Research Project 3.1 These Materials and Data will be used by Recipient's PI solely in connection with the Research Project, as named and described in the attached research application (insert Research Project name below):
For Product Development Projects and Project Demonstrations Published documents, including date, title, and periodical name. Estimated or actual energy and cost savings, and estimated statewide energy savings once market potential has been realized. Identify all assumptions used in the estimates. Greenhouse gas and criteria emissions reductions. Other non-energy benefits such as reliability, public safety, lower operational cost, environmental improvement, indoor environmental quality, and societal benefits. Data on potential job creation, market potential, economic development, and increased state revenue as a result of the project. A discussion of project product downloads from websites, and publications in technical journals. A comparison of project expectations and performance. Discuss whether the goals and objectives of the Agreement have been met and what improvements are needed, if any.
Sub-projects 1. The Participating Bank shall make Sub-loans to Beneficiaries and appraise, review, approve, and supervise Sub-projects in accordance with the criteria, conditions and procedures set forth in the Operations Manual, including, inter alia, the following eligibility criteria:
Projects The Annexes attached hereto describe the specific projects and the policy reforms and other activities related thereto (each, a “Project”) that the Government will carry out, or cause to be carried out, in furtherance of this Compact to achieve the Objectives and the Compact Goal.
Development of the Project 4.1 TSP's obligations in development of the Project: Subject to the terms and conditions of this Agreement, the TSP at its own cost and expense shall observe, comply with, perform, undertake and be responsible:
PROJECT 3.01. The Recipient declares its commitment to the objectives of the Project. To this end, the Recipient shall carry out the Project in accordance with the provisions of Article IV of the General Conditions.
Construction Development of the Project The Allottee has seen the proposed layout plan/demarcation-cum-zoning/sanctioned plans, / site plan / building plan, specifications, amenities and facilities, etc. depicted in the advertisement / brochure / agreement / website (as the case may be) regarding the Project where the Said Independent Floor for residential usage along with parking is located and has accepted the floor / site plan, Payment Plan and the specifications, amenities, facilities, etc. [annexed along with this Agreement] which has been approved by the competent authority, as represented by the Promoter. The Promoter shall develop the Project in accordance with the bye-laws such as Haryana Building Code, 2017, FAR, density norms, provisions prescribed, approved plans, terms and condition of the license/ allotment as well as registration of RERA, etc. Subject to the terms in this Agreement, the Promoter undertakes to strictly abide by such plans approved by the competent authorities and shall also strictly abide by the provisions and norms prescribed by the relevant State laws and shall not have an option to make any variation/ alteration/ modification in such plans, other than in the manner provided under the Act and Rules made thereunder or as per approvals/instructions/ guidelines of the competent authorities, and any breach of this term by the Promoter shall constitute a material breach of the Agreement.
Project Initiation i - Upon final execution of the Agreement with the DISTRICT, the ARCHITECT shall: ♦ Review the Program Management Plan (PMP) with the DISTRICT and its representatives to familiarize them with the proposed tasks and schedule and develop necessary modifications. The PMP defines the Program Master Schedule and Budgets and each Project scope and budget.
In-Scope Projects Project Based Information Technology (IT) Consulting Services required by an Authorized User must be obtained via a Mini-Bid process under this Contract. The Authorized User shall issue a Mini-Bid with a SOW for the required Project Based IT Consulting Services. A Mini-Bid may include, but will not be limited to, projects requiring: analysis, data classification, design, development, testing, quality assurance, security and associated customized training for IT based applications. Additional examples of in-scope projects include, but are not limited to: Technical architecture advisory services; Business analysis for project development; Proprietary software application development/customization, programming and integration; Data information management (including data migration, data conversion, data manipulation, data integration); Project management project support services - including, but not limited to; project management, project quality assurance and control, and Independent Verification & Validation (IV&V); Disaster recovery/business continuity and testing; Quality assurance; Continuity of operations planning (COOP); Data categorization; and Open-source software implementation. Out-of-Scope Work There are service offerings expressly excluded from the scope of these contracts. In many instances, such services and/or offerings are (or will be) covered by another OGS Centralized Contract. Examples include: Staff augmentation services; Time and material services; Web hosting; Automated network monitoring or any other service provided principally through an automated process; Hardware maintenance and support; Software maintenance and support; Ongoing maintenance and support; Services priced on a per asset basis; Services priced on a contingency basis; Equipment maintenance; Prepackaged training courses; E-Learning; Managed services; Acquisition of equipment (hardware) Acquisition of software, either Commercial off-the-shelf (COTS) software or pre-existing software; Acquisition of non-consulting services, such as network provisioning, voice services (local, long- distance), or video bridging; Cloud based or “As a Service” offerings, including but not limited to SaaS, IaaS, PaaS, and XaaS; Any offering that is a combination of equipment, hardware, software, cloud or “as a service offerings”; and Consulting or other installation work which is considered Public Works is excluded from purchase under the scope of this Contract. Historically, the New York State Bureau of Public Works has maintained that installation, maintenance and repair of equipment attached to any wall, ceiling or floor or affixed by hard wiring or plumbing is public work. In contrast, installation of a piece of equipment which is portable or a “plug-in” free-standing unit would not be considered public work. Thus, this Contract does not authorize installation where the equipment becomes a permanent part of the building structure, or is otherwise incorporated into the fabric of the building (i.e. installation on a wall, ceiling or floor in a fixed location, or affixed by hard- wiring or plumbing). See Appendix A, Clause 6, Wage and Hours Provisions. For questions about whether a proposed work constitutes public work, please contact the New York State Department of Labor’s Bureau of Public Work District Office in a specific area. A listing of district offices and contact information is available at xxxx://xxx.xxxxx.xx.xxx/workerprotection/publicwork/PWContactUs.shtm. Definitions Additional definitions applicable to this Contract can be found in Appendix B. Term Definition Authorized User Agreement The document resulting from the transactional Mini-Bid process, which sets forth the specifics regarding the services to be provided by the Contractor to the Authorized User, under the Project Based Information Technology Consulting Contract. Best Value The basis for awarding all service and technology contracts to the offerer that optimizes quality, cost and efficiency, among responsive and responsible offerers. Such basis shall be, wherever possible, quantifiable (State Finance Law §163 (1) (j)). Billing Contact The name, phone number, e-mail, and billing address a customer uses on a xxxx for contact information. Consultant Disclosure Legislation Chapter 10 of the Laws of 2006 amends State Finance Law § 8 and § 163 by requiring: that the Office of the State Comptroller (OSC) include in the Consulting Services Report it compiles annually on contracts issued by state agencies for consulting services during the previous fiscal year. xxxx://xxx.xxx.xxxxx.xx.xx/agencies/guide/MyWebHelp/Content/XI/18/C.htm Deliverables All services or products created during the performance or provision of Services hereunder or identified as a “Deliverable” in an applicable Mini-Bid. A Deliverable is a building block of an overall project. For the purposes of this Solicitation and the resulting Contract, a deliverable shall not be set forth as a status report, meeting attendance, a block of staff hours, or an invoice submission. Fixed Price Authorized User Agreement An agreement pursuant to the Centralized Contract that provides for a fix cost for a defined project. Government Contract A contract let by a Federal, State, or Local governmental body within the continental United States. Government Entity An entity at the federal, state, county, city or provincial level. Joint Venture A contractual agreement joining together two or more business enterprises for the purpose of performing on a State Contract. Knowledge Transfer The transfer of knowledge from the Contractor to the Authorized User. Knowledge Transfer can include full written system documentation including all system changes, training classes, manuals and other items. Depending on the scope of the transaction, there may or may not be a deliverable cost associated. All materials will be the property of the Authorized User unless specifically negotiated during the award process. May Denotes the permissive in a contract clause or specification. Refers to items or information that the State has deemed are worthy of obtaining, but not required or obligatory. Also see “Should”. Mini-Bid A type of Bid Document used by the Authorized User to obtain Services under the Project Based IT Consulting Services Contracts. Not To Exceed Rates (NTE) Refers to the New York State contract price set forth in Appendix D. Amounts proposed by the Contractor at the transactional level shall not exceed the hourly rates provided under this Contract (which will be defined values in US Dollars). Prime Contractor For the purposes of Technical qualifications, the business entity with whom a government entity directly has a contract. Project Based IT Consulting Services An OGS Centralized Contract which will provide a set of standardized terms and conditions, guidelines, processes, and templates for the development, distribution and award of specific deliverable-based and fixed-price Information Technology projects. Project Plan A formal, approved document used to guide both project execution and project control. The primary uses of the project plan are to document planning assumptions and decisions, facilitate communication among stakeholders, and document approved scope, cost, and schedule baselines. Retainage A portion of the Authorized User and Contractor fixed-price agreement amount that is held back by the Authorized User until the deliverable or project is satisfactorily finished. Should Denotes the permissive in a contract clause or specification. Refers to items or information that the State has deemed are worthy of obtaining, but not required or obligatory. Also see “May”. Term Definition Solicitation A non-competitive periodic recruitment solicitation (“Solicitation”) for vendors that provide Project Based Information Technology Consulting Services. Vendor An enterprise that sells goods or services. Vendor Submission The complete response to this Solicitation submitted by a Vendor to provide, as applicable , the Product and services described in the Solicitation
Feasibility Study Buyer will, at Buyer's expense and within ____ days from Effective Date ("Feasibility Study Period"), determine whether the Property is suitable, in Buyer's sole and absolute discretion, for ___________________ use. During the Feasibility Study Period, Buyer may conduct a Phase I environmental assessment and any other tests, analyses, surveys and investigations ("Inspections") that Buyer deems necessary to determine to Buyer's satisfaction the Property's engineering, architectural and environmental properties; zoning and zoning restrictions; subdivision statutes; soil and grade; availability of access public roads, water, and other utilities; consistency with local, state and regional growth management plans, availability of permits, government approvals, and licenses; and other inspections that Buyer deems appropriate to determine the Property's suitability for the Buyer's intended use. If the Property must be rezoned, Buyer will obtain the rezoning from the appropriatx xxxernment agencies. Seller will sign all documents Buyer is required to file in connection with development or rezoning approvals. Seller gives Buyer, its agents, contractors and assigns, the right to enter the Property at any time during the Feasibility Study Period for the purpose of conducting inspections; provided, however, that Buyer, its agents, contractors and assigns enter the Property and conduct inspections at their own risk. Buyer will indemnify and hold Seller harmless from xxxxes, damages, costs, claims and expenses of any nature, including attorney's fees, expenses and liability incurred in application for rezoning or related proceedings, and from liability to any person, arising from the conduct of any and all inspections of any work authorized by Buyer. Buyer will not engage in any activity that xxxxx result in a construction lien being filed against the Property without Seller's prior written consent. If this transaction does not close, Buyer will, at Buyer's expense, (1) repair all damages to the Property resulting from the Inspections and return the Property to the condition it was in prior to conduct of the Inspections, and (2) release to Seller all reports and other work generated as a result of the Inspections. Buyer will deliver written notice to Seller prior to the expiration of the Feasibility Study Period of Buyer's determination of whether or not the Properxx xx acceptable. Buyer's failure to comply with this notice requirement will constitute acceptance of the Property as suitable for Buyer's intended use in its "as is" condition. If the Property is unacceptable to Buyer and written notice of this fact is timely delivered to Seller, this Contract will be deemed terminated as of the day after the Feasibility Study period ends and Buyer's deposit(s) will be returned after Escrow Axxxx receives proper authorization form all interested parties.
