and Iron Preference provisions of Texas Transportation Code Section 223.045, to the extent applicable. Contractor agrees to provide all certifications required by Customer regarding such programs. With respect to products purchased by Customer for use in federally funded transit projects, Contractor shall comply with all federal procurement laws and regulations with respect to such projects, including the Buy American provisions set forth in 49 U.S.C. Section 5323(j)(1), 49 C.F.R. Sections 661.6 or 661.12, to the extent applicable. Contractor agrees to provide all certifications required by Customer regarding such programs.

  • Benefit to Citizens of Xxxxxxx County The safety of the citizens of Xxxxxxx County is enhanced through this Agreement, which promotes safe boating conditions and reduces costs associated with patrols of recreational waterways.

  • Extended Health Plan (a) The Employer will pay 100% of the monthly premiums for the extended health care plan that will cover the employee, their spouse and dependent children, provided they are not enrolled in another plan.

  • Extended Health Care The Hospital shall contribute on behalf of each eligible employee seventy-five percent (75%) of the billed premium under the Extended Health Care Plan (Liberty Health $15-25 deductible plan including hearing aids with a maximum of $300.00 per person and vision care with a maximum of $150.00 every 24 months per person, or its equivalent) provided the balance of the monthly premium is paid by employees through payroll deduction. Any Hospital currently paying more than 75% of the premium shall continue to do so. The drug formulary shall be as defined by Liberty Health Formulary Three.

  • CFR PART 200 Domestic Preferences for Procurements As appropriate and to the extent consistent with law, the non-Federal entity should, to the greatest extent practicable under a Federal award, provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). The requirements of this section must be included in all subawards including all contracts and purchase orders for work or products under this award. For purposes of 2 CFR Part 200.322, “Produced in the United States” means, for iron and steel products, that all manufacturing processes, from the initial melting stag through the application of coatings, occurred in the United States. Moreover, for purposes of 2 CFR Part 200.322, “Manufactured products” means items and construction materials composed in whole or in part of non-ferrous metals such as aluminum, plastics and polymer-based products such as polyvinyl chloride pipe, aggregates such as concrete, class, including optical fiber, and lumber. Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, Vendor certifies that to the greatest extent practicable Vendor will provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). Does vendor agree? Yes

  • Extended Health Care Plan (a) The Employer shall pay the monthly premium for regular employees entitled to coverage under a mutually acceptable Extended Health Care Plan.

Time is Money Join Law Insider Premium to draft better contracts faster.