Location and Density of Residential Development Sample Clauses

Location and Density of Residential Development. The Xxxxxxx Xxxxx 0 Land Use Table (Exhibit “D”) lists the types, numbers and acreages of land uses within Phase 1. Exhibit “D” includes Parcel O as presently approved only to illustrate the existing approval on that Parcel. A range of residential types and densities are proposed in Phase I of the Project, including: single-family dwelling units covering a variety of types (including Age Qualified / Restricted) and densities (1 to 10 dwelling units or “du”) per gross acre depending on the housing type); and, multifamily dwelling units with densities ranging from 10 to 25 du per gross acre depending on specific design. The actual amounts and densities of development within each parcel will vary in response to market conditions, however, the Phase I maximum unit count will not exceed 2,586 unless otherwise approved by Xxxxxx County. Phase I could be developed at higher densities than currently depicted in Exhibits "C" and "D", thereby consuming less land area. In this event “surplus” Phase 1 land area would be developed when additional dwelling units are permitted as part of later Phases. For purposes of this Agreement, gross density is dwelling units divided by total acreage (of the Phase, project or subdivision). Net density is dwelling units divided by total acreage minus acreage not part of residential lot area. Accessory dwelling units (“ADUs”) shall not be counted for purposes of calculating Phase I residential density, however, ADUs shall be counted with respect to calculating the total number of dwelling units served by utility systems.