Floor Drains. Clean, disinfect, and fill with water to avoid the escape of sewer gasses. No acids are permitted.
Floor Drains. Contractor must maintain floor drains so that they do not smell. Contractor must pour approximately one cup of City approved disinfectant/enzyme cleaner down each restroom floor drain, as needed.
Floor Drains. 75 Rofo Engineering grade AISI 304 stainless steel RO 200 NW 100 square floor drain with perforated circular grating pattern (Code: RO200HNW100SQ) suitable for screeded floor, size 240 x 210mm deep, with 104 diameter horizontal waste outlet with mitred bend connected to waste pipe. No 2 Section No. 2 BUILDING WORKS Bill No. 11 76 "Everyway" hose reel complete with 30m plastic hose, chromium plated stopcock, shut-off nozzle and wall bracket No 8 77 4.5 Litre water fire extinguisher No 8 78 4.5 Litre foam fire extinguisher No 8 Section No. 2 BUILDING WORKS Bill No. 11 Section No. 2 Bill No. 11 PLUMBING AND DRAINAGE
Floor Drains. 16.4.1.1. Ensure all floor drains are filled with at least 2 gallons of water twice per month to prevent p-traps from drying out. The date maintenance was performed should be marked on calendar in the custodial closet at each building location.
Floor Drains. Clean, disinfect and fill with water to avoid the escape of sewer gasses.
Floor Drains. Existing floor drains are to be maintained free of obstructions at all times. Tenant is to install concrete containment curbs and floor drains at tenant installed hot water heaters or other water source equipment.
Floor Drains. Clean, disinfect, and fill with water to avoid the escape of sewer gases. Use of acids is prohibited.
Floor Drains. A minimum 0.75” ID, marine/commercial quality stainless steel floor drain shall be installed aft of all four wheel housings and as close to the wall as practical. The drains shall be routed to dump aft of the splash aprons. The drains, by design, shall not allow moisture or dust to enter the vehicle from the exterior. The purpose of the drain is to allow for rapid drainage of interior cleaning water. The drain design and installation locations require approval during pre- production meetings with the contractor.
Floor Drains. Remove all built up deposits, embedded hairs, etc., from the grate and neck of the drain. Replace the grate properly. Clean the inside of the drain by pouring at least one gallon of 50/50 mixture of clean water/disinfectant through the drain.
Floor Drains. Watts FD-100-A epoxy coated cast iron with bronze strainer.
