Legal Basis The coordination of programs serving individuals with disabilities and the development of cooperative agreements between these programs has the following basis in Federal and State law: • The Rehabilitation Act of 1973, as amended by the Workforce Innovation Opportunity Act, 29 U.S.C. 701 et. seq. • 34 Code of Federal Regulations §§ 361, 363, 397 • The Americans with Disabilities Act, as amended • Maryland Education Article, §§ 21-301 – 21-304, Annotated Code of Maryland • Code of Maryland Regulations, 13A, Subtitle 11.
Local Bargaining 2.4.1 Notwithstanding section 59(2) of the Labour Relations Code, a notice to commence local bargaining by a School Division or the Association must be served after, but not more than 60 days after, the collective agreement referred to in section 11(4) of PECBA has been ratified or the central terms have otherwise been settled. 2.4.2 A notice referred to in subsection 2.4.1 is deemed to be a notice to commence collective bargaining referred to in section 59(1) of the Labour Relations Code.
Policy Administration The Company shall provide all required, necessary and appropriate claims, administrative and other services with respect to the Policies. The Company shall use reasonable care in its administration and claims practices with respect to the Policies and in administering and performing its duties under this Agreement and such practices, administration and performance shall (a) conform with Applicable Law; (b) not be fraudulent; and (c) be no less favorable than those used by the Company with respect to other policies of the Company not reinsured by the Reinsurer.
Policy Grievance Where either Party disputes the general application, interpretation or alleged violation of an article of this Agreement, the dispute shall be discussed initially with the Employer or the Union, as the case may be, within thirty (30) days of the occurrence. Where no satisfactory agreement is reached, either Party may submit the dispute to arbitration, as set out in Article 10.
CFR PART 200 AND FEDERAL CONTRACT PROVISIONS EXPLANATION TIPS and TIPS Members will sometimes seek to make purchases with federal funds. In accordance with 2 C.F.R. Part 200 of the Uniform Administrative Requirements, Cost Principles, and Audit Requirements for Federal Awards (sometimes referred to as “XXXXX”),Vendor's response to the following questions labeled "2 CFR Part 200 or Federal Provision" will indicate Vendor's willingness and ability to comply with certain requirements which may be applicable to TIPS purchases paid for with federal funds, if accepted by Vendor. Your responses to the following questions labeled "2 CFR Part 200 or Federal Provision" will dictate whether TIPS can list this awarded contract as viable to be considered for a federal fund purchase. Failure to certify all requirements labeled "2 CFR Part 200 or Federal Provision" will mean that your contract is listed as not viable for the receipt of federal funds. However, it will not prevent award. If you do enter into a TIPS Sale when you are accepting federal funds, the contract between you and the TIPS Member will likely require these same certifications.
Franchise Tax Status Contractor represents and warrants that it is not currently delinquent in the payment of any franchise taxes owed the State of Texas under Chapter 171 of the Texas Tax Code.
Central Bargaining Notwithstanding the foregoing provisions, in the event the parties to this Agreement agree to negotiate for its renewal through the process of central bargaining, either party to this Agreement may give notice to the other party of its desire to bargain for amendments on local matters proposed for incorporation in the renewal of this Agreement and negotiations on local matters shall take place during the period from 120 to 60 days prior to the termination date of this Agreement. Negotiations on central matters shall take place during the period commencing forty-five days prior to the termination date of this Agreement. It is understood and agreed that "local matters" means, those matters which have been determined by mutual agreement between the central negotiating committees respectively representing each of the parties to this Agreement as being subjects for local bargaining directly between the parties to this Agreement. It is also agreed that local bargaining shall be subject to such procedures that may be determined by mutual agreements between the central negotiating committees referred to above. For such purposes, it is further understood that the central negotiating committees will meet during the sixth month prior to the month of termination of this Agreement to convey the intentions of their principals as to possible participation in central negotiations, if any, and the conditions for such central bargaining.
Department The Massachusetts Department of Public Utilities or any successor state agency.
Policy Grievance – Union Grievance The Union may institute a grievance alleging a general misinterpretation or violation of this Agreement by the Employer by submitting a written grievance at Step No. 1 within twenty (20) days after the circumstances have occurred. This section shall not apply to disciplinary grievances or application of competitive clauses under this Agreement.
CFR PART 200 Domestic Preferences for Procurements As appropriate and to the extent consistent with law, the non-Federal entity should, to the greatest extent practicable under a Federal award, provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). The requirements of this section must be included in all subawards including all contracts and purchase orders for work or products under this award. For purposes of 2 CFR Part 200.322, “Produced in the United States” means, for iron and steel products, that all manufacturing processes, from the initial melting stag through the application of coatings, occurred in the United States. Moreover, for purposes of 2 CFR Part 200.322, “Manufactured products” means items and construction materials composed in whole or in part of non-ferrous metals such as aluminum, plastics and polymer-based products such as polyvinyl chloride pipe, aggregates such as concrete, class, including optical fiber, and lumber. Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, Vendor certifies that to the greatest extent practicable Vendor will provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). Does vendor agree? Yes