Handrails Sample Clauses

Handrails. Stainless Steel Handrails with Glass shall be used in Staircase Areas and Double Ceiling Floor Areas Cost based on Cost constraints and Elevation. Cables: Hosper or V-Guard Switches & Sockets: Modular switches & sockets from Hosper or Anchor All Final Fittings such as Fancy Lightings & ceiling Fans should be provided by the client at site. For Common Electrical commercial EB line charges monthly will be paid by land owner. Distributor Board will be provided as per Site Requirement. Electrical provisions flexible to Site condition and Client Requirement.

Handrails. Sometimes a handrail needs to be removed before we install the stairlift. We would normally ask you to arrange for a local tradesman to do this. We may agree to remove your handrail free of charge. However, we will not carry out remedial work (such as replastering and redecorating) afterwards. We also will not fit the handrail somewhere else. If you would like us to carry out any remedial work or fit the handrail somewhere else, we could arrange for one of our subcontractors to do this for an extra charge.

Handrails. Ramp runs with a rise greater than 6 inches (150 mm) shall have handrails complying with 505. o See Figure 9 for required compliance  Garage Near Building 6: install handrails and edge protection above curb at ramp.

Handrails. It is required that handrails are used for both sets of stairs.

Handrails. Ramps with a rise greater than 6 in (150 mm) or a run greater than 72 in (1830 mm) shall have handrails complying with 4.3.10 and 4.3.11.  See Figures 12 and 9 for required compliance  Near Unit #1218: o Install accessible curb ramps at crosswalk along the accessible route

Handrails. Clean all handrails with proper cleaning solution of all dust, smudges, handprints and fingerprints. Remove graffiti.

Handrails. The design of handrails / guardrails is included for stairs that we design (see above), catwalks that we design, seating balconies, and lobbies. Handrails / guardrails for bidder-designed stairs will be a bidder-designed element.

Handrails a. The gripping surface of the railings on the ramp that serves the dock does not comply with the Standards because a person with a mobility impairment cannot grip around the top rail and the gripping surface does not extend beyond the top and bottom of the ramp. Provide railings for the ramp that comply with the Standards. §§ 4.1.3(1), 4.3.7, 4.8.5, 4.26.2. b. There is no inside handrail on the ramp. Provide handrails on the both sides of the ramp that are between 34 and 38 inches high. Provide extensions of at least 12 inches beyond the top and bottom of the ramp segment, and have ends that are rounded or returned to the floor, wall, or post and otherwise comply with the Standards. §§ 4.1.3(1), 4.3.7, 4.8.5(1), 4.26.

Handrails a. Balcony: SS handrails in lay with toughened glass as approved by architect. b. Staircase: SS handrails as per architect’s design.

Handrails. Ramp runs with a rise greater than 6 inches (150 mm) shall have handrails complying with Section 505.