Minimum FBO Facility Standards Sample Clauses

Minimum FBO Facility Standards. 1. The leasehold shall contain the appropriate acreage to provide for the specific use area requirements established for the services of the following required activities: aircraft maintenance and repairs, plus the requirements set out in this section for the dispensing of aviation fuel and lubricants and hangar rental. (Specific use spaces need not be additive where combination use can be reasonably and feasibly established.) 2. A building to provide adequate and heated space for office, public lounge, pilot briefing room and restrooms must be leased or constructed. Aircraft hangar rental space appropriate for the type of aircraft to be stored. For FBO’s with an FAA certificated repair station a separate hangar facility with minimum shop and floor space is required. 3. Ample public amenities for their customers to include a conveniently located, heated and air-conditioned lounge and separate sanitary restrooms for men and women, public telephone service, pilot briefing room and snack and/or beverage vending services available during required hours of operation. 4. Sufficient facilities and/or procedures for washing aircraft. 5. Paved off-street parking outside of the Air Operations Area (AOA), but within the Leased Premises, for a minimum number of automobiles as specified by New Hanover County 6. Electronic security gate with closed circuit camera monitoring and continuous recording equipment to restrict unauthorized access to the ramp.
Sample 1
AutoNDA by SimpleDocs

Related to Minimum FBO Facility Standards

  • Quality Standards Each Party agrees that the nature and quality of its products and services supplied in connection with the other Party's Marks will conform to quality standards set by the other Party. Each Party agrees to supply the other Party, upon request, with a reasonable number of samples of any Materials publicly disseminated by such Party which utilize the other Party's Marks. Each Party will comply with all applicable laws, regulations, and customs and obtain any required government approvals pertaining to use of the other Party's marks.

  • Federal Medicaid System Security Requirements Compliance Party shall provide a security plan, risk assessment, and security controls review document within three months of the start date of this Agreement (and update it annually thereafter) in order to support audit compliance with 45 CFR 95.621 subpart F, ADP System Security Requirements and Review Process.

  • Applicable Standards The requirements and guidelines of NERC, the Applicable Regional Entity, and the Control Area in which the Customer Facility is electrically located; the PJM Manuals; and Applicable Technical Requirements and Standards.

  • Safety Standards Performance of the Contract for all commodities or contractual services must comply with requirements of the Occupational Safety and Health Act and other applicable State of Florida and federal requirements.

  • Facility Requirements 1. Maintain wheelchair accessibility to program activities according to governing law, including the Americans With Disabilities Act (ADA), as applicable. 2. Provide service site(s) that will promote attainment of Contractor’s program objectives. Arrange the physical environment to support those activities. 3. Decrease program costs when possible by procuring items at no cost from County surplus stores and by accepting delivery of such items by County.

  • Minimum Standards (a) It is intended that the provisions contained in the Employment Standards Act and Regulations (Act), presently in effect and from time to time amended, are minimum requirements only. (b) In the event this collective agreement does not contain a provision which is contained in the Act such provision shall be deemed to be incorporated in the collective agreement as part of its terms. (c) In the event this collective agreement contains a provision which is a lesser requirement than a similar or related provision contained in the Act, then the provision contained in the Act shall prevail, and shall be deemed to be incorporated in the collective agreement as part of its terms. (d) In the event a dispute arises respecting the application or interpretation of any provision of the Act which is deemed to be part of the terms of this collective agreement, the Grievance Procedure contained in this collective agreement, including Arbitration if necessary, shall apply for resolution of the dispute.

  • PREVAILING WAGE RATES - PUBLIC WORKS AND BUILDING SERVICES CONTRACTS If any portion of work being Bid is subject to the prevailing wage rate provisions of the Labor Law, the following shall apply:

  • CONTRACT WORK HOURS AND SAFETY STANDARDS As per the Contract Work Hours and Safety Standards Act (40 U.S.C. 3701-3708), where applicable, all Customer Purchase Orders in excess of ,000 that involve the employment of mechanics or laborers must include a provision for compliance with 40 U.S.C. 3702 and 3704, as supplemented by Department of Labor regulations (29 CFR Part 5). Under 40 U.S.C. 3702 of the Act, each contractor must be required to compute the wages of every mechanic and laborer on the basis of a standard work week of 40 hours. Work in excess of the standard work week is permissible provided that the worker is compensated at a rate of not less than one and a half times the basic rate of pay for all hours worked in excess of 40 hours in the work week. The requirements of 40 U.S.C. 3704 are applicable to construction work and provide that no laborer or mechanic must be required to work in surroundings or under working conditions which are unsanitary, hazardous or dangerous. These requirements do not apply to the purchases of supplies or materials or articles ordinarily available on the open market, or contracts for transportation or transmission of intelligence.

  • Standards Compliance Registry Operator shall comply with relevant existing RFCs and those published in the future by the Internet Engineering Task Force (IETF), including all successor standards, modifications or additions thereto relating to the DNS and name server operations including without limitation RFCs 1034, 1035, 1123, 1982, 2181, 2182, 2671, 3226, 3596, 3597, 4343, and 5966. DNS labels may only include hyphens in the third and fourth position if they represent valid IDNs (as specified above) in their ASCII encoding (e.g., “xn--ndk061n”).

  • Contract Work Hours and Safety Standards Act The following clauses apply to any Federal-aid construction contract in an amount in excess of $100,000 and subject to the overtime provisions of the Contract Work Hours and Safety Standards Act. These clauses shall be inserted in addition to the clauses required by 29 CFR 5.5(a) or 29 CFR 4.6. As used in this paragraph, the terms laborers and mechanics include watchmen and guards.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!