Grade A Gas Fitting Training Course Sample Clauses

Grade A Gas Fitting Training Course. Grade A training courses are available to employees through night school or college. This training course totals approximately 160 hours and requires an additional 80 hours with approximately 40 hours of theoretical and 40 hours of field training. This additional 80 hours of daytime training will be provided by the Company which will pay the employee forty hours at regular straight-time rates. The employee will absorb the remaining 40 hours through annual vacation, vacation overtime leave or other banked time.
AutoNDA by SimpleDocs

Related to Grade A Gas Fitting Training Course

  • Travelling, Transport and Fares (a) An employee required and authorised to use their own motor vehicle in the course of their duties will be paid not less than the allowance set out in item 21 in Table 2.

  • Training Courses 16.3.1 Training courses will be as described in the Seller’s customer services catalog (the “Seller’s Customer Services Catalog”). The Seller’s Customer Services Catalog also sets forth the minimum and maximum number of trainees per course. All training requests or training course changes made outside of the scope of the Training Conference will be submitted by the Buyer with a minimum of ***** prior notice.

  • Stewards Training Courses 22.6.1 Where operational requirements permit, the Council may grant leave without pay to a xxxxxxx to undertake training related to the duties of a xxxxxxx.

  • Occupational First Aid Requirements and Courses (a) The Union and the Employer agree that First Aid Regulations made pursuant to the Workers' Compensation Act shall be fully complied with.

  • Representatives’ Training Courses When operational requirements permit, the Employer will grant leave without pay to employees who exercise the authority of a representative on behalf of the Association to undertake training related to the duties of a representative.

  • Transporting Students Teachers shall not be required to transport a student in a private vehicle on behalf of the school.

  • Scaling Locations, Rules, and Organizations All logs from timber sold under the terms and conditions of this contract shall be: (1) scaled at a location approved in writing by STATE; (2) scaled by a third-party scaling organization with a current agreement with STATE; and (3) scaled using the Official Log Scaling and Grading Rules (as adopted by the Northwest Log Rules Advisory Group) and STATE special service scaling instructions in effect at the time the logs are scaled. Utilization scale shall be handled in accordance with the section titled, “Utilization Scale.” PURCHASER shall enter into a written agreement with a third-party scaling organization for the scaling of logs removed from the timber sale area. PURCHASER shall furnish STATE with a copy of the scaling agreement upon request. If logs are delivered when a TPSO scaler is not present, PURCHASER must provide STATE with a method to assure protection and accountability. PURCHASER shall provide STATE with remote check scaling opportunities for logs scaled under this contract. The last two loads at each delivery point shall be continuously available for checking. They shall remain available for a minimum of 48 hours unless replaced by other STATE loads. They shall be available as originally presented for scaling; i.e., if truck scaled, they shall be presented in bunks. In the event scaling is suspended for any reason, hauling operations shall be immediately suspended until approved alternate scaling services are provided, or service by the scaling organization is resumed.

  • GEOGRAPHIC AREA AND SECTOR SPECIFIC ALLOWANCES, CONDITIONS AND EXCEPTIONS The following allowances and conditions shall apply where relevant: Where the company does work which falls under the following headings, the company agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.

  • PREVAILING WAGE RATES - PUBLIC WORKS AND BUILDING SERVICES CONTRACTS If any portion of work being Bid is subject to the prevailing wage rate provisions of the Labor Law, the following shall apply:

  • Solicitations for Subcontracts, Including Procurement of Materials and Equipment In all solicitation, either by competitive bidding or negotiation, made by the Contractor for work to be performed under a subcontract, including procurement of materials or leases of equipment, each potential Subcontractor or supplier shall be notified by the Contractor of the Contractor’s obligations under this Agreement and the Regulations relative to non-discrimination on the grounds of race, color, or national origin.

Time is Money Join Law Insider Premium to draft better contracts faster.