Quality Standard for Fresh Water Sample Clauses

Quality Standard for Fresh Water. (a) The following quality standards shall apply to the Fresh Water and Recycled Water as provided herein: pH 6.5 to 7.5 6.5 to 7.5 6 to 8.5 6 to 8 Iron (Fe) 25 mg/L 25 mg/L 300 mg/L 25 mg/L Chloride (Cl) 23,125 mg/L 23,125 mg/L 7000 mg/L ~ Sulfate (SO4) 800 mg/L 800 mg/L 2,000 mg/L 500 mg/L Calcium (Ca) 500 mg/L 2000 mg/L Magnesium (Mg) 300 mg/L 2000 mg/l Carbonate (CO3) 100 mg/L 300 mg/L Bicarbonate (HCO3) 1000 mg/L 300 mg/L Tannin/ Lignin 25 mg/L ~ Total Hardness 500 mg/L as CaCO3 500 mg/L as CaCO3 Total Alkalinity 500 mg/L as CaCO3 500 mg/L as CaCO3 Sodium 18,750 mg/L 18,750 mg/L Silica 10 mg/L 10 mg/L Aluminum 4 mg/L 4 mg/L Oil and Grease 5 mg/L 5 mg/L Particulate Size 50 nominal micron 50 nominal micron (b) Fresh Water at each Retention Facility, Receipt Point and Delivery Point shall be free from any contamination or any substances that would result in such Fresh Water being unsuitable for any Purpose or violating any law, rule or regulation (including but not limited to environmental laws). Raw Fresh Water at each Retention Facility, Receipt Point and Delivery Point shall conform to Quality Standard for Fresh Water. Recycled Water at each Retention Facility, Receipt Point and Delivery Point shall conform to Quality Standard for Recycled Water. (c) Producer shall not deliver Raw Fresh Water and Recycled Water into the same Retention Facility, unless agreed to by Midstream Co prior to such delivery. With respect to the Raw Fresh Water delivered into the Individual System, Producer has the obligation to obtain and deliver Raw Fresh Water that conforms to the Quality Standard for Fresh Water. With respect to the Recycled Water delivered into the Individual System, Producer has the obligation to obtain and deliver Recycled Water that conforms to the Quality Standard for Recycled Water. (d) Except to the extent specified in Section 7.2, Midstream Co shall use reasonable efforts to ensure that Fresh Water that is held in the Retention Facilities or conveyed through the Individual System is not subject to any contamination or pollution that would result in the Fresh Water held in the Individual System not meeting Quality Standard for Fresh Water or Quality Standard for Recycled Water, as applicable. (e) Either Party may, at its option and sole expense, obtain water samples available at any Retention Facility, Receipt Point or Delivery Point for water quality analyses and retain appropriate qualified personnel to conduct analyses in accordance with all then-...
Sample 1Sample 2
AutoNDA by SimpleDocs

Related to Quality Standard for Fresh Water

  • Quality Standards Each Party agrees that the nature and quality of its products and services supplied in connection with the other Party's Marks will conform to quality standards set by the other Party. Each Party agrees to supply the other Party, upon request, with a reasonable number of samples of any Materials publicly disseminated by such Party which utilize the other Party's Marks. Each Party will comply with all applicable laws, regulations, and customs and obtain any required government approvals pertaining to use of the other Party's marks.

  • Quality Management System Supplier hereby undertakes, warrants and confirms, and will ensue same for its subcontractors, to remain certified in accordance with ISO 9001 standard or equivalent. At any time during the term of this Agreement, the Supplier shall, if so instructed by ISR, provide evidence of such certifications. In any event, Supplier must notify ISR, in writing, in the event said certification is suspended and/or canceled and/or not continued.

  • CONTRACT WORK HOURS AND SAFETY STANDARDS As per the Contract Work Hours and Safety Standards Act (40 U.S.C. 3701-3708), where applicable, all Customer Purchase Orders in excess of ,000 that involve the employment of mechanics or laborers must include a provision for compliance with 40 U.S.C. 3702 and 3704, as supplemented by Department of Labor regulations (29 CFR Part 5). Under 40 U.S.C. 3702 of the Act, each contractor must be required to compute the wages of every mechanic and laborer on the basis of a standard work week of 40 hours. Work in excess of the standard work week is permissible provided that the worker is compensated at a rate of not less than one and a half times the basic rate of pay for all hours worked in excess of 40 hours in the work week. The requirements of 40 U.S.C. 3704 are applicable to construction work and provide that no laborer or mechanic must be required to work in surroundings or under working conditions which are unsanitary, hazardous or dangerous. These requirements do not apply to the purchases of supplies or materials or articles ordinarily available on the open market, or contracts for transportation or transmission of intelligence.

  • Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.

  • Quality Service Standards Price Services and the Fund may from time to time agree to certain quality service standards, as well as incentives and penalties with respect to Price Services’ Services hereunder.

  • Quality Specifications SANMINA-SCI shall comply with the quality specifications set forth in its Quality Manual, incorporated by reference herein, a copy of which is available from SANMINA-SCI upon request.

  • Quality Assurance Program An employee shall be entitled to leave of absence without loss of earnings from her or his regularly scheduled working hours for the purpose of writing examinations required by the College of Nurses of Ontario arising out of the Quality Assurance Program.

  • Contract Work Hours and Safety Standards Act The following clauses apply to any Federal-aid construction contract in an amount in excess of $100,000 and subject to the overtime provisions of the Contract Work Hours and Safety Standards Act. These clauses shall be inserted in addition to the clauses required by 29 CFR 5.5(a) or 29 CFR 4.6. As used in this paragraph, the terms laborers and mechanics include watchmen and guards.

  • Quality- and Cost-Based Selection Except as ADB may otherwise agree, the Borrower shall apply quality- and cost-based selection for selecting and engaging consulting services.

  • Benchmarks for Measuring Accessibility For the purposes of this Agreement, the accessibility of online content and functionality will be measured according to the W3C’s Web Content Accessibility Guidelines (WCAG) 2.0 Level AA and the Web Accessibility Initiative Accessible Rich Internet Applications Suite (WAI-ARIA) 1.0 for web content, which are incorporated by reference.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!