PROCEDURE BY OWNER’S TAB SERVICES CONTRACTOR Sample Clauses

PROCEDURE BY OWNER’S TAB SERVICES CONTRACTOR. 2.6.1. Air Handling and Distribution Systems 2.6.1.1. Adjust air handling and distribution systems to provide required or design supply, return, and exhaust air quantities at site altitude. 2.6.1.2. Make air quantity measurements in ducts by Pitot tube traverse of entire cross sectional area of duct. 2.6.1.3. The total air volume handled by the system shall be determined by means of a Pitot tube and draft gauge. The total air delivered by each duct shall be measured by Pitot tube traverses. 2.6.1.4. The average velocity in the duct shall be determined by velocity readings which are taken in the center of equally divided areas in the cross section of the duct. The number of areas in which velocity readings are to be taken is determined by the size of the duct, based on a maximum size of equally divided areas of 8 inches. 2.6.1.5. Measure air quantities at air inlets and outlets. The volume dampers, pressure controllers, outlets and other devices shall be adjusted so the air volumes will be as shown on the drawings. 2.6.1.6. Adjust distribution system to obtain uniform space temperatures free from objectionable drafts and noise. 2.6.1.7. Use volume control devices to regulate air quantities only to the extent that adjustments do not create objectionable air motion or sound levels. Effect volume control by duct internal devices such as dampers and splitters. 2.6.1.8. Vary total system air quantities by adjustment of fan speeds. Provide drive changes required. Vary branch air quantities by damper regulation. 2.6.1.9. Provide system schematic with required and actual air quantities recorded at each outlet or inlet. 2.6.1.10. Measure air static pressure conditions on air supply units, including filter and coil pressure drops, and total pressure across the fan. Make allowances for 50 percent loading of filters. 2.6.1.11. Adjust outside air automatic dampers, outside air, return air, and exhaust dampers for design conditions. 2.6.1.12. Measure temperature conditions across outside air, return air, and exhaust dampers to check leakage. 2.6.1.13. Where modulating dampers are provided, take measurements and balance at extreme conditions. 2.6.1.14. Measure building static pressure and adjust supply, return, and exhaust systems to provide required relationship between each to maintain approximately 0.05 inches positive static pressure near the building entries. 2.6.1.15. On completion of the test the Owner’s TAB Services Contractor shall prepare a typewritten report sh...
AutoNDA by SimpleDocs

Related to PROCEDURE BY OWNER’S TAB SERVICES CONTRACTOR

  • Construction Phase Services 3.1.1 – Basic Construction Services

  • Contractor Services Emerald has contracted, on an exclusive basis, with official contractors to provide certain services for the Event. Service companies other than the official contractors will not be allowed to perform any of these exclusive services. Non-exclusive services may be performed by exhibitor-appointed contractors (“EACs”) within certain guidelines. Please refer to the Exhibitor Service Manual for a listing of exclusive services and EAC guidelines.

  • Contractor Responsibility for System Agency’s Termination Costs If the System Agency terminates the Contract for cause, the Contractor shall be responsible to the System Agency for all costs incurred by the System Agency and the State of Texas to replace the Contractor. These costs include, but are not limited to, the costs of procuring a substitute vendor and the cost of any claim or litigation attributable to Contractor’s failure to perform any Work in accordance with the terms of the Contract.

  • Contractor Certification for Contractor Employees Introduction Texas Education Code Chapter 22 requires entities that contract with school districts to provide services to obtain criminal history record information regarding covered employees. Contractors must certify to the district that they have complied. Covered employees with disqualifying criminal histories are prohibited from serving at a school district. Definitions: Covered employees: Employees of a contractor or subcontractor who have or will have continuing duties related to the service to be performed at the District and have or will have direct contact with students. The District will be the final arbiter of what constitutes direct contact with students. Disqualifying criminal history: Any conviction or other criminal history information designated by the District, or one of the following offenses, if at the time of the offense, the victim was under 18 or enrolled in a public school: (a) a felony offense under Title 5, Texas Penal Code; (b) an offense for which a defendant is required to register as a sex offender under Chapter 62, Texas Code of Criminal Procedure; or (c) an equivalent offense under federal law or the laws of another state. I certify that: NONE (Section A) of the employees of Contractor and any subcontractors are covered employees, as defined above. If this box is checked, I further certify that Contractor has taken precautions or imposed conditions to ensure that the employees of Contractor and any subcontractor will not become covered employees. Contractor will maintain these precautions or conditions throughout the time the contracted services are provided. OR SOME (Section B) or all of the employees of Contractor and any subcontractor are covered employees. If this box is checked, I further certify that: (1) Contractor has obtained all required criminal history record information regarding its covered employees. None of the covered employees has a disqualifying criminal history.

  • Contractor’s Project Manager and Key Personnel Contractor shall appoint a Project Manager to direct the Contractor’s efforts in fulfilling Contractor’s obligations under this Contract. This Project Manager shall be subject to approval by the County and shall not be changed without the written consent of the County’s Project Manager, which consent shall not be unreasonably withheld. The Contractor’s Project Manager shall be assigned to this project for the duration of the Contract and shall diligently pursue all work and services to meet the project time lines. The County’s Project Manager shall have the right to require the removal and replacement of the Contractor’s Project Manager from providing services to the County under this Contract. The County’s Project manager shall notify the Contractor in writing of such action. The Contractor shall accomplish the removal within five (5) business days after written notice by the County’s Project Manager. The County’s Project Manager shall review and approve the appointment of the replacement for the Contractor’s Project Manager. The County is not required to provide any additional information, reason or rationale in the event it The County is not required to provide any additional information, reason or rationale in the event it requires the removal of Contractor’s Project Manager from providing further services under the Contract.

  • Detailed Description of Services / Statement of Work Describe fully the services that Contractor will provide, or add and attach Exhibit B to this Agreement.

  • Routing for Operator Services and Directory Assistance Traffic For a Verizon Telecommunications Service dial tone line purchased by CBB for resale pursuant to the Resale Attachment, upon request by CBB, Verizon will establish an arrangement that will permit CBB to route the CBB Customer’s calls for operator and directory assistance services to a provider of operator and directory assistance services selected by CBB. Verizon will provide this routing arrangement in accordance with, but only to the extent required by, Applicable Law. Verizon will provide this routing arrangement pursuant to an appropriate written request submitted by CBB and a mutually agreed-upon schedule. This routing arrangement will be implemented at CBB's expense, with charges determined on an individual case basis. In addition to charges for initially establishing the routing arrangement, CBB will be responsible for ongoing monthly and/or usage charges for the routing arrangement. CBB shall arrange, at its own expense, the trunking and other facilities required to transport traffic to CBB’s selected provider of operator and directory assistance services.

  • Attachment A, Scope of Services The scope of services is amended as follows:

  • Out of Scope Services Axon is only responsible to perform the professional services described in the Quote and this Appendix. Any additional professional services are out of scope. The Parties must document scope changes in a written and signed change order. Changes may require an equitable adjustment in the charges or schedule.

  • Supervision of Contractor Personnel The Contractor must supply all necessary and sufficient supervision over the work that is being performed and will be held solely responsible for the conduct and performance of his employees or agents involved in work under the Agreement.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!