Pressure at Receipt Points Sample Clauses

Pressure at Receipt Points. Producer shall deliver or shall cause to be delivered Producer’s Gas hereunder at a pressure sufficient to enter the Processing Plant at the Receipt Points at a pressure not less than 950 psig. In the event that Producer’s Gas is delivered at the Receipt Points at a pressure less than 950 psig, Processor will operate the Processing Plant and process Producer’s Gas in each case to the extent commercially practicable and reasonable under the circumstances and taking into account the impact that such lower pressure may have on the operation of the Processing Plant, and Producer agrees to be responsible for, and to defend, indemnify, release, and hold Processor and its Affiliates, directors, officers, employees, agents, consultants, representatives, and invitees harmless from and against, all claims and losses of whatever kind and nature resulting from such low pressure Gas.
AutoNDA by SimpleDocs
Pressure at Receipt Points. Shipper shall deliver Shipper Gas hereunder to each Receipt Point at a pressure sufficient to enter the Magnolia Gathering System at the prevailing pressures required under this Agreement, but such Gas shall not be delivered at pressures in excess of the maximum allowable operating pressure of the Magnolia Gathering System.
Pressure at Receipt Points. Shipper shall deliver Shipper Gas hereunder to each Receipt Point at a pressure sufficient to enter the Olympia Gathering System at the prevailing pressures required under this Agreement, but such Gas shall not be delivered at pressures in excess of the maximum allowable operating pressure of the Olympia Gathering System.
Pressure at Receipt Points. Shipper shall cause Shipper’s Gas to be delivered to the Receipt Points at a pressure sufficient to enter the Gathering System, but shall not be delivered at pressures in excess of the maximum allowable operating pressure at the Receipt Points, as such pressure may exist from time to time; provided, however, the following shall apply:
Pressure at Receipt Points. Producer shall cause Producer’s Gas to be delivered to the Receipt Points at a pressure sufficient to enter the Gathering System, provided that Gatherer maintains the operating pressure at low pressure Receipt Points at no greater than the applicable Gas Gathering Agreement dated July 1, 2018 Between Alpine High Gathering LP (Gatherer) and Apache Corporation (Producer) Required Pressure. Producer shall not deliver Gas at any Receipt Point at a pressure in excess of the MAOP at the Receipt Point, as such MAOP may exist from time to time. As of the Effective Date, the MAOP at each Receipt Point shall be listed on Exhibit B, and Gatherer shall give written notice to Producer at any time thereafter that the MAOP for any Receipt Point changes and for each Additional Receipt Point when it is added.
Pressure at Receipt Points. Producer shall cause Producer’s Gas to be delivered to the Receipt Points at a pressure sufficient to enter the Gathering System, provided that Gatherer maintains the operating pressure at low pressure Receipt Points at no greater than the applicable Required Pressure. Producer shall not deliver Gas at any Receipt Point at a pressure in excess of the MAOP at the Receipt Point, as such MAOP may exist from time to time. As of the Effective Date, the MAOP at each Receipt Point shall be listed on Exhibit B, and Gatherer shall give written notice to Producer at any time thereafter that the MAOP for any Receipt Point changes and for each Additional Receipt Point when it is added.

Related to Pressure at Receipt Points

  • Delivery Points ‌ Project water made available to the Agency pursuant to Article 6 shall be delivered to the Agency by the State at the delivery structures established in accordance with Article 10.

  • Delivery Point The delivery point is the point of delivery of the Power Product to the CAISO Controlled Grid (the “Delivery Point”). Seller shall provide and convey to Buyer the Power Product from the Generating Facility at the Delivery Point. Title to and risk of loss related to the Power Product transfer from Seller to Buyer at the Delivery Point.

  • Traffic Measurement and Billing over Interconnection Trunks 6.1 For billing purposes, each Party shall pass Calling Party Number (CPN) information on at least ninety-five percent (95%) of calls carried over the Interconnection Trunks. 6.1.1 As used in this Section 6, “Traffic Rate” means the applicable Reciprocal Compensation Traffic rate, Measured Internet Traffic rate, intrastate Switched Exchange Access Service rate, interstate Switched Exchange Access Service rate, or intrastate/interstate Tandem Transit Traffic rate, as provided in the Pricing Attachment, an applicable Tariff, or, for Measured Internet Traffic, the FCC Internet Order. 6.1.2 If the originating Party passes CPN on ninety-five percent (95%) or more of its calls, the receiving Party shall xxxx the originating Party the Traffic Rate applicable to each relevant minute of traffic for which CPN is passed. For any remaining (up to 5%) calls without CPN information, the receiving Party shall xxxx the originating Party for such traffic at the Traffic Rate applicable to each relevant minute of traffic, in direct proportion to the minutes of use of calls passed with CPN information. 6.1.3 If the originating Party passes CPN on less than ninety-five percent (95%) of its calls and the originating Party chooses to combine Reciprocal Compensation Traffic and Toll Traffic on the same trunk group, the receiving Party shall xxxx the higher of its interstate Switched Exchange Access Service rates or its intrastate Switched Exchange Access Services rates for all traffic that is passed without CPN, unless the Parties agree that other rates should apply to such traffic. 6.2 At such time as a receiving Party has the capability, on an automated basis, to use such CPN to classify traffic delivered over Interconnection Trunks by the other Party by Traffic Rate type (e.g., Reciprocal Compensation Traffic/Measured Internet Traffic, intrastate Switched Exchange Access Service, interstate Switched Exchange Access Service, or intrastate/interstate Tandem Transit Traffic), such receiving Party shall xxxx the originating Party the Traffic Rate applicable to each relevant minute of traffic for which CPN is passed. If the receiving Party lacks the capability, on an automated basis, to use CPN information on an automated basis to classify traffic delivered by the other Party by Traffic Rate type, the originating Party will supply Traffic Factor 1 and Traffic Factor

  • Pressure The System user is not entitled to deliver natural gas to Gas Connect Austria at the Entry Point Xxxxxxxxxx WAG at a pressure of below 49 bar. Normal cubic meter (Nm³) is a cubic meter of natural gas at 273.15 K (= 0°C) and 101,325 kPa (=1.01325 bara). The natural gas delivered by the System User at the Entry Point Xxxxxxxxxx WAG for transportation must be in line with the following chemical and physical specifications:

  • DELIVERY: FOB DESTINATION, INSIDE DELIVERY, FREIGHT PAID Whenever possible, contractors should give the ordering entities 3 working days prior notice of any deliveries and/or installations. Furniture contractors will not be responsible for the removal/moving of existing furnishings unless requested by the ordering entity. Contractors should verify site readiness prior to delivery. All deliveries will be made during normal working hours unless otherwise arranged with the ordering entity. Contractor will communicate any scheduling delays and/or changes immediately. Agencies will not be responsible for any freight damage, concealed or otherwise.

  • Interconnection Customer Compensation If the CAISO requests or directs the Interconnection Customer to provide a service pursuant to Articles 9.6.3 (Payment for Reactive Power) or 13.5.1 of this LGIA, the CAISO shall compensate the Interconnection Customer in accordance with the CAISO Tariff.

  • Compressed Work Week The Company and Union recognize the concept of the compressed work week. It is further understood that the compressed work week conditions will apply only to those departments that are on the compressed work week.

  • Interconnection Customer (1) Interconnection Customer shall construct and, unless otherwise indicated, shall own, the following Interconnection Facilities: None (2) In the event that, in accordance with the Interconnection Construction Service Agreement, Interconnection Customer has exercised the Option to Build, it is hereby permitted to build in accordance with and subject to the conditions and limitations set forth in that Section, the following portions of the Transmission Owner Interconnection Facilities which constitute or are part of the Customer Facility: None Ownership of the facilities built by Interconnection Customer pursuant to the Option to Build shall be as provided in the Interconnection Construction Service Agreement.

  • DELIVERY PRESSURE Xxxxxx agrees to use due care and diligence to furnish gas hereunder at such uniform pressure as Seller may elect up to, but not exceeding 20 pounds per square inch gauge, and not less than 5 pounds per square inch gauge, at the "Point of Delivery". Buyer shall be responsible for the installation and operation of adequate safety equipment downstream of the Point of Delivery so as to relieve or control pressure variations within the limits described above that may, for any reason through malfunction of Seller's equipment or otherwise, occur on Buyer's side of the "Delivery Point".

  • Check Meters Developer, at its option and expense, may install and operate, on its premises and on its side of the Point of Interconnection, one or more check meters to check Connecting Transmission Owner’s meters. Such check meters shall be for check purposes only and shall not be used for the measurement of power flows for purposes of this Agreement, except as provided in Article 7.4 below. The check meters shall be subject at all reasonable times to inspection and examination by Connecting Transmission Owner or its designee. The installation, operation and maintenance thereof shall be performed entirely by Developer in accordance with Good Utility Practice.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!