Installation of Umbilicals and Flying Sample Clauses

Installation of Umbilicals and Flying. Leads Perform subsea umbilical tie-ins of xxxxx, as per Table D (optional). Develop relevant installation and testing procedures (optional) Engineer, procure, construct, install and hook-up equipment as per Tables A and D. Account for loads and load margin in FPSO hull/mooring design. Provide FPSO motion data to SUBSEA. Review installation procedure and requirements issued by FLOWLINE, SUBSEA, and INSTALLATION. Provide space for temporary equipment provided by FLOWLINE and/or INSTALLATION. Coordinate installation of temporary equipment with FLOWLINE and/or INSTALLATION. Verify actual design against the interference results from FLOWLINE Identify locations for TUTU and provide bulk-heads to connect TUTU with the umbilical pig tails Engineer, procure, construct, install and hook-up equipment as per Tables A and D. Provide installation engineering support to SUBSEA for umbilical and flying leads design. Incorporate the installation requirements and develop the installation and subsea tie-in procedures. Review load out procedures developed by SUBSEA. Assist, witness load out testing and receive the umbilical system Perform umbilical transportation from manufacturing yard to the offshore site. Install and test all umbilical sections and SDU.* Install, connect and test all flying leads. Perform post-installation tests with the assistance of SUBSEA. Perform precommissioning of the umbilical system with the assistance of SUBSEA Perform interference analysis with risers and moorings. Provide results to SUBSEA and FPSO. Perform detailed design of dynamic umbilical, included hang-off configuration. Incorporate into design the interference results from FLOWLINE Develop the installation requirements and provide them to FLOWLINE Develop the load out requirements and provide them to FLOWLINE Develop the installation requirements for flying leads and provide them to FLOWLINE and DRILLING. Calculate and document operating and installation hang-off loads and provide them to FPSO. Perform the load-out of umbilical onto FLOWLINE installation vessel. Perform loadout testing and handover the umbilical system to FLOWLINE Provide assistance and temporary equipment during installation works, hang-off, testing and commissioning. Develop the pre-commissioning procedures. Provide to FPSO information about the pig-tail lengths. Coordinate the activities of SUBSEA personnel during installation, test and commissioning phases. Review load out procedures developed by SUBSEA. Review the pr...
AutoNDA by SimpleDocs

Related to Installation of Umbilicals and Flying

  • Installation Tenant may install and use Tenant's Lines and make connections and disconnections at the terminal blocks as described above, provided Tenant shall: (i) obtain Landlord's prior written approval of all aspects thereof, (ii) use an experienced and qualified contractor designated or approved in writing in advance by Landlord (whom Landlord may require to enter an access and indemnity agreement on Landlord's then standard form of agreement therefor), (iii) comply with such inside wire standards as Landlord may adopt from time to time, and all other provisions of this Lease, including Paragraph 8 respecting alterations, and the Building rules respecting access to the wire closets, (iv) not install Lines in the same sleeve, chaseway or other enclosure in close proximity with electrical wire, and not install PVC-coated Lines under any circumstances, (v) thoroughly test any riser Lines to which Tenant intends to connect any Lines to ensure that such riser Lines are available and are not then connected to or used for telephone, data transmission or any other purpose by any other party (whether or not Landlord has previously approved such connections), and not connect to any such unavailable or connected riser Lines, and (vi) not connect any equipment to the Lines which may create an electromagnetic field exceeding the normal insulation ratings of ordinary twisted pair riser cable or cause radiation higher than normal background radiation, unless the Lines therefor (including riser Lines) are appropriately insulated to prevent such excessive electromagnetic fields or radiation (and such insulation shall not be provided by the use of additional unused twisted pair Lines). As a condition to permitting installation of new Lines, Landlord may require that Tenant remove any existing Lines located in or serving the Premises.

  • Installation and Maintenance of Meters The Servicer shall cause to be installed, replaced and maintained meters in accordance with the Servicer Policies and Practices.

  • Heating, Ventilation and Air Conditioning Landlord shall furnish to the Premises heating, ventilation and air-conditioning (“HVAC”) in accordance with the Design Standards set forth in Exhibit D during Ordinary Business Hours. Landlord shall have access to all air-cooling, fan, ventilating and machine rooms and electrical closets and all other mechanical installations of Landlord (collectively, “Mechanical Installations”), and Tenant shall not construct partitions or other obstructions which may interfere with Landlord’s access thereto or the moving of Landlord’s equipment to and from the Mechanical Installations. No Tenant Party shall at any time enter the Mechanical Installations or tamper with, adjust, or otherwise affect such Mechanical Installations. Landlord shall not be responsible if the HVAC System fails to provide cooled or heated air, as the case may be, to the Premises in accordance with the Design Standards by reason of (i) any equipment installed by, for or on behalf of Tenant, which has an electrical load in excess of the average electrical load and human occupancy factors for the HVAC System as designed, or (ii) any rearrangement of partitioning or other Alterations made or performed by, for or on behalf of Tenant. Tenant shall install, if missing, blinds or shades on all windows, which blinds and shades shall be subject to Landlord’s approval, and shall keep operable windows in the Premises closed, and lower the blinds when necessary because of the sun’s position, whenever the HVAC System is in operation or as and when required by any Requirement. Tenant shall cooperate with Landlord and shall abide by the rules and regulations which Landlord may reasonably prescribe for the proper functioning and protection of the HVAC System. Tenant acknowledges that the server room in the Premises currently has three heat pumps installed, being two 4-ton units, and one 2.5-ton unit (the “Existing Heat Pumps”). The 2.5-ton unit is currently connected and operational. Tenant shall determine whether it is satisfied with the condition of the Existing Heat Pumps and Landlord shall not have any responsibility or liability for the condition, operation, maintenance, repair or replacement of the Existing Heat Pumps. Tenant may operate the Existing Heat Pumps. Tenant shall be responsible for, and pay directly for, all necessary maintenance and repairs to the Existing Heat Pumps. Tenant shall reimburse Landlord monthly for the cost of all utility services used to operate the Existing Heat Pumps within 10 Business Days after receipt of Landlord’s invoice for such amount. Landlord may measure Tenant’s usage of such utility services by either a sub-meter or by other reasonable methods such as by temporary check meters or by survey. Tenant, at its cost, may replace the Existing Heat Pumps with one or more new heat pumps, provided, however, that the capacity of such replacement heat pump(s) shall not exceed the 10.5-ton capacity cooling capacity of the Existing Heat Pumps.

  • Infrastructure (a) The Borrower has and will maintain a sufficient infrastructure to conduct its business as presently conducted and as contemplated to be conducted following its execution of this Agreement.

  • HEATING, VENTILATING AND AIR CONDITIONING The Tenant will operate and regulate those portions of the heating, ventilating, and air conditioning equipment within and serving the Leased Premises so as to maintain such reasonable conditions of temperature and humidity within the Leased Premises as are determined by the Landlord and its Architect and engineers so that no direct or indirect appropriation of the heating, ventilating and air conditioning from the other portions of the Building occurs. The Tenant shall comply with such stipulations and with all Rules and Regulations of the Landlord pertaining to the operation and regulation of such equipment. The Tenant shall immediately notify the Landlord in the event that any repairs are required to the heating, ventilating and air conditioning equipment serving the Leased Premises and shall reimburse the Landlord as part of its Proportionate Share of Operating Costs for the cost of any maintenance, repairs or replacements made by the Landlord in respect of the heating, ventilating and air conditioning equipment serving the Leased Premises. The Landlord acknowledges that the Tenant shall not be responsible for the cost of capital repairs and capital replacements in respect of the heating, ventilating and air conditioning equipment serving the Leased Premises provided that such capital repairs and capital replacements are not necessitated by the Tenant's incorrect or negligent use of equipment. The Tenant shall not under any circumstances go onto the roof of the Building or make any maintenance repairs or replacements to the heating, ventilating and air conditioning systems in the Building without the prior written consent of the Landlord. If the Tenant fails to comply with such stipulations and Rules and Regulations, the Landlord shall be entitled to take such steps as it deems advisable to correct such defaults (including, without limitation, entering upon the Leased Premises and assuming control of such equipment) without liability to the Tenant, and the Tenant will pay to the Landlord forthwith upon demand as Additional Rent all costs and expenses incurred by the Landlord in so doing. The Landlord represents and warrants to the Tenant that the heating, ventilating and air conditioning equipment serving the Leased Premises and required to be installed by the Landlord pursuant to Schedule "C" is and will be at the Commencement Date in good working order and condition.

  • Personnel, Office Space, and Facilities of Manager The Manager at its own expense shall furnish or provide and pay the cost of such office space, office equipment, office personnel, and office services as the Manager requires in the performance of its investment advisory and other obligations under this Agreement.

  • Maintenance and Repairs 7.1 Tenant shall, at its expense, throughout the Term and all renewals and extensions thereof, maintain in good order, condition and repair the Premises, including but not limited to heating and air conditioning equipment, walls, floors and ceilings, window exteriors, mechanical and electrical systems and equipment exclusively serving the Premises, electric light fixtures, bulbs, tubes and tube casings, doors, floor coverings, dock doors, levelers, plumbing system and plumbing fixtures, Tenant’s signs and utility facilities not maintained by Landlord. Landlord shall use reasonable efforts to extend to Tenant the benefit from warranties on such items, if any, that have been made by Landlord’s contractors or vendors and to extend to Tenant, as and if available, any bulk buying power that Landlord may have with such contractors or vendors. If any portion of the Premises or any system or equipment in the Premises which Tenant is obligated to repair cannot be fully repaired, Tenant shall promptly replace the same, regardless of whether the benefit of such replacement extends beyond the Term. Tenant shall, at Tenant’s expense, maintain a preventive maintenance contract providing for the regular inspection (at least quarterly) and maintenance of the heating and air conditioning system by a licensed and qualified heating and air conditioning contractor, or Tenant shall perform such HVAC inspection and maintenance with duly licensed and qualified employee. The cost of such preventive maintenance contract shall be paid by Tenant and an expense solely chargeable to Tenant; but if Landlord so elects, same may be billed directly by Landlord to Tenant where Landlord on Tenant’s behalf enters into such preventive maintenance contract and in such case shall be deemed Additional Rent (Landlord alone may so elect whether to enter into such preventive maintenance contract on Tenant’s behalf). Landlord shall have the right, upon notice to Tenant, to undertake the responsibility for preventive maintenance of any other system or component at Tenant’s expense. Tenant shall be responsible for janitorial services and trash removal from the Premises, at Tenant’s expense. Landlord and Tenant intend that, at all times during the Term, Tenant shall maintain the Premises in good order and condition and appearances reasonably commensurate with the balance of the Property. All of Tenant’s obligations to maintain and repair shall be accomplished at Tenant’s sole expense. If Tenant fails to maintain and repair the Premises as required by this Section, Landlord may, on 10 days’ prior written notice (except that no notice shall be required in case of emergency), enter the Premises and perform such maintenance or repair on behalf of Tenant; provided such entry is made in compliance with Applicable Laws, including but not limited to, the Marijuana code. In such cases, Tenant shall reimburse Landlord immediately upon demand for all costs incurred in performing such maintenance or repair plus an administration fee equal to 5% of such actual and reasonable costs or expenses.

  • System Maintenance The Trust understands that USBFS will perform periodic maintenance to the System(s), which may cause temporary service interruptions. To the extent possible, USBFS shall notify the Trust of all planned outages and will perform any necessary maintenance during non-business hours.

  • Information Systems Acquisition Development and Maintenance a. Client Data – Client Data will only be used by State Street for the purposes specified in this Agreement.

  • Lighting Landlord will furnish both Building Standard and non-Building Standard lamps, bulbs, ballasts and starters that are part of the Leasehold Improvements for purchase by Tenant at Landlord's cost, plus Landlord's standard administration fee. Landlord will install non-Building Standard items at Landlord's scheduled rate for this service.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!