Construction Methods No four course of brick-work, with three joints, shall exceed in height, when built, one inch more than the same bricks piles upon one another without mortar. The bricks are to be well soaked in water before use on works, in proper through so as to be thoroughly wet when layed. The Cessation of the bubbles through the water is an irldication of saturation being complete. For ensuring thorough soaking of the bricks every one or two bricklayers or more as necessary, shall be provided with tubs for use The wall of structures shall be carried up regularly in all cases 1` when the nature of the work will admit of it not leaving any part 915mm (3 feet) lower than another. Horizontal courses shalI be straight, level and even and faces of walls smooth and plumb. A straight edge and a plumb- xxx shall be used for constant checking during progress of the work. No brick-bats shall be permitted to be used except when necessary for obtaining the dimension of the different course or for obtaining the specified bond. All unfinished work must be raked back in course unless otherwise directed arid when new work is to be jointed to it the surface of unfinished work must be cleaned and wetted. The bricks shall be laid by placing sufficient mortar on the wall and forcing every brick into it in such a manner as to completely fill every joint with moratar whether at the bottom, side or end of the brick. The mortar to be used shall be that specified for the relevant schedule items and shall comply with the specification for the mortar specified. The bound used shall be English and shall be carried throughout the work. At all angles forming the junction of any two walls, the bricks shall, at each alternate course be carried into each of the respective walls, so as to thoroughly unite the work. V'Jhen the faces are to be plastered, the joints shall be well raked out before any plaster is laid on should the plaster from want of proper joint ranking detach and 7 fall off from the brick work, the contractor shall strip off the plaster bodily to the extent ordered by Superintending Engineer and shall re-do the work properly at his own expense. All requisite scaffolding shall be provided at the contractor's expense and shall be double i.e., must it have two sets of upright supports Care must be taken to ensure the safety of the work people and the contractor must comply with such instructions as the Superintending Engineer may issue to ensure such safety. The contractor will be entirely responsible for any damage or injuries to person or property resulting from ill-erected scaffolding, defective ladders, or otherwise arising out of his default in this respect. The brick work for the retaining wall shall proceed side by side with the depositing and compacting of earth between the retaining walls. At no time shall the brick-work be constructed more than 405mm (1'-4") above Y the compacted earth. In the retaining wall weep-holes shall be provided at suitable intervals as instructed during execution, with the inner surface of the weep-holed plastered 20mm (3/4") thick in cement mortar 1:4 crouched rock of grades in different layer shall be provided at the inner end of the weep-holes to prevent the choking of the weep-holes to have full drainage. No extra payment will be made for this and no deductions will be made for this in the brick-work.
Calculation methodology No adjustment in the Conversion Price need be made unless the adjustment would require an increase or decrease of at least 1% in the Conversion Price then in effect, provided that any adjustment that would otherwise be required to be made shall be carried forward and taken into account in any subsequent adjustment. Except as stated in this Article VI, the Conversion Rate will not be adjusted for the issuance of Common Stock or any securities convertible into or exchangeable for Common Stock or carrying the right to purchase any of the foregoing. Any adjustments that are made shall be carried forward and taken into account in any subsequent adjustment. All calculations under Article V and Section 6.06 hereof and this Section 6.07 shall be made to the nearest cent or to the nearest 1/10,000th of a share, as the case may be.
Alternative Resolution Methods Any time during the grievance process, by mutual consent, the parties may use alternative methods to resolve the dispute. If the parties agree to use alternative methods, the time frames in this Article are suspended. If the selected alternative method does not result in a resolution, the Union may return to the grievance process and the time frames resume. Any expenses and fees of alternative methods will be shared equally by the parties.
Agreed Guidelines Applications With respect to the application of the Sentencing Guidelines to this case, the parties stipulate and agree as follows:
NETWORK INTERCONNECTION METHODS 64.1 This Section sets forth the terms and conditions for Network Interconnection Methods (NIMs) provided between CenturyLink and CLEC for the Interconnection Facilities established between the Parties’ networks. Additionally, this Section describes the physical architecture for the Interconnection of the Parties’ facilities and equipment required for the transmission and routing of Local Traffic, ISP-Bound Traffic, IntraLATA LEC Toll Traffic, VoIP-PSTN Traffic, Transit Traffic and Jointly Provided Switched Access Service Traffic.
Notification Procedures To address non-compliance, the receiving Competent Authority would notify the providing Competent Authority pursuant to Article 5 of the IGA. The notification procedures would differ depending upon whether the receiving Competent Authority seeks to address administrative or other minor errors or significant non-compliance.
Notification Procedure (i) Each such notice shall be deemed to have been delivered:
PayPal as Login Method We may allow you to authenticate with PayPal when you log into certain external websites or mobile apps. If we do so, we may share your login status with any third party enabling you to log in in this way, as well as the personal and other account information that you consent to being shared so that the third party can recognize you. PayPal will not give the third party access to your account and will only make payments from your account to that third party with your specific authorization and instruction. If you enable visitors to authenticate with PayPal when they log into your website, app, or your customer accounts, you must agree to any specific terms applicable when this functionality is made available to you, and comply with any specifications in any integration manual or guideline. We do not guarantee or otherwise represent the identity of any user of this login method. We will not share with you the personal and other account information of the user (including login status) held by PayPal unless the user has consented to our disclosure of that information to you. Corporate Customers When we refer to “PSD2” in this section we mean the Second EU Payment Services Directive ((EU)2015/2366). We consider you to be a “Corporate Customer” if, on the date you entered into this user agreement, you are not: • A consumer, (being an individual acting for purposes other than a trade, business or profession). • A micro-enterprise (being an enterprise which employs fewer than 10 persons and has an annual balance sheet that does not exceed 2 million EUR. We and you may agree that certain provisions of PSD2 (as implemented by local law) do not apply to your use of our service if you are a Corporate Customer. If you are a Corporate Customer you agree that: • You are not entitled to a refund for billing agreement payments. • Where you identify a problem you have up to 60 (sixty) days from the date on which the problem happened to notify us about it, after which time we have no obligation to investigate and refund you. • We are not obliged to comply with the information requirements set out in Title III of PSD2 and their equivalents in any implementation of PSD2 in member states of the European Economic Area that may apply to you (“PSD2 transpositions”). • Articles 72 and 89 of PSD2 and equivalent provisions in PSD2 transpositions do not apply to your use of our service, meaning that, even where we may say so otherwise in this user agreement, we are not liable to you for the losses or damage you may suffer under those articles and provisions. Section numbers and defined words
NOTIFICATIONS AND SUBMISSION OF REPORTS Unless otherwise stated in writing after the Effective Date, all notifications and reports required under this IA shall be submitted to the following entities: OIG: Administrative and Civil Remedies Branch Office of Counsel to the Inspector General Office of Inspector General U.S. Department of Health and Human Services Xxxxx Building, Room 5527 000 Xxxxxxxxxxxx Xxxxxx, XX Xxxxxxxxxx, XX 00000 Telephone: (000) 000-0000 Facsimile: (000) 000-0000 LFAC: Xxxxxxx X. Xxxxx, DPM 0000 Xxxxxxxxxxx Xx. X-000 Xxxxxxxxx, XX 00000 Telephone: (000) 000-0000 Email: xx.xxxxx@xxxxx.xxx Unless otherwise specified, all notifications and reports required by this IA may be made by electronic mail, overnight mail, hand delivery, or other means, provided that there is proof that such notification was received. Upon request by OIG, LFAC may be required to provide OIG with an additional copy of each notification or report required by this IA in OIG’s requested format (electronic or paper).
Resume Self-Certification Form When submitting a response to an RFQ the Contractor shall submit with its response a completed and signed Resume Self-Certification Form (Contract Exhibit F) to the Customer for each proposed Staff member identified in the RFQ response.
