Project Study Area Sample Clauses

Project Study Area. The Engineer shall perform an analysis and characterization of habitat and habitat impacts for the study area and documented on the Biological Evaluation Form. The habitat analysis shall be based on the most current State and TPWD MOU and associated Programmatic Agreements.
AutoNDA by SimpleDocs
Project Study Area. The Project “study area” is bounded by the City’s urban growth boundary on the south, Interstate 5 (“I-5”) on the east, land developed to urban densities on the north and Oregon Route 99E on the west (the “Project Study Area.” The Consultant’s transportation analysis for proposed facilities and land uses within the Project Study Area may need to consider impacts on transportation facilities outside the Project Study Area. The Project will plan for integration of development in South Albany with existing and planned urban development adjacent to the Project Study Area.
Project Study Area. Figure 3. Soils in the Project Study Area Figure 4. Vegetation communities in the Project Study Area Figure 5. Wetlands and Other Waters in the Project Study Area Appendices
Project Study Area. The proposed project study area was developed to address the above-stated purpose and need for U-5949. The project study area boundaries are fully depicted on Figures 1 and 2 of the Merger packet dated August 16, 2018. The Project Team members have concurred, on this date of May 20, 2019, on the project purpose and need as stated above and the project study area fully depicted in Figures 1 and 2 of the Merger packet dated August 16, 2018. US Army Corps of Engineers Xxxx Xxxxxx DATE 5/20/2019 US Fish & Wildlife Service Xxxx Xxxxxx DATE 5/20/2019 NC Division of Water Resources Xxxxxx Xxxxxxxxx DATE 5/21/2019 NC Wildlife Resources Commission Xxxxxx Xxxxxx DATE US Environmental Protection Agency 5/21/2019 Xxxxxxxx Xxxxxxxxxx DATE May 20, 2019 5/20/2019 NC Department of Transportation Xxxxxx Xxxxxx DATE 5/21/2019 NC State Historic Preservation Office NC Division of Coastal Management Jacksonville Metropolitan Xxxxx Xxxxxxxx-Xxxxxx DATE 5/23/2019 Xxxxx Xxxxxxxxxxx DATE 5/23/2019
Project Study Area. The project study area extends from the western terminus of I-26 southwest of the City of Asheville around the western side of Asheville to existing US 19-23-70 north of Asheville. The study area, as shown in the FEIS, is shown on Figure 1.

Related to Project Study Area

  • Study Area The study area focused on the Bulk Power System in South-Eastern New York between Albany and New York City, and voltages underlying systems at 115 kV and above in the lower Xxxxxx Valley (Zones G, H & I). In the PSS™E power flow base case provided by NYISO, facilities rated at 115 kV and above in PSS™E designated areas 6 through 11 are monitored in the study. These areas are: • Capital District • Xxxxxx • Millwood • Xxxxxxxxx • Con Ed • Long Island

  • Development Area 10.4. The Development Area shall encompass all Deposits to be produced.

  • Project Area The Project Area is the incorporated area of the City of San Xxxx.

  • Research Project 3.1 These Materials and Data will be used by Recipient's PI solely in connection with the Research Project, as named and described in the attached research application (insert Research Project name below):

  • Project Site The “Project Site” is the place where the Work is being carried on.

  • Project Work PURCHASER shall complete the following projects in accordance with the specifications provided in Exhibits B, C, D, E, and F and written instructions from STATE. Project locations are shown on Exhibit A unless otherwise described. PURCHASER shall furnish all material unless otherwise specified.

  • Project Scope The physical scope of the Project shall be limited to only those capital improvements as described in Appendix A of this Agreement. In the event that circumstances require a change in such physical scope, the change must be approved by the District Committee, recorded in the District Committee's official meeting minutes, and provided to the OPWC Director for the execution of an amendment to this Agreement.

  • Development Plan document specifying the work program, schedule, and relevant investments required for the Development and the Production of a Discovery or set of Discoveries of Oil and Gas in the Contract Area, including its abandonment.

  • Project Plan Development of Project Plan Upon the Authorized User’s request, the Contractor must develop a Project Plan. This Project Plan may include Implementation personnel, installation timeframes, escalation procedures and an acceptance plan as appropriate for the Services requested. Specific requirements of the plan will be defined in the RFQ. In response to the RFQ, the Contractor must agree to furnish all labor and supervision necessary to successfully perform Services procured from this Lot. Project Plan Document The Contractor will provide to the Authorized User, a Project Plan that may contain the following items: • Name of the Project Manager, Contact Phone Numbers and E-Mail Address; • Names of the Project Team Members, Contact Phone Numbers and E-Mail Address; • A list of Implementation milestones based on the Authorized User’s desired installation date; • A list of responsibilities of the Authorized User during system Implementation; • A list of designated Contractor Authorized Personnel; • Escalation procedures including management personnel contact numbers; • Full and complete documentation of all Implementation work; • Samples of knowledge transfer documentation; and • When applicable, a list of all materials and supplies required to complete the Implementation described in the RFQ. Materials and Supplies Required to Complete Implementation In the event that there are items required to complete an Implementation, the Contractor may request the items be added to its Contract if the items meet the scope of the Contract. Negotiation of Final Project Plan If the Authorized User chooses to require a full Project Plan, the State further reserves the right for Authorized Users to negotiate the final Project Plan with the apparent RFQ awardee. Such negotiation must not substantively change the scope of the RFQ plan, but can alter timeframes or other incidental factors of the final Project Plan. The Authorized User will provide the Contractor a minimum of five (5) business days’ notice of the final negotiation date. The Authorized User reserves the right to move to the next responsible and responsive bidder if Contractor negotiations are unsuccessful.

  • PROJECT 3.01. The Recipient declares its commitment to the objectives of the Project. To this end, the Recipient shall carry out the Project in accordance with the provisions of Article IV of the General Conditions.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!